Question 3Figure 4 below shows two blocks connected by a light inextensible string.60°30 kg10 kgFigure 4Required:A.Draw a diagram to show all forces acting on the blocks.В.Given that the coefficient of friction between the blocks and the surface is 0.25 and thatthe blocks accelerate at 2.0 ms-2, determine:the tension in the stringii. the magnitude of pulling force F.i.

When there is any relative motion between any two surfaces, there is a force that opposes the motion…

Answered: 60° 30 kg 10 kg

Engineering

Mechanical Engineering

60° 30 kg 10 kg

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.3P: Two identical chairs, each weighing 14 lb, are stacked as shown. The center of gravity of each chair...

See similar textbooks

Similar questions

Two identical chairs, each weighing 14 lb, are stacked as shown. The center of gravity of each chair is denoted by G. The coefficient of static friction is 0.2 at B (the contact point between the chairs) and 0.35 at A, C, and D. Determine the smallest force P that would cause sliding.
A wedge is used to prop up the 6000-lb block of marble. The wedge angle is =30, and the angle of static friction is s=12 between all contact surfaces. Determine the smallest force P that would prevent the wedge from sliding out.
The coeffient of static friction between the uniform bar AB of weight W and the ground is 0.45. Find the smallest angle and the corresponding force P that would initiate simultaneous tipping and sliding of the bar.
The coefficients of friction between the block ana the rail are us= 0.25 and uk= 0.20. Given: P2 = 200 N. P1 350 P2 Find the magnitude and direction of the smallest force P1 required to start the block moving up the rail. (You must provide an answer before moving on to the next part.) The magnitude and direction of the smallest force P1 required to start the block moving up the rail is °. N v (Click to select)
A dictionary is pulled to the right at constant velocity by a 10 N force acting 30° upward above the horizontal. The coefficient of kinetic friction between the book and the horizontal surface is 0.5. What is the weight of the book?
The Figure Q2 shows a ball and block with masses M1=10kg and M2, respectively. The block and ball are connected with a cable and pulley system. The coefficient of static friction for all contacting surface is 0.3. i) Determine the range of the mass of block so that the system is in M1 = 10 Kg equilibrium. ii) Determine the tension in the cable. M2 Hs= 0.3 Comment on your answer at question 2(i). 75%
A crate of 60 kg simply stands on the moving cart with constant acceleration a. The height from the center of gravity to the cart is L, and the incline has angle. The coefficient of static friction between the crate and the cart is g = {ms}. Match the following situations to the correct impending motion: if sliding will occur first or if tipping over will occur first? 0.5 m 0.5 m 0 G L = 1.2 m; 0= 7°, μg = 0.29. L = 1.0 m; = 13°, μg = = 0.45. L = 1.5 m; 0.3. 0 = 15, μs = L = 1.5 m; = 15°, µg = 0.5. L = 1.4 m;0= 7°, μl g= 0.4. a 1. Tipping over will occur first. 2. Sliding will occur first.
The system shown is in static equilibrium and motionless. • The force "P" is at the maximum magnitude that will not initiate motion. NOTE: Submitted responses shall be to 4 significant figures. Do NOT use scientific notation. Find: 1. The magnitude of weight of Block-A is 2. The magnitude of internal force in the rope is N. _N. 3. The magnitude of normal force between Block-A and Block-B is N. 4. The magnitude of friction force between Block-A and Block-B is N. 5. The magnitude of normal force between Block-B and the Ground is 6. The magnitude of friction force between Block-B and the Ground is 7. The magnitude of force P is_N. _N. N. A 100 kg 30° H, = 0.30 200 kg B P -Hy = 0.20
QUESTION 2 Figure Q2 shows a 100 kg block is pulled by a man with a cable. The coefficient of static friction between the block and floor surface is 0.3, determine: a) the tension in the cable to stop block A form slipping down. b) the tension in the cable to start moving block A towards the man. SOALAN 2 Rajah S2 menunjukkan blok 100 kg ditarik oleh seorang lelaki dengan kabel. Pekali geseran statik antara blok dan permukaan lantai adalah 0.3, tentukan: a) ketegangan dalam kabel untuk menghentikan blok A dari tergelincir ke bawah. 60 b) ketegangan pada kabel untuk mula menggerakkan blok A Figure Q2/ Rajah S2 ke arah lelaki itu.
A box weighing 150lb is moved across a horizontal Floor by dragging it by means of a rope attached to the front end. If the rope makes an angle of 30° with the floor and if the coefficient of friction between box and floor is 0.400, find the force exerted by the man pulling the rope.
A 250 lb refrigerator is being pushed. You do not know what force P should be applied. The coefficient of static friction between the refrigerator and floor is point G. 0.4. The center of gravity of the refrigerator is at = d2 ++ d2 → F1 d3 d1 d4 Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value di 4.5 ft d2 1.5 ft d3 2.5 da 3.5 a. Determine the force P that is needed to overcome friction. b. Determine the location of the normal force x measured from the center of the refrigerator if the force P from part a is applied. c. Determine the minimum force P that is required to tip the refrigerator. d. Will the refrigerator slip or tip first? Round your final answers to 3 significant digits/figures.
Situation 2: Find the minimum force P required to just pull out box B. Also, find the tension of the cord supporting box A. Take note that the coefficient of friction between the blocks is 0.10. While between block B and the ground, u = 0.25. 350 N B 70N A. Magnitude of P (N) B. Tension on the cable (N)