2. A student carries out the reaction sequence below. Unfortunately, the first 2 reactions are incomplete, and a mixture of A, B, and Cis obtained after the second step. She plans on using column chromatography to separate the 3 compounds. What is the expected order of elution of the 3 compounds using 10:1 hexane-diethyl ether as the mobile phase and silica gel as the stationary phase? The first compound to elute is listed first. Give the basis of your answer. Br Mg но HSO, H) H,O" H, Pd-C

2. A student carries out the reaction sequence below. Unfortunately, the first 2 reactions are incomplete, and a mixture of A, B, and Cis obtained after the second step. She plans on using column chromatography to separate the 3 compounds. What is the expected order of elution of the 3 compounds using 10:1 hexane-diethyl ether as the mobile phase and silica gel as the stationary phase? The first compound to elute is listed first. Give the basis of your answer. Br Mg но HSO, H) H,O" H, Pd-C

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

State whether the following reactions will show a normal or inverse, primary or secondary, kinetic isotope effect. Explain your reasoning. H(D) N3 А. H(D) H(D) `H(D) H(D) H(D) O= C=O B. C.
In this experiment we investigate the effect of isotopes on chemical kinetics. There are three hydrogen isotopes (protium = just one proton / deuterium = one proton + one neutron / tritium = one proton + two neutrons). Deuterium (D) is stable; tritium (T) is radioactive. We will monitor the decay (by hydrolysis) of acetic anhydride in water using UV absorption spectroscopy. I had a hard time saving the data and transferring it off the lab computers just like you earlier in the semester. The experiment involves two runs: (1) in normal [light] water which is H2O; and (2) in heavy water which is D2O. From the absorbance data we can determine the effective rate constant and reaction order for the reaction in the different types of water. We are especially interested in the differences: will the reaction be faster or slower in heavy water? Will the difference be significant or very slight?
State whether the following reactions will show a normal or inverse, primary or secondary, kinetic isotope effect. Explain your reasoning. H(D) N3 А. H(D) H(D) `H(D) В. H(D) H(D) -ズ、 O=C=O С.
(d) A 5.6 dm sample of ethene, CH2=CH2 measured at s.tp. was reacted with 0.05 mol dm acidified potassium manganate(VII). Ethylene glycol, CH2(OH)CH(OH), is formed as the only carbon containing product. The half-equation for reduction of manganate(VII) ion is shown below. Mnos + 8H* + 5e - Mn?* + 4H2O (i) Construct a half-equation for the oxidation of ethene and hence write an overall equation for the reaction between ethene and manganate(VII) ions. ...[2] (ii) Calculate the minimum volume of potassium manganate(VI) required for a complete reaction with the ethene sample. [2]
k₁ Ex. 7. A measurement of the proportion of HI decomposed in the reaction 2HI H₂ + 1₂ at k_₁ different moment of heating give the following results: Time/min ані.102 20 10 4.50 9.06 30 40 50 13.03 15.68 17.30 ∞ 21.43 Initial concentration of HI equals to 0.0446 mol dm³. Calculate the equilibrium constant of the reaction and the rate constant of the forward and the reverse reactions
Q1: Experiment 1: The Acid – Catalyzed Iodination of Acetone To carry out the kinetic study of iodination of acetone, the following reaction mixture was prepared: 5.00 mL of 1.00M HCl + 2.00 mL Acetone + 15.0 mL of 0.05 M I2 solution + enough water to get the total volume of 100 mL. The mixture was transferred to conical flask. At various time intervals, 20.0 mL portions of the solution were removed and titrated against 0.02 M S2O32-, The following volume of the S2O32- was needed for the titration. t(min) mL of thiosulphate solution 5 7.00 10 5.5 15 4.0 Find the concentration of I2 in the conical flask at each of these times. Find the specific acid catalytic constant KH+.
Which of the following would result in an increase in the calculated ngas 10, assuming the rest of the parameters are held constant? I. Inserting 23.0 mg instead of the prescribed 15.0mg of folded Mg ribbon into the eudiometer. II. Performing the experiment in a different laboratory with a cooler temperature. III. A shorter equilibration time prior to volume measurement. IV. Acid used was 12.0 M HNO3 instead of 6.0 M HCI.
Which of the following would result in an increase in the calculated ngas in the Chem 16.1 Experiment 10, assuming the rest of the parameters are held constant? I. Inserting 23.0 mg instead of the prescribed 15.0mg of folded Mg ribbon into the eudiometer. II. Performing the experiment in a different laboratory with a cooler temperature. III. A shorter equilibration time prior to volume measurement. IV. Acid used was 12.0 M HNO3 instead of 6.0 M HCl. a. II and III b. I only c. I and II d. II, III, and IV
Analyte may be lost at the ashing stage volatile hydride generated by the reaction that occurs is swept into the atomization chamber by an inert gas, where it undergoes decomposition. detection limits by a factor of 10 to 100 compared to alternative methods v limited to only the determination of mercury.
What are the dissociation reaction, including phases, of AICI3?
R(s) = As/(K+s)for positive constants A and K. (b) Show that the reaction rate attains one-half of the limiting value when the substrate concentrationis K millimolars.
Briefly explain the techniques of catalyst characterization: c) FT-IR of solids with pyridine adsorbed) XRD in the analysis of a catalyst