2. Fill in the following table to show the theoretical results for the titration of 1.0 L of 0.20 M acetic acid by adding the designated amount of solid (no volume change) potassium hydroxide, KOH. Show sample calculation of your work. Amount of NaOH added 0.0 mol 0.010 mol 0.020 mol 0.030 mol 0.040 mol Amount of acetic acid remaining pH [H+]

2. Fill in the following table to show the theoretical results for the titration of 1.0 L of 0.20 M acetic acid by adding the designated amount of solid (no volume change) potassium hydroxide, KOH. Show sample calculation of your work. Amount of NaOH added 0.0 mol 0.010 mol 0.020 mol 0.030 mol 0.040 mol Amount of acetic acid remaining pH [H+]

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter14: Acid- Base Equilibria

Section: Chapter Questions

Problem 110CP: A 0.400-M solution of ammonia was titrated with hydrochloric acid to the equivalence point, where...

See similar textbooks

Similar questions

For the titration of 50.0 mL of 0.100-M HCl with 0.100-M NaOH, calculate the pH when these volumes of NaOH have been added: (a) 10.0 mL (b) 25.00 mL (c) 45.0 mL (d) 50.5 mL
A 0.400-M solution of ammonia was titrated with hydrochloric acid to the equivalence point, where the total volume was 1.50 times the original volume. At what pH does the equivalence point occur?
The titration curves for two acids with the same base are shown on this graph. (a) Which is the curve for the weaker acid? Explain your choice. (b) Give the approximate pH at the equivalence point for the titration of each acid. (c) Explain why the pH at the equivalence point differs for each acid. (d) Explain why the starting pH values of the two acids differ. (e) Which indicator or indicators, phenolphthalein, bromthymol blue, or methyl red, could be used for the titration of Acid 1? For the titration of Acid 2? Explain your choices.
Fifty cm3 of 1.000 M nitrous acid is titrated with 0.850 M NaOH. What is the pH of the solution (a) before any NaOH is added? (b) at half-neutralization? (c) at the equivalence point? (d) when 0.10 mL less than the volume of NaOH to reach the equivalence point is added? (e) when 0.10 mL more than the volume of NaOH to reach the equivalence point is added? (f) Use your data to construct a plot similar to that shown in Figure 14.10 (pH versus volume NaOH added).