6. For the network of Figure 6, the capacitor is fully discharged, since the switch is in position 2. Find the mathematical expressions for the transient behavior of the voltage v, and the current i, following the closing of the switch at position 1 at t = 0 sec. Find the mathematical expressions for the voltage v. and current i, as a function of time if the switch is thrown into position 2 at t = 1sec. Draw the resultant waveforms of the voltage v. and current i on the same time axis.

6. For the network of Figure 6, the capacitor is fully discharged, since the switch is in position 2. Find the mathematical expressions for the transient behavior of the voltage v, and the current i, following the closing of the switch at position 1 at t = 0 sec. Find the mathematical expressions for the voltage v. and current i, as a function of time if the switch is thrown into position 2 at t = 1sec. Draw the resultant waveforms of the voltage v. and current i on the same time axis.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
capacitor having capacitance of 10uF is connected with 1k ohm resistor in series. The switch of the DC supply of 10 Volts, closes at t = 0. Compute the following a. Draw a circuit diagram for t- and t+ b. Compute the time constant c. Plot the Voltage with respect to time, showing the behavior of capacitor charging(take at least 10 values of time in seconds to draw a graph).
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
When the switch is in position 2, the circuit will discharge the capacitor. Draw the circuit for the discharge phase. (without any of the charge phase components). and determine the time constant for the discharge phase and the equations for v(t) and i(t) for the discharge phase.
a) With switch J2 open, close switch J1. Estimate the time it takes to do it. Obtain the equations for the voltage and current of the capacitor. Determine the energy stored by the capacitor. b) Open switch J1, close switch J2. Estimate the time it takes to do it. Obtain the equations for the voltage and current of the capacitor.
What do you think will happen to the current if the frequency is adjusted higher in the pure inductance experiment? and what will happen to the current if the frequency is adjusted lower in pure inductance experiment? explain why please
. In the adjacent figure each of the two capacitors mounted in parallel has a value C,the resistor has a value R, and the power supply has value ɛ= 25 V. Upon closing thekey S the charging process of the two capacitors starts. The initial value of the electriccurrent was I0 = 25 mA, as shown in the table below, then the electric currentdecreased until it vanished at . The table below shows the values of the electriccurrent every two seconds as measured by the ammeter A.a) Determine the value R of the resistor in k ohm units.b)Plot the I-t graph (electric current versus time).c)Determine the circuit constant time from the I-t graph.d)Determine the value C of each capacitor in micro F units.e)Complete the table by evaluating the electric charge q(t) on eachcapacitor at the moments .
a. As capacitor charges, describe the behavior of: i.current with time ii. the voltage across the resistor with time iii. capacitor voltage withtime Explain the reason for each behavior.
Draw the inductance and resistance voltages on an oscilloscope screen in accordance with their polarity. In the drawing, it should start with voltage changes and values and should be stable. Write the Time/Div and Volt/Div steps made on the oscilloscope during the measurement on the oscilloscope screen drawing. Specify the voltage labels in the drawing. The current through the circuit has the same variation as the resistor voltage measured from the equation V=I/R, but is 1/47 times the value.
For the circuit, now keep switch J2 closed, close switch J1. Determine the expressions for the voltage across the capacitor and the current delivered by the source. Find the time it takes for the capacitor to reach its final voltage and what value it is.
For the following circuit, do the following:a) Write the mathematical expressions for the voltage VC, VR1 and IC if the switch is on theposition 1.b) Find the voltage VC, VR1 and IC if the switch changes to a position 2 at t = 100ms.c) Determine the discharge time of the capacitor.d) Draw the charge and discharge waveforms.
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV