1. Calculate I, in the circuit using Thevenin's theorem. 4 A 2002 50 50 w 1002 12 A A 40 V

Q: 4. Find the transient charge in an RLC series circuit when: L = 1H C = 0.25F R = 2Ω E(t) = 50 cos tV…

A: Note: Resistance doesn't depend on source frequency  Reactance of capacitor or inductor depends on…

Q: what is the realistic channel capacity of a communication channel of 25KHZ that has 20db signal to…

A: Given data,Signal-to-noise ratio (dB) SNR(dB)=20 dB Bandwidth BW=25×103 Hz

Q: 9-A binary data source has P(OT) = 3/8, due to interference of channel, then P(OR/1T) = 1/16 and…

A: According to the question,

Q: VI R1 680 60 v<20° XL1 3300 XC1 150 XL2 750 R3 180 12 R2 1200 XC2 HH 220 O + V2 75 V <10°

A:

Q: Where does capacitive touch come from, and how does it function?

A: Capacitive touch screen computers are currently most frequently seen in smartphones and tablet PCs.…

Q: Calculate the TF of the following circuit: Vin(s) R 1/(SC) Vout(s)

A: In this question We need to determine the transfer function of the following circuit.  We know…

Q: A 4x1 MUX is used to implement a 3-input Boolean function as shown in figure. The Boolean function…

A: Given: A 4×1 MUX is used to implement a 3-input Boolean function.

Q: Example 2 Rop. and determine the feedback topology- For the circuit shown, find Ave, Rif, and

A:

Q: An op-amp comparator in a firing circuit can produce waveforms at the output of up to 28 V…

A: Given: Peak to peak voltage, Vp-p=28V, Therefore the maximum voltage will be, Vm=14V, Firing angle,…

Q: Determine the values of Av, Ai, Zin and Zout

A: The required parameters can be obtained by using the DC analysis and AC analysis of the amplifier…

Q: 1/0 SO s3 1/0 0/1 0/1 1/1 1/1 s1 s2 0/1 0/1

A:

Q: An energy source forces a constant current of 2A for 10s to flow through a light bulb. If 2.3 kJ is…

A: Given- Constant current I=2 A, Time t=10 s, Energy E=2.3 kJ, To Find- The voltage drop V across the…

Q: [7] AC potential e = Esinot was applied to a capacitor (capacitance: C), and the output AC current…

A: It is given that: e=EsinωtE˙=-Ee-jπ2=-E-j=jE

Q: A4 Pole, 3 Phase, 415 V, induction motor having an efficiency of 715 stator iron loss is 2.1kW and…

A: Given data, Number of poles P = 4. Frequency f = 50 Hz. Rotor resistance r2=0.03 Ω/phase. Standstill…

Q: What is the minimized expression of f=xZ+yz+yz + xyz A Z+XY B с z + xy Z+XY D Z+xy

A: Given- Boolean expression, F=x.z+y.z+y.z+x.y.z   To find- Minimized expression.

Q: Problem 10.055.a - Thevenin equivalent of a phasor circuit Find the Thevenin and Norton equivalent…

A: We need to find out the thevenin equivalent and norton equivalent circuit for given circuit.

Q: • If 20V battery in the left side and 10V battery to the right side (both case the positive voltage…

A: Given data Two voltage sources of 20 V and 10 V are applied to the circuit such that 20 V source is…

Q: 12 V Μ 3Ω *Μ 6Ω 3Ω b 50 Μ 10Ω ΤΩ ¡LOAD NLOADS RLOAD |8Ω

A:

Q: 4V S(t=0) 20 20 1F + -

A:

Q: 1. 10 I2 13 102 H

A:

Q: The circuit shown in the figure below is a O Low pass filter O High pass filter O Band pass filter O…

A: Given circuit:

Q: A 480 V, 50 Hz, Y-connected, six-pole synchronous generator has the OCC shown in Figure below. This…

A: Since, the question posted by you has multiple sub-parts, we will solve the first three sub-parts…

Q: A 60 Hz sinusoidal voltage with an RMS value of 240 V is applied to a single-phase full-wave SCR…

A: The rms output voltage of a full wave scr rectifier is given it is asked to find the firing angle in…

Q: Simplify the following expression into sum of products using Karnaugh map F(A,B,C,D) =…

A:

Q: A unity feedback system has the open loop transfer function shown below. Find the angle of arrival…

A:

Q: 4+2) (+1) 49 Ut 1₂ www 352 ww 202 127

A: The question is about finding mess currents.

Q: (b) In simulating a noise signal, random number will be used. Consider the random number as a noise…

A:

Q: a) impulse current generator , generation of switching surges , generation of high frequency high…

A: We have tobriefly explain impulse current generator, generation of switching surges, generation of…

Q: What are the branch currents, 12 and 13? R₁ 4 kOhm V₁ 35 V R2 7.5 kOhm R312.5 kOhm

A: Given data, Circuit diagram is given as,

Q: Solve the following using Kirchhoff’s Laws Find V1, V2, and V3 in the following circuit

A: Given: To find: V1, V2 and V3 using Kirchhoff's law.

Q: Ejercicio 3: Utilizando las Leyes de Kirchhoff, encuentre las corrientes: 1₁; 1₂ e 13. Respuesta: 1₁…

A:

Q: 4. Determine equivalent impedance = R₁ 2000 C = 10μF R₂ = 4000 L = 1H Assume: w = 120π R₁ www Ť C…

A: given circuit. we have to calculate Zeq

Q: 4. A 3-phase full-wave bridge rectifier is built using six power diodes numbered 1 to 6. The phase…

A:

Q: A 400 V, 3 phase, 50 Hz, Induction motor gives out an mechanical output of 13.586 HP (Metric). It…

A:

Q: Calculate the ground reflection amplitude factor for communication at 5 GHz between a transmitter…

A: Given data, Height of the transmitter ht=20 m Height of the receiver hr=5 m Distance between the two…

Q: What must be the value of E to ensure that the Current (I₁= 5mA) as shown. Calculate the power…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Problem 5 - Norton Equivalent Circuit a) b) Find the Norton Equivalent Resistance between terminals…

A: The norton's equivalent circuit can be obtained by using equivalent resistance and short circuit…

Q: ← OpAmp Linear Circuits Q.7 An op-amp has a slew rate of 10 V/μs. The largest since wave output…

A:

Q: 3. Use NORTON'S THEOREM to find the Norton's Short Circuit Current, Looking Back Resistance, and the…

A:

Q: 12 V 3Ω 6Ω b 3 Ω 5Ω Μ W ΖΩ 10Ω ¡LOAD VLOAD ≥ RLOAD 8Ω 8 Ω

A:

Q: 1. (a) Derive the transfer function of the following circuit. (b) Plot the Bode plot of magnitude.…

A:

Q: 7. Determine the value of the currents, the voltage across all resistors, and the power dissipated…

A: Note: According to kirchoff's current law, the incoming current at any node should be equal to…

Q: Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc = 2316 ohms. Round your…

A: The question is about finding capacitance value.

Q: Describe the Transient stability analysis for Two machine System

A: Transient stability involves the response of small disturbances that occurred on the system.,…

Q: A conducting bar can slide freely over two conducting rails as shown in the figure below. Calculate…

A: We need to find out the induced voltage for given circuit .

Q: The circuit shown is at steady state before the switch opens. Find the expressions of voltage v(t)…

A:

Q: .A 110-V dc motor draws a current of 30A and is located 500 ft from the power source. What is the…

A: Given data, Back EMF of motor Eb=110 V. Armature current Ia=20 A. Length l=500 ft = 15240 cm.…

Q: Ferramenta de Graph the amplitude and phase spectra of the functions A(z) = 1 − z¯¹ and B (z) =…

A: Given: A(z)=1-z-1,B(z)=z-z-12, To find: Graph the amplitude and phase spectra of the functions.

Q: Electrical Circuits The switch in the circuit in Figure 3 changes position from position b to…

A: In this question We need to determine the voltage across the capacitor, current in the capacitor and…

Q: Mention in which type of application it is recommended to use an active filter analog, and in which…

A: Analog filters are divided in two parts. 1. active filter 2. passive filter   Active filter : This…

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.