Answered: 5- Why should the terminal voltage drop…

5- Why should the terminal voltage drop more in the case of shunt generator than in the case of separately excited generator as the load current is increased ?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Related questions

Q: How can the speed effect on the No Load characteristic And the external characteristic Of the shunt…

A: No load characteristics is also called magnetic characteristics. This characteristics shows the…

Q: A synchronous generator having no-load frequency of 51HZ and droop constant of 0.5Hz/MW is…

Q: Define the drooping charateristic of a DC generator. What is its significance when two DC generators…

A: To define the drooping charateristic of a DC generator. To find its significance when two DC…

Q: Which of the following factor is responsible for negative voltage regulation of a DC generator?…

A: Voltage Regulation :- It is defined as the ratio of change in full-load voltage from no-load voltage…

Q: Is there a great difference between long and short - shunt compound generator , show that ?

A: The main difference between long shunt compound generator and short shunt compound generator: Long…

Q: Is the parallel operation of shunt generators stable if their characteristics are not identical?…

A: Parallel operation of DC generators is required to meet the extra load demand. It is always…

Q: Can an induction motor work as a generator ? Why ?

A: An AC motor is an electrical machine that takes AC electrical input energy and produces mechanical…

Q: 5- Why should the terminal voltage drop more in the case of shunt generator than in the case of…

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: b) Why the power factor of three-phase induction motor low at no-load and increase as applied load…

A: Power Factor = Real Power/Apparent Power,or p.f. = W/VA.Then the cosine of the resulting angle…

Q: Discuss power equation of synchronous motor

A: A synchronous motor coverts electrical power to mechanical power but always runs at synchronous…

Q: For which reasons its not possible to develop rated voltage of d.c shunt generator, both in unloaded…

A: It is not possible to develop rated voltage in dc shunt generator because of the commutation process…

Q: 1. How does loading of the Generator affect the Generator’s Terminal Voltage (VT) and Load Current…

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: What are the reasons for the drop in terminal voltage of self excited shunt generator When loaded?

A: With increases in the load, the terminal voltages of all dc shunt generators decrease.

Q: : in DC generator how can get the output voltage more than no-load voltage? which type of connection…

A: A DC machine is classified in two types. DC motors DC generators Above question is based on DC…

Q: 1. How does loading of the Generator affect the Generator’s Terminal Voltage (VT) and Load Current…

A: It is asked the affect of loading on the Generator’s Terminal Voltage (VT) and Load Current (IL). We…

Q: Draw the Terminal Characteristics of the following Generators. (i)Shunt DC Generator (ii)Series DC…

Q: 4- Is there a great difference between long and short shunt compound generator, show that?

A: Compound Generator: The generator which have both shunt fields and series fields is called the…

Q: Load characteristic of DC generator is a graph between Il and Vt. True or False

A: The load characteristics of a dc generator gives the relationship between the line current and…

Q: The effect of the capacitor on the operation of the asynchronous machine as a generator what? Please…

A: The asynchronous machine acting as a generator is a type of induction machine. The rotor of such…

Q: The purpose of diverting resistance in series dc generator to control the effect of field winding

A: Divert resistance in DC series machine. This resistance is connected to parallel of field winding…

Q: . Type of compound DC Generator wherein the shunt field winding is connected across the armature and…

Q: Why the power factor of three-phase induction motor low at no-load and increase as applied load…

A: Power factor is define the cosine of power factor angle. So Why the power factor of three-phase…

Q: give one example of asynchronous generator and its operation and characteristics

Q: Which of the following is true for the phasor diagrams drawn according to the ohmic, inductive and…

A: For a synchronous motor, In normal excitation condition, synchronous motor draws sufficient amount…

Q: 2. For which reasons its not possible to develop rated voltage of d.c shunt generator, both in…

A: It is not possible to develop a rated voltage in dc shunt generator because of the commutation.…

Q: 0.07 ohm, respectively. In order to make the generator flat-compound, so that it will have a no-load…

A: Given 10kW 250V compound generator No load voltage 230V Shunt field has 800 turns per pole And…

Q: Rotor leakage impedance at starting is different from its value at normal running conditions. a)…

Q: ndard practice of synchronous generator construction now a days is to ndrical field ating armature…

A: These are the few questions related to the basic understanding of alternators their construction and…

Q: Open circuit (OC) and short circuit (SC) tests on an AC generator are conducted under the condition,…

A: Open circuit test: In this test the generator must be moved to at its rated speed and no-load must…

Q: b) Why the power factor of three-phase induction motor low at no-load and increase applied load…

A: In this question , we will write the reason of low power factor of induction motor at no load..

Q: What is the effect of variation of speed on build up in generator shunt

A: In a DC generator, the relation between generated voltage or build-up voltage and speed is given by,…

Q: For DC shunt generator, external characteristics is the relationship between Answer:

A: For DC shunt generator, external characteristic is the relationship between

Q: The following characteristic curve represents: VT Select one: O a. The terminal characteristic of…

A: The given characteristics curve is,

Q: Demonstrate over compound flat compound and under compound DC generator with the help of circuit…

Q: QI: What is the relation between the speed of compound generator and shunt field current? Write your…

A: (a) At no load The figure below shows a graph of variation of field current (If) with the no-load…

Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…

Q: 1- What is the no-load characteristic of d.c. generator? ic?

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: Which of the following factor is responsible for negative voltage regulation of a DC generator? O…

A: Over compound dc generator has negative voltage regulation.

Q: 1. What is the difference between circle diagram method and equivalent circuit method in calculating…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: A three phase, synchronous generator ed at reactance of 1.2 ohm /phase, and an armature resistance…

Q: How does loading of the Generator affect the Generator’s Terminal Voltage (VT) and Load Current…

Q: 4- Why should the terminal voltage drop more in the case of shunt generator thần in the case of…

A: The terminal voltage drop more in the case of shunt generator than in the case of separately…

Q: 1. How does loading of the Generator affect the Generator’s Terminal Voltage (VT) and Load Current…

A: When we increase the loading value, then it draws more current. Let's draw the general circuit…

Q: 4. Is there a great difference between long and short shunt compound generator, show that?

A: In short shunt connection the shunt field is associated straightforwardly across the armature…

Q: What are the components of generator?

A: we want to know What are the components of a generator?

Q: 3) Why Ego is not equal to zero at If=0 in separately excited do generator?

A: Need to find Eg0 is not equal to zero at If=0 in separately excited DC generator why

Q: (a) With the aid of diagrams describe the basic topology of a wound field 3 phase synchronous…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Why should the terminal voltage drop more in the case of shunt generator than in the case of…

Q: Problem 4.9: A 60-Hz synchronous generator rated 30 MVA at 0.90 power factor has the no-load…

Question

i need the answer quickly

5- Why should the terminal voltage drop more in the case of shunt
generator than in the case of separately excited generator as the
load current is increased ?
6- Why it is possible to short circuit the differential compound
generator and not the cumulative compound generator ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

5.26. A 23-kW, 230-V, 900-rpm shunt generator has 240.5 V induced in its ar- mature winding when it delivers the rated load at the rated voltage. The field current is 5 A. What is the armature resistance? What is the field- circuit resistance? The no-load voltage of the generator is 245 V. What is the voltage regulation? Why is the induced emf at the rated load not equal to that at no load?
L-1). The 3-phase wound-rotor induction motor has .... . a) high starting torque b) low starting current c) both "a" and "b" d) neither "a" nor "b" L-2). The 3-phase wound-rotor induction.........a) motor has a wire wound rotor b) motor's rotor can be connected to an external resistive load by way of slip rings and brushes c) motor requires more maintenance than the 3-phase squirrel-cage induction motor d) all of the above L-3). The 3-phase wound-rotor induction motor's rotor circuit's resistance should be adjusted so it is__________ during starting. a) low b) high c) either "a" or "b" d) neither "a" nor "b" L-4). Will a 3-phase wound-rotor induction motor start with no external circuit connected to its rotor leads? a) yes b) no
2. Describe the Torque-Slip characteristics of a three phase induction motor.
Describe the basic circuit of DC Generators including its yoke, fid windings, interpoles, fieldpoles, difference of shunt coils and series coils, commutator and brushes ?
In alternator armature winding why we prefer : a- short pitch winding w.r.t. full pitch winding? b- distributed winding w.r.t. concentrated winding? c- double layer winding w.r.t. single layer winding?
Q3/ A/ Compare between de series and shunt generator. Q3/ B/ Briefly explain the commutating process in dc machine.
1) P.f of inductive load is corrected by connecting . . across it. .... ...... 2) Open circuit test measures . losses. 3) The output variables of a motor are and ........ ... .... 4) For a motor output power is given by ...... 5) Flux control, voltage control, and armature control are three methods for ....... of dc motor. 6) A transformer takes 100V at primary and gives 50V at secondary, its turn ratio equals 7) The given set of equations represents . . Ea – laRa = Vr , la = IL , %3D Rf 8) The given set of equations represents. la = !, + IL, VT Rf Ea – laRa = Vr , 9) The given set of equations represents . Ea – laRa – IseRse = Vr, la = Ise = l, %3D | 10). .. has more initial torque than shunt dc motor.
1-transfer function of DC Series motors. 2-block diagram of DC Series motors.
1- To control the speed of an induction motor, the supply frequency is reduced by 10%. For the same magnetizing current to remain constant, the supply voltage must be....... a) Reduced by 10%, b) Reduced by 20%, c) Increased by 10%, d) Increased by 20% 2. When maximum starting torqua ic ohtoinod
A value of magnetizing current in a 3-phase induction motor * gives power factor smaller .. larger smaller. .poor large . better O large...poor O
Electrical Engineering A 50-kW, 250-V short-shunt compound generator has the following đata: R, = 0.06 2, R, = 0.04 2, and R,= 125 2. Calculate the induced armature voltage at rated load and terminal voltage. Take 2 V as the total brush-contact drop. Ans: 272V
6. The relation between the field current and the armature current in an alternator with the armature short-circuited can be shown byA. a rated-current 80% pf saturation curve.B. a synchronous impedance curve.C. an open-circuit saturation curve.D. a zero-power-factor regulation curve.