2420°v I1 a b -j2 I2 j22 I3 214 ell 12230° A I4 -j42. 22 d

Q: VPeablemse- Find Hhe transhr funchion for CO/25) Por the fallowingg Contral systems by using block…

A:

Q: Space wave propagation occurs in radio wave communication within a frequency range of O 3 MHz 300…

A: Space waves are a class of radio waves which basically has a frequency range of approximately 30MHz…

Q: Consider the circuit below. solve the output voltage, Vo- 24 V Ge 8k2 Vo 16kn O 23 V O 46.6 V O…

A:

Q: 11.) A single phase inductive load at 0.70 power factor lagging takes 32 kVA power. Compute the…

A: The solution is given below

Q: R , Vor V 200VZ-10° , (assume positive sequence) %3D ry o=Z = 12 +j 4 a) Show all type of current…

A:

Q: A combination of three resistors R1, R2 and R3 in series is connected across a voltage source VT.…

A:

Q: Find the average current of a sinusoidal current wave during  half-cycle given instantaneous maximum…

A: The solution is given below

Q: Q3) State four features of Light Emitting Diode (LED).

A:

Q: 115 volts 60 cycle source is connected to series CKT, consisting of a fixed resistor and an…

A: In this question,   We need to determine the resistance and inductance of the impedance coil.   We…

Q: Find the current and voltage using superposition across the 4- kN resistor(I, and Vx, respectively).…

A:

Q: A LEO satellite was launched into an orbit at an altitude of 1000 km. The satellite orbits the earth…

A: It is given that: h=1000kmR=6371kmk=3.986×105 km3s2

Q: Find the Laplace Transform of the following. Answers must be in a simplified form and solutions must…

A:

Q: alternator is rated at 15kVA, 460V. The armature resistance and reactance are 1.50 and 30…

A: In this question we will find single phase alternator no load voltage with given data...

Q: using phasor. determine V, (t) and V2 (t) where w = 5 5 rad Is - Vi + O.IF 6OL-30 3 1, 64 10 La0 60…

A:

Q: what does the coupling coefficient do to the voltage output of a transformer? for example, the turns…

A: In case perfectly coupled transformer,  Coupling coefficient =1 When transformer is nor perfectly…

Q: Implement the below logic function with an 8 :/ multiplexer. AzA2 A,ø+ A3A, +A,A,A,A, + A, A,4,A,t…

A: A logic expression is given in the question. We need to implement the logic expression by a 8:1…

Q: Three resistors of 502, 1002 and an unknown resistance R are connected in parallel and the…

A: The solution is given below

Q: Coulomb's law concern itself with; (A) The interaction between two static charges. B The creation…

A: We need to select correct option for coulombs law

Q: The analysis of the voltage, V for the circuit given in The below circuit can be expressed in the…

A: Note: value  of id is not given. We assume id =0.5882

Q: Please write a long explanation so that we can report back to you Ideal Non-inverting Operational…

A:

Q: For the circuit shown below, use the superposition theorem and solve for the following: a. The…

A:

Q: Q3) The conduction angle of SCR in AC chopper fed R-load is equal to а. а Ob. B Oc. B+n Od.n-a

A: In this question,  we need to choose the correct options What is conduction angle of SCR?

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A:

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A:

Q: Table QI(a) Location Load Nos. Estimated Power Demand (W) 200 Factor Chandelier lamp Fluorescent…

A: Apart from the common electrical symbols for resistor, capacitor, and inductor. The electrical…

Q: The discrete time Fourier series representation of a signal x[n] with period N is written as x[n] =…

A:

Q: The analog signal ra (t) = e(240nl+) +e is sampled at F, = 300 Hz. What is the xpression for the…

A:

Q: The output of a filter is given by Y(t) = X(t) + X(t – T) where X (t) is a WSS process with power…

A:

Q: Ideal Non-inverting Operational Amplifier

A: Ideal Non-Inverting Amplifier:

Q: A power transformer with a voltage rating of 12500:240 V has a primary current rating of 50 A. Find…

A: given that,                  primary voltage VP = 12500 v                 secondary voltage Vs = 240…

Q: Complete the table. Solve the currents of the circuit using mesh analysis.Note: If there are no…

A: In this question,   We need to determine the loop currents as shown the circuit

Q: Find the Laplace Transform of the following. Answers must be in a simplified form and solutions must…

A:

Q: (A) The induced emf and the magnetic flux across the rectangular loop are out of phase by 90°. (B)…

A: The generator is a electrical machine which is capable of converting the mechanical power input into…

Q: e radiation pattern of an antenna is generally observed within: O The radiating near field region.…

A: The radiation pattern of the antenna is defined as the representation of electromagnetic field…

Q: If E = 2ax + ay - 3az, F = ay - az, and G = 3ax + 5ay + 7az, determine E • G - (|F|^2)

A:

Q: 1. A balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three- phase,…

A:

Q: 16.) Three cells each having emf of 1.4 V and internal resistance of 0.75 Q are connected in…

A:

Q: Reduce the biock diagram. H. R. G, G. G H, Q2

A:

Q: Z-TRANSFORM SOLVE:  yn+2 – 2 yn+1 + yn = 2n with y0 = 2, y1 = 1.

A: It is given that: yn+2 – 2 yn+1 + yn = 2n with y0 = 2, y1 = 1

Q: What is the  phase relationship    between    the  voltage    across     the resistor VR and the…

A: In this question we will write about series RC circuit voltage relationship...

Q: Question 17 In Frequency Division Multiplexing (FDMA) users are allocated a unique: O Code. Time…

A:

Q: E = K,ONvolts-where NIS Example 8.8. Afour-pole generator, having wa ve-wound armature winding has…

A: The solution is given below

Q: Determine the DC Voltage for a bridge rectifier with a 115 Vrms, 60 Hertz primary transformer. The…

A: In this question,   We need to determine the DC Voltage for a bridge rectifier?  Load is RC filter…

Q: 13.) Calculate the inductance or capacitance in series for the impedance 7.5z-53.13° ohms. Assume…

A:

Q: 9.) Assume the frequency to be 60 Hz. Calculate the inductance or capacitance in series for the…

A:

Q: When we denote the direction of the line currents in a balance load, balance source system, it is…

A: Balanced electrical supply Voltage Magnitude of each phase remain same Line voltage displaced by…

Q: Si 10 V 10Ω A Si Figure 4

A: We need to find out current for given circuit

Q: 2.) Two sinusoidal currents are given by, i1 = 20 sin (w t + Tt/4) and i2 = 25 sin (w t + Tt/5).…

A: The solution is given below

Q: Summarize the differences between passive filter and active filter in terms of gain, cost and…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: The C-S MOSFET amplifier has three low break frequencies in low frequency band at fLI =1 Hz (caused…

A: The given circuit is as shown below,

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.