2. Design a two-stage amplifier that produces the following output:V₁ = 3√₁ + 2V2 + 4V3a. Draw the block diagram for this systemb. Implement the block diagram for this circuit using op-amps. Ensure that allresistors drawn have values.c. If V₁=1 V, V2=2 V, V3 = 2 V, what should be the minimum Vcc of bothamplifiers so that neither stage is saturated?

Answered: 2. Design a two-stage amplifier that…

Electrical Transformers and Rotating Machines

4th Edition

ISBN:9781305494817

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter3: Inductance In Alternating-current Circuits

Section: Chapter Questions

Problem 6RQ

See similar textbooks

Similar questions

Question 5 The impedance matrix [Z (iw)], can be used to determine the solution as: X = [Z(iw)]-¹Fo b. X = [Z(iw)]Fo c. X= [Z(iw)] Xo Question 6 The mass matrices stiffness and damping of a system with two degrees of freedom are symmetrical. Choose an option: True False
QUESTION 3 BAND PASS FILTER Find the transfer function, Vo(s)/Vi(s), for the op-amp system shown in the figure. C R R C Vo Vi V₁(s) V₁(s) ○ V (s) 0 V₁(s) ○ V (s) A V₁(s) WH RCs RCS +1 1 (RCs+1) 2 RCS+1 RCs V₁(s) RCs V₁(s) (RCs+1)²
2. Figure 1 shows a sensor consists of a core, an armature and a variable air gap. The core with 3.0 cm depth and 10000 relative permeability has 200 coil turns. On the other hand, the armature is a steel plate of thickness 0.2 cm and has similar relative permeability with the core. Assuming the relative permeability of air is unity and the permeability of free space is equal to 4x x 10-7 H.m, calculate the inductance of the sensor for air gaps of 0 mm and 2 mm. Please write the answers in 3 decimal places. 2.0 cm 1.0 cm 6.0 cm 3.0 cm 1.5 cm Figure I
8. An R-L series circuit has a reactive power of 1234 VARs and an apparent power of 4329 VA. By how many degrees are voltage and current out of phase with each other? 9. An R-L series circuit contains a resistor and an inductor. The resistor has a value of 6.5 22. The circuit is connected to 120 V and has a current flow of 12 A. What is the inductive reactance of this circuit? 10. What is the voltage drop across the resistor in the circuit in Question 9? 11. A phase angle meter connected in an R-L series circuit indicates that the current is 28 degrees out of phase with the voltage. What is the circuit power factor? 12. An R-L series circuit has a power factor of 73%. If the apparent power is 560 kVA, what is the true power in the circuit?
Design an analog Butterworth filter with the following properties. Find the transfer function? Ap=2dB (Passband attenuation Wp-20rad/sec pass bondi frequency As 10 dB (Stop band attenuation WS-30 rad/sec stop body frequency
Q1: Design a highpass filter with a high-frequency gain of 5 and a corner frequency of 2 kHz. Use a 0.1-μF capacitor in your design.
T4. Sketch the schematic diagram of the Antenna Azimuth control system (position servo motor) as shown in fig. T4, then find the block diagram of the control system. Potentiometer 0;(1) Desired azimuth angle input power amplifier Motor 00(1) Azimuth angle output Fig. T4 Antennal Potentiometer
2- for a DSB-SC modulator with calculations, assuming perfect carrier pression: usdal Modula ng Signal cerario: Carrier freque Modulating c) = 1 t), whe m = 1 kHz (20 marks)
Find the moment about A & B where AB = 8m, BC = CD 6m & all forces makes 40° to horizontal axis. 7kN 8 kN 10KN 15kl 6kN 5kN B. 3kN 4kN
3. Figure 3 shows a nonlinear circuit consisting of a diode and a capacitor in parallel combination. Furthermore, the circuit is driven by a constant current source Is. The voltage v(t) satisfies the nonlinear equation odv dt + Iev/(nVT) = Is (9) where I, n and Vr are the saturation current, emission coefficient, and thermal voltage of the diode, respectively. Moreover, they are all constants. Also in (9), C is the capacitance and Is > I. Answer the following questions. (a) When the system is in equilibrium, v(t) = vo = constant. Find the constant vo. (b) Linearize (9) around v = vo to obtain a linearized equation of motion.
When a system is expanding and doing work, part of the work done is used to overcome the atmospheric pressure, and thus Wsurr represents a loss. When a system is compressed, however, the atmospheric pressure helps the compression process, and thus Wsurr represents a gain.
Question: In inverted amplifier if the input signal is 500mV and the desired output is 4V. If the feedback resistance is 1KQ what is the value of input resistance in KQ unit: 125 8.000 0.125 -0.125 -125

SEE MORE QUESTIONS

Recommended textbooks for you

Electrical Transformers and Rotating Machines

Mechanical Engineering

ISBN:

9781305494817

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Understanding Motor Controls

Mechanical Engineering

ISBN:

9781337798686

Author:

Stephen L. Herman

Publisher:

Delmar Cengage Learning

Electrical Transformers and Rotating Machines

Mechanical Engineering

ISBN:

9781305494817

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Understanding Motor Controls

Mechanical Engineering

ISBN:

9781337798686

Author:

Stephen L. Herman

Publisher:

Delmar Cengage Learning

SEE MORE TEXTBOOKS