5. The mineral analysis below was reported for a water sample. Calcium 90 Chloride 120 Magnesium 30 Sulfate 170 Iron (Fe**) 5 Bicarbonate 165 Sodium 10 PH 7.5 units Potassium Note: All reported as “mg/L as the ion" unless stated otherwise. Draw a bar chart that includes all the ions listed above. (Remember to convert to appropriate units) b. What is the total hardness of the water using ALL multivalent cations in mg/L as а. CACO3? What is the total hardness of the water using the predominant polyvalent cations in mg/L as CaCO3? с.

5. The mineral analysis below was reported for a water sample. Calcium 90 Chloride 120 Magnesium 30 Sulfate 170 Iron (Fe**) 5 Bicarbonate 165 Sodium 10 PH 7.5 units Potassium Note: All reported as “mg/L as the ion" unless stated otherwise. Draw a bar chart that includes all the ions listed above. (Remember to convert to appropriate units) b. What is the total hardness of the water using ALL multivalent cations in mg/L as а. CACO3? What is the total hardness of the water using the predominant polyvalent cations in mg/L as CaCO3? с.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 107QRT

See similar textbooks

Similar questions

What is the microscopic explanation for the macroscopic behaviour illustrated in Figure 11.15?
Calculate the volume of concentrated ~ 0.1250 M copper (II) acetate monohydrate solution needed to prepare 25.00 mL of ~0.0500 M copper (II) acetate monohydrate from your stock solution.
1. A sample of ilmenite (FeTiO3) analyzes 27.8% titanium and 35.4% iron. a. Which of the two elements is also likely to be found in the impurity materials in the sample? b. Based on the limiting element, what percentage of the sample is actually ilmenite? c. A 100 gram sample of the mineral is placed in a vessel containing 4.64 molality HF. The HF reacts with the FeTiO3 forming hydrogen gas and a solution containing TiF4, ferric fluoride and water. Write the reaction and determine how many liters of HF solution will be needed to complete the dissolution, using 30% excess. Given these conditions, what would the concentration of titanium in the solution be, in terms of grams per liter and mole?
Determine the exact hardness in units of mg/L as CaCO3. Ba2+ contributes to hardness as well.
Solution AII. Calculate the volume of concentrated ~ 0.1250 M copper (II) acetate monohydrate solution needed to prepare 25.00 mL of ~0.0500 M copper (II) acetate monohydrate from your stock solution. Calculate the theoretical (i.e. calculated) molarity of solution AII.
1.) AI. Calculate the mass of copper (II) acetate monohydrate needed to prepare 100.0 mL of ~0.1250 M solution from solid copper (II) acetate monohydrate. 2.) Calculate the volume of concentrated ~ 0.1250 M copper (II) acetate monohydrate solution needed to prepare 25.00 mL of ~0.0500 M copper (II) acetate monohydrate from your stock solution. 3.) Solution BI. Calculate the volume of concentrated ~0.02XXX M(use the exact molarity from the lab) M KMnO4 stock solution needed to prepare 100.0 mL of ~ 0.00100 M KMnO4 solution. 4.) Solution BII. Calculate the volume of ~0.00100 M KMnO4 (Solution BI) needed to prepare 25.00 mL of ~ 4.000 x 10–4 KMnO4 solution. 5.)Calculate the volume of ~1.25× 10–3 M K2CrO4 stock solution needed to prepare 10.00 mL of dilute solution. 8.75 × 10–4 M CrO4 solution. [Remove this statement and enter calculation here] 6. )Calculate the theoretical (i.e. calculated) molarity of solution AII. [Remove this statement and enter calculation here] 7.)…
A hollow square metal tube has a measurement of 2.42 in for each side and a weight of 53.71 g. The volume of empty space inside the tube was measured to be 0.93 in³. If the density of the metal used in constructing the tube is 11.81 g/mL, calculate the length of the tube in inches. Note: 1 in = 2.54 cm, 1 cm3 = 1 mL %3D Show your solutions in the next item Round your answer to 2 decimal places.
A newly-discovered iron ore was examined to determine percent iron in the ore gravimetrically. 5.408 grams of the ore samples was subjected to gravimetric analysis and precipitated as iron (III) oxide and dried at 105 degrees Celsius. What is the percent iron contentn of the ore if the mass of the precipitate is 0.3785 grams?
A sample is known to consists of NaOH, or NaHCO3 or Na2CO3 or possible compatible mixture of these, together with inert matter. With methyl orange, a 1.100 g sample requires 31.4 ml of HCl ( 1.000ml is equivalent to 0.0140 g CaO). With phenolphthalein , the same weight of the sample requires 13.3 ml of the acid. Calculate the percent inert matter in the sample? ( ans. 17.7%)
Determine the percentage Fe in a sample of limonite from the following data: -Sample : 0.5000g -KMnO4 used = 50.00 ml -1.000ml of KMnO4 is equivalent to 0.005317 g Fe -FeSO4 used = 6.00 ml -1.000ml FeSO4 is equivalent 0.009200 g FeO
Excess crystals KCr,0, Crystals of K2Cr207 are added to water and dissolved until a large excess of crystals sink to the bottom of the container. Which of the following are true the diagram above? [Check any that are true statements.] The orange liquid is a saturated solution. The solution can be made more concentrated by adding more crystals. O Adding a small amount of water to dissolve a few of the excess crystals will decrease concentration. O Adding a twice the amount of water needed to dissolve the excess crystals will lower the concentration. OEvaporating some water will cause more crystals to appear. but the concentration will not change. Adding more crystals will darken the orange color of the liquid.
a) Tiffany received a pesticide sample and was asked to analyse its arsenic content. Sample was precipitated as MGNH4ASO4 (181.25 g/mol) and subsequently heated to form Mg.As207 (310.45 g/mol). Results shown that a 1.134 g pesticide sample yielded 135.8 mg of Mg:As207. Based on the information provided above, report the gravimetric factor and % w/w As (74.92 g/mol) in the pesticide sample.