3. If R₁ 12 Ohms and R₂ = 6 Ohms, calculate 1₁. www + V₁ - ww +V₂' 4V

Q: Resistors in Parallel R₂ R3 R₁ -OOD 6 kn 3 ΚΩ 1 kn RT R₁ R5 R6 1 kQ 700 Ω 4200 Ω Find the total…

A:

Q: Given the circuit in the figure below, find the current in the loop: Assume R₂50R₂-120R,…

A:

Q: Types of DC Generators 1. A compound dynamo supplies a load of 20 kW at 400 V. The shunt and series…

A:

Q: Solve Vo using superposition and show each circuit

A: In this question,  We need to determine the voltage Vo using the superposition theorem.  Here 2…

Q: Please expound the solution for Vo''

A: When more than one source is present in the electrical network, the Superposition theorem is used.…

Q: R(s) 2. X3(s) X₂(s) -24 -26 X₁(s) C(s)

A:

Q: coil has a resistance of 4 ohm and an inductance of 9.55 mH. Calculate the reactance, the impedance,…

A: We need to find out the reactance , impedance and current and phase angle for given voltage and…

Q: 4. Find the unknown currents marked in below figure. A 20 A B 50 A D 15A 13 120 A F E 15 40 A

A:

Q: 02. A 4 pole 50 Hz induction motor is running at 1470 rpm. What is the slip value?

A: Given: An induction motor has, Number of poles, P=4. Supply frequency, f=50 Hz. Rotor speed, Nr=1470…

Q: 4Ω www 3A (Η 2 Ω ww 8 Ω + 3Ω να - +1 12 V

A:

Q: 402 12V 2222 3.50 Vo 30 + 12V

A:

Q: What sets field programmable gate arrays different from other semiconductors?

A: In the given questions we need to tell about that why the FPGA is better than the other…

Q: 1. - In the circuit of fig 1 the input voltage Vent is 120 volts rms with a frequency of 60 Hz. The…

A: It is given that: Vp=120 Vf=60 HzVd=0.7 V

Q: In the circuit shown, the potential at point A is defined to be 1.0 V. wwww 2.092 B 9.0V 3.0V www…

A:

Q: units. Is 4/0° A ZL jin Given the following circuit, find the Thevenin Equivalent between a-b.…

A:

Q: 3. Determine current flowing through 52 resistor in the circuit shown in Fig. 1. Use source…

A:

Q: QUESTION 10 10V Figure 9.1 1292 12 Ω 15,4 Ω 3.4 Ω www 8 Ω 69 a www See Figure 9.1. What is the…

A:

Q: 27. Obtain Thevenin's equivalent circuit at A B, as shown in Fig. 23. -880 276 [Ans. 119 119 502 www…

A: We need to find out the thevenin equivalent circuit for given circuit , first we will find out the…

Q: If power gain of an amplifier is 20W/W, find the power gain in dB.

A: Given, Power gain of the amplifier, G=P0Pin=20 W/W.

Q: 1. Two shunt generators A and B operate in parallel, and their load characteristics may be taken as…

A:

Q: 4.2 2A 2 3.$ Vo 7% A 4

A: This is a problem of nodal analysis. The detailed solution is given in the next step

Q: A 100 kV, 50 Hz supply is fed to a rectifier ammeter (using a bridge rectifier) throu PMMC ammeter…

A:

Q: 2. Use the signal flow graphs (Mason's Rule) to reduce the multiple subsystems shown below and…

A:

Q: Determine the input common-mode range for a bipolar differential amplifier in the figure below…

A:

Q: What is the maximum number of digits that may be used in the Octal System?

A: Octal number system : The main feature of Octal number system is that it compries of digits ranging…

Q: 10. Find the Norton's current in the circuit shown below. 10 306300A.

A: In this question,  We need to determine the norton current in the circuit.  We are solving this…

Q: EXAMPLE 4.23 A 500 µH inductor, 80/² pF capacitor and a 628 resistor are connected to form a series…

A:

Q: 4. Find the unknown currents marked in below figure. 20 A B 50 A A➡ D 15A 4V 1=2A AX15 F 40 A 5.…

A:

Q: 3. How do transistors use semiconductors?

A:

Q: 5. The resistors, labeled A through F, in the following circuit represent incandescent lightbulbs…

A: Note The brightness of a bulb is directly related to the current flowing through it If the current…

Q: Design an ammeter with a range of 0-5mA, 0-10mA and 0-20mA from an ammeter whose full scale current…

A: We need to find Design a multi range ammeter for given current

Q: 3. Each of the two channels of the power supply pictured here can provide 30 V, but we want to run a…

A: Note : The circuit for information given at top is not given. Circuit with resistances R1,R2,....R7…

Q: QUESTION 7 9 What is this a symbol of? O Motor starter coil O Heater Horn O Solenoid valve

A: Symbols are very important to represent the system in a more approachable and understandable form.…

Q: The measured value of a capacitor is 205.5 µF whereas its true value is 202.4 µF. The relative error…

A:

Q: Problem 1. Write the equations of motion of the linear translation system shown in Fig. 1 (a) and…

A:

Q: 2. Determine the impedance of the following circuits if w=50rad/sec Zin 35 10 mF

A: Given circuit,

Q: EXAMPLE 4.23 A 500 µH inductor, 80/² pF capacitor and a 628 resistor are connected to form a series…

A:

Q: Write the function of crossbar switch?

A: To explain: the function of crossbar switch

Q: The measured value of a capacitor is 205.5 µF whereas its true value is 202.4 µF. The relative error…

A: The basic problem on measurement is solved as shown

Q: Find the Fourier transform for each of the following signals, using the Fourier integral: a) y(t) =…

A: In this question,  We need to determine the Fourier transform for the given signals.  We are solving…

Q: Problem 1 A 15 KVA, 2200/220 V transformer has R. = 195 Q and Xm = 170 2 referred to the LV side.…

A:

Q: Q1/ A 6-poles generator having a 3-phase, star connected winding. To induce a line voltage of 3300V…

A:

Q: For the time-harmonic magnetic field H(t) = ax Ho sin(kyy) cos(wt - Bz) in a region of free space:…

A:

Q: 1/a/ the density of electrons increases along the coordinates of the metal according to the…

A:

Q: 1. A control system in which the control action is somehow dependent on the output is known as (a)…

A: A control system in which the controller action is dependent on the output is known as ...... The…

Q: A mass is connected by a spring and damper to the wall as shown in the following figure. The floor…

A: In this question,  We need to calculate the transfer function of the given system.  We are solving…

Q: RCS) 电 35 +4 S 7////

A:

Q: R2 (s) 3 ya+ R1 (s) “င် း ာင်းနှင် + |H2 |3 | Y6 G₁ | G3 Y2 (s) + /ya + 7 G5 |s Y1 (s)

A: Given: A block diagram of a control system To find: Solve T11(s), T12(s), T21(s), and T22(s)   Note:…

Q: Solve for V0 using mesh analysis Step-by-step, please. I need to understand the process.

A:

Q: 4 pole 50 Hz induction motor is running at 1470 rpm. What is the slip value?

A:

Unijunction Transistor (UJT)

The Unijunction Transistor (UJT) is a three-terminal switching semiconductor device. It contains an n-shaped silicone object bar with a terminal attached to its two ends known as base one and base two. The third terminal is connected to a highly enclosed p-type material attached to the bar section of its length and is known as emitter. As there is only one corrective cross within the device, it is therefore called the 'Unijunction' transistor. The characteristics of the single junction transistor show the wrong resistance if it finds use in resting oscillator circuits for various applications.