3. In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peakvalue of 48 V. If the load is 500 N and the ripple factor is no more than 8%, which of thefollowing capacitors can be used? Support your choice(s)a) 0.68 µF, 50 V b) 680 mF, 25 V c) 62 uF, 75 V d) 560 uF, 75 V

It is given that: Vcmax=48 Vγ≤8 %≤0.08RL=500 Ω

3. In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peak value of 48 V. If the load is 500 Q and the ripple factor is no more than 8%, which of the following capacitors can be used? Support your choice(s) a) 0.68 uF, 50 V b) 680 mF, 25 V c) 62 µF, 75 V d) 560 uF, 75 V

3. In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peak value of 48 V. If the load is 500 Q and the ripple factor is no more than 8%, which of the following capacitors can be used? Support your choice(s) a) 0.68 uF, 50 V b) 680 mF, 25 V c) 62 µF, 75 V d) 560 uF, 75 V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 4RQ: What is the difference between a diode and rectifier?

See similar textbooks

Similar questions

What is the difference between a diode and rectifier?
What is CEMF?
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to IL-DC =0:5A RL VL-DC =20V 220V omsb O 001 F O 0.02 F O 0.0167F O None of the above Activate
ier quesuon Will save this response. Quèstion 6 Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to iL-DC =05A RL VLDC =20V 220V omsb 0.01 F 0.02 F 0.0167 F Hows b None of the above DEV Chp
Determine the ripple factor for the filtered rectifier circuit below when RL= 4KO. Then explain briefly the effect of changing in the RL value on the output waveform. 5:1 Vp= 0.7v for all diodes Vma 100 V f= 60H2 D S0uF
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to 220V omsh RL VI-DC20V 0.01 F 0.02 F 0.0167 F None of the above
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to 220V ams 5OHZ İL-DC =05A RL VL-DC =20V
a full-wave rectifier with a capacitor-input filter provides a dc output voltage of 35V to a 3.3k ohms load. Determine the minimum value of filter capacitor if the maximum peak-to-peak ripple voltage is to be 0.5V.
In the clamping circuit below, assume the diode has Von-0.7V and V₁ is a sinusoidal wave with a peak-to-peak amplitude of 10V. How much is the maximum value of the output voltage signal (Vmax)? And how much will it be if we set V₂=2V? Input V1 C1 0.1e-6 9.3 V and 7.3 V 9.3 V and 11.3 V 11.3 V and 7.3 V O 7.3 V and 12.0 V O 12.0 V and 7.3 V Output D1 1N4148 .tran 30-3 V2 0 Vmax V(output) 0.0ms putput MAN Input 0.6ms 1.2ms V(input) 1.8ms 2.4ms 3.0ms
What voltage is boosted at the output of a multiplier. a) average b) rms c) peak d) instantaneous Which assumption is not used in the analysis of multipliers? a) a capacitor will not discharge b) start with the cycle of the source that will forward bias the nearest diode c) the output will always be multiplied d) a single diode is forward biased at a time A voltage multiplier a) multiplies the output voltage b) has very high voltage and low current c) can employ inductors d) may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations at a) the input and output b) the load c) source d) in the environment Between a lower percent regulation and a higher one, which is better? a) lower b) higher
Q2) The expected average and RMS output voltage of the following PLECS circuit is equal to Single-phase diode rectifier L: 0.05 01 V_R (V i_N Scope V: 120 w: 2*pi*60 v_N R: 2.50 C: 500e-6 Oa) 40V, 84.85 V Ob) 38 V, 84.85V c) 38V, 80.2V O d) 40V, 38V Probe Probe
R VD 3cos(1000nt) VOUT 0.7 V What are the minimum and maximum values of Vout assuming the offset model for a diode with Von = 0,7 V for the input signal shown below? Chọn một: O a. Minimum -3 V, maximum 1.4 V O b. Minimum 1.4 V, maximum 3 V O c. Minimum 0.7 V, maximum 3 V O d. Minimum -3 V maximum 0.7 V O e. Minimum -3 V, maximum 3 V