3-26) A gas is contained in a vertical, frictionless piston- cylinder device. The piston has a mass of 4 kg and a cross- sectional area of 35 cm². A compressed spring above the pis- ton exerts a force of 60 N on the piston. If the atmospheric pressure is 95 kPa, determine the pressure inside the cylinder. Answer: 123.4 kPa

3-26) A gas is contained in a vertical, frictionless piston- cylinder device. The piston has a mass of 4 kg and a cross- sectional area of 35 cm². A compressed spring above the pis- ton exerts a force of 60 N on the piston. If the atmospheric pressure is 95 kPa, determine the pressure inside the cylinder. Answer: 123.4 kPa

Name: make it short and simple 3-26) A gas is contained in a vertical, frict
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: make it short and simple 3-26) A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of 4 kg and a cross-sectional area of 35 cm². A compressed spring above the pis-ton exerts a force of 60 N on the piston. If t

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of 4kg and cross-sectional area of 35cm?. a compressed spring above the piston exerts a force 60N on the piston. If the atmospheric pressure is 95kPa, determine the pressure in side the cylinder. (123.35kPa) 1.8
H.w: A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of 4 kg and a cross-sectional area of 35 cm2. A compressed spring above the piston exerts a force of 60 N on the piston. If the atmospheric pressure is 95 kPa, determine the pressure inside the cylinder 60 N P= 95 kPa mp=4 kg A = 35 cm www
Scanned with CamScanner cross-sectional area of 35 cm². A compressed spring above the piston exerts a force of 150 N on the piston. If the atmos- pheric pressure is 95 kPa, determine the pressure inside the cylinder. Answer 147 kPa 150N P-95 kP. A=35 cm Scanned with CamScanner Both a gage and a manometer are attached to a O gas tank to measure its pressure. If the reading on the pressure gage is 80 kPa, determine the distance between the two fluid levels of the manometer if the fluid is (a) mer- 1000 kg/m'). I. 1-69 cury (p = 13,600 kg/m) or (h) water (p P = 80 kPa Gas HIGURE P1-69 Scanned with CamScanner CHAPTER I 1-72 A mercury manometer (p = 13,600 kg/m) is con- nected to an air duct to measure the pressure inside. The differ- ence in the manometer levels is 15 mm, and the atrmospheric pressure is 100 kPa. (a) Judging from Fig. P1-72, determine if the pressure in the duct is above or below the atmospheric pressure. (b) Determine the absolute pressure in the duct. Air
A 98.43ft vertical column of fluid (density is 1878 kg/m3) is located where is 31.66ft/sec2. determine the pressure at the base of the column in kPa.
The pressures in the piston-cylinder assembly shown in the figure are P1 = 1000 kPa, P2 = 500 kPa and P3 = 100 kPa. If the diameters of the small and large cylinders are %3D D1 = 3 cm and D2 = 8 cm, respectively, what is the mass of the piston? D, P, P3 Piston P2 D2
Equal to 250 kN 2. A square plate of surface area 9 square meters is held vertically in water. Determine the total pressure force on the surface and the center of pressure if its upper edge is 3 m below the surface of water * Free surface of water F is greater than 4000 kN and Yp is less than 4m Fis greater than 3000 kN and Yp is less than 5m Fis greater than 5000 kN and Yp is less than 3m II >
A conical tank of top radius 4-ft and height 4-ft is filled with oil with a specific weight of (20a+4) y. The work needed to pump the oil out of the top of the tank is equal to where a is a constant. What is the value of a? -nу ft-lbs, a
3-49 The pressure difference between an oil pipe and water pipe is measured by a double-fluid manometer, as shown in Fig. P3-49. For the given fluid heights and specific gravities, calculate the pressure difference AP = PB – PA: Glycerin SG = 1.26 Water SG = 1.0 Oil SG = 0.88 %3D 60 cm 10 cm B 15 cm 20 cm Mercury SG = 13.5 اضف ملف ک
2. Air is enclosed by a rigid cylinder containing a piston. A pressure gage attached to the cylinder indicates an initial reading of 25 psi. Determine the reading on the gage when the piston has compressed the air to one-third its original volume. Assume the compression process to be isothermal and the local atmospheric pressure to be 14.7 psi. Ans. 104 psig
3-47 Two chambers with the same fluid at their base are separated by a pistan whose weight is 25 N, as shown in Fig. P3-47. Calculate the gage pressures in chambers A and B. FIGURE P3-43 Piston 344E Twa eil tanks are connected to each other through a manometer. If the difference between the mercury levels in Air p Air Oil Oil 50 em 10 in 30 cm 25 cm E. 30 cm 32 in Water CMereury 50 c FIGURE P3-44E FIGURE P3-47 108 FLUID MECHANICS 3-50 Consider the system shown in Fig. P3-50. If a change of 0.7 kPa in the pressure of air causes the beine mercury interface in the right column to drop hy 5 mm in the hrine level in the right column while the pressure in the brine pipe remains coustant, determine the ratio of AJA, 3-48 Consider a double-fluid manometer attached to an air pipe shown in Fig. P3 48. If the specific gravity of ene fluid is 13.55, determine the specific gravity of the other fluid for the indicated absolute pressure of air. Take the atmospheric pressure to be 100 kPa. Answer: 5.0…
a force is 1.6 kN is applied uniformly on piston of 8 cm diameter. determine the pressure on the piston.