A 10 μF capacitor is initially charged to 100 volts d.c. It is then discharged through a resistance of R ohms for 20 seconds when the p.d. across the capacitor is 50 V. Calculate the value of R.
Q: The op amp in the circuit shown in Fig. P13.46 is ide- al. There is no energy stored in the circuit…
A: Given op amp circuit vg =20000tu(t) We will use Laplace functions to solve this question.
Q: 12.42 A balanced three-phase generator delivers 7.2 kW to a wye-connected load with impedance 30 -…
A:
Q: Give at least two processes (1 industrial plant and 1 Power plant) where a SCADA system is applied…
A: According to the question, We need to give at least two processes (1 industrial plant and 1 Power…
Q: From the figure, the voltage Vc at t = (0+) is equal to?
A: Given:
Q: 2. Prove that capacitance in parallel circuits are added, or C = C₁ + C2 + C3 + . Cn
A: The solution is given below. The problem is basic of capacitor. The capacitors ate added in…
Q: 2.14 The spring-mass accelerometer shown schematically in figure 2.16 has a sensing mass of 0.05 kg…
A:
Q: 0 Vo = -2V for figure (a) V₁ = -4V for figure (a) Vo = -4V for figure (b) Vo = -3V for figure (b) Vo…
A:
Q: How do semiconductor diodes and transistors compare?
A:
Q: -2M1 저씨 ㅇ 1 1 ㅍ 2
A: Given Data: A periodic square waveform with unity amplitude. To find: 1. Fundamental frequency and…
Q: Is this an SMA connector? What are the technical specifications need to consider?
A: The given image is shown below. We need to tell what is shown in the image, Also the specifications…
Q: 2. Given the diode circuit shown, determine VD, VR, and IR using the third approximation if E=12V…
A: In this question We need to determine the voltage across diode VD, current in the diode and…
Q: What is the total area for the following Copper wire run? Three -10 AWG type THHN Solid Seven -12…
A: Given Data: Number of AWG -10 type solid conductor = 3 Number of AWG -12 type solid conductor = 7…
Q: 1. A sequential circuit is defined by the following characteristic equations: Q1+ x' Q1 + xy QO+ =…
A:
Q: Solve for the current flowing through the 8 resistor in the following figure. 292 ww 492 www isa SV…
A: Given data, Circuit diagram is given as,
Q: The function Q of the next circuit is O Q-(A+B+C)+A(B'C') O Q-(AB)+A(B+C) O Q-(ABC)+A(B+C) O…
A: Given, Logic circuit is given as,
Q: What is I in terms of U and R
A: Consider voltage V at node 1, Apply nodal analysis at node 1 : (V-u)/R + V/2R +V/R+V/2R = 0…
Q: Is the current at question (b) IRMS or is it already the current?
A: It is given that: VRMS=120 VR=20 Ω
Q: Q31 For the circuit below, 1. Calculate i3 and Vx. 2. Find the power delivered to the 6 Ohm…
A:
Q: 14. (1e:1.8) We now attach two output terminals to the circuit from problem 13. The resulting…
A: It is given that:
Q: 13.36 There is no energy stored in the circuit in Fig. P13.36 at the time the voltage source is…
A: Given:
Q: 4. Determine if the flip-flop in Figure 7-94 is operating properly, and if not, identify the most…
A:
Q: Solve a), c) and d) only showing all the steps in detail and the K-Map
A: In this question we need to find the minimum POS of the given Boolean function by using K map
Q: Show through derivation. Why is the unit of reactance Xc and XL are express in ohm.
A: Answer: Reactance refers to the resistance that arises against the flow of alternating current…
Q: Part A Find the equivalent voltage. Express your answer with the appropriate units. ANSWER: UTh Part…
A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage. The…
Q: 1- If the highest frequency of the modulating signal is 3 kHz, the bandwidth of the DSBAM- SC signal…
A: We need to select correct option for given each problem .
Q: Use the mesh-current method to find the branch currents ia-ie for the circuit shown in (Figure 1).…
A: Using the mesh-current method to find the branch currents ia to ie. Given: v = 340V From the…
Q: Draw the wiring diagram of DELTA DVP-SS2 | plc
A: We have to Describe and Draw the diagram of DELTA DVP-SS2
Q: 16 A 4-pole dc series motor has wave connected winding with 600 conductors. When fed from 250 V dc…
A: Given- Number of poles P=4, Number of conductors Z=600, 250 V dc source, Load = 5 kW A=2 Current=50…
Q: Problem 3-An AC circuit is shown. The source voltage is vs(t) = 14.14 cos(1000t) V. a) Find the…
A: The impedance of the capacitor can be calculated by using the given input voltage frequency and then…
Q: The steady state current flowing through the inductor of a DC-DC buck boost converter is given in…
A: Given- A DC-DC buck-boost converter. The peak-to-peak ripple in the output voltage of the converter…
Q: Autotransformer starting uses a(n) ___ 3 phase autotransformer to provide reduced-voltage starting.…
A: Autotransformer The autotransformer is used to transfer power from one circuit to the another…
Q: + From the circuit shown, the current Isw at t = 0+ is O A O 6 A O4 A none of the given option 10 A…
A:
Q: So what, really, is digital audio? The procedure whereby analogue audio is transformed into digital…
A: Digital audio: Digital audio is a representation of sound that has been digitally recorded or…
Q: Vb=5V, R1=4Ω, R2=8Ω, R3=12Ω, R4=16Ω Compute the listed: Equivalent resistance of entire system.…
A:
Q: Consider the following spring-mass-damper mechanical system. The input is given by f(t), and the…
A:
Q: Solve for the current flowing through the 8 resistor in the following figure. 292 492 www isa SV 892…
A:
Q: 16 A 4-pole dc series motor has wave connected winding with 600 conductors. When fed from 250 V dc…
A: In this question We need to determine the torque developed of the motor We know Torque = power/w…
Q: 5. A single phase full wave ac voltage controller working on ON-OFF control technique has supply…
A:
Q: What are the parameters need to consider for transmission line, explain in basic terms?
A: In this solution we discuss about basic transmission line parameters. There are mainly four…
Q: 4. Determine the time-domain waveforms in standard cosine format corresponding to the fol- lowing…
A:
Q: The p-type sample (N₁ = 10¹7 cm³³) is uniformly illuminated with light at room temperature,…
A: Since you have posted multiple questions with multiple sub parts, we will provide the solution only…
Q: A 1602 resistor, an 8302 inductive reactance, and a 20 capacitive reactance are in series. A 120V…
A: Given: Resistance = 16Ω Inductive Reactance= 83Ω Capacitive Reactance= 20Ω
Q: Find the Norton equivalent with respect to the terminals a,b for the circuit seen in . Suppose that…
A:
Q: Explain what will be seen on a synchroscope, when the frequency of the incoming source is higher…
A: During synchronisation, the Synchroscope is a tool used to measure the phase angle discrepancies…
Q: 5. Calculate the improvement in signal to noise in progressing from spectrum A to spectrum D in the…
A: Given the progressing signal to noise. We can drawn the signal to noise representation. Where S/N…
Q: Consider an ac power circuit containing an ideal inductor. Determine the phase shift between the…
A:
Q: 60° c
A: In the given figure it is a two sinusoidal signal v1 and v2 , we need to find the angle between the…
Q: ▾ Part A Find the current in the circuit using a sequence of appropriate source transformations.…
A: The required parameters can be calculated by using source transformation. The voltage source can be…
Q: Determine V2 applying nodes analysis and if the voltage and current source increase the triple, how…
A: The given circuit diagram is shown below,
Q: 1. Construct a 16*1 multiplexer with two 8*1 and one 2*1 multiplexers 1. Implement a 4*16 decoder…
A:
do question
Step by step
Solved in 2 steps with 3 images
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
- Can current flow through a capacitor?You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?4. In what form is the energy of a capacitor stored?
- You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
- What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?Describe the behavior of the voltage across the resistor with time as thecapacitor charges. Explain the reason for this behavior.1. 1-5 K 30v a. what is tue T CTime constant) ? b. How long will it take for the capacutor TO rtach s0% op charge? C. What is tne voltage of capa citor apter 1 seconds? d. How many tíme constants will it take for the soltage to reach 23 v? C. Gweng that the capacitor is fully changed, how will it take por it to be 20% ? long 120v + BF what is the. T ? b. what is the voltage capacitor apter 10 sec? a. C. How many time constants will it take for Tue Vo Itage to reach 80 v.? d. Given that the capaator is Fully charged, how time constants will it be to reau many GOV!