Answered: A 1,000 ft. of aluminum wire, whose…

A 1,000 ft. of aluminum wire, whose diameter is 0.365 in., has a resistance of 0.13 Q at 20°C. What is its percent conductivity?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: Calculate the total charge in Coulombs (to 2dp) that has passed through a reference point in a wire…

A: Given, The total charged has passed through a reference point in a wire from, Time, t = 0 sec to t =…

Q: Permittivity characterizes the tendency of the Atomic Charge in an insulating material to distort in…

A: Permittivity :- It is the ability of a material to store electrical energy under the influence of an…

Q: Find the total current flowing (in ampere) in a cylindrical conductor (solid wire) 1 meter long and…

Q: Q1 Two conducting plates of size 1x 5 m are inclined at 45° to each other with a gap of width 4 mm…

Q: 3. Consider the conducting plates shown in Figure 3. If and determine V, and in the dielectric…

A: A dielectric region is a region electrical insulated which can be polarized by current flow. A…

Q: C) A 50-m-long copper wire has a circular cross section with radius r= 2 cm. Given that the…

Q: 2. A 2m diameter plastic sphere, used in a static electricity demonstration, has a uniformly…

A: This question belongs to electro magnetic field theory . It is based on the concept of potential at…

Q: It is found that the resistance of a coil of wire increases from 40 ohms at 15 degrees Celsius to 50…

Q: In dielectric material with ɛ = 2.8 ɛ0, V = sin(30). At point P (1, 5°, 4), the volumetric charge…

Q: A rectangular cross-section conductor has length/cross-sectional area ratio of 700 × 106 m-'. A…

A: Given values are - LengthArea=LA=700×106m-1I=5mAV=100mVMobilityμ=500cm2Vs=500×10-4m2Vs

Q: A rectangular aluminum bus bar is 0.9m long, 0.15 m wide, 0.013m (1.3cm) thick. If the current in…

Q: 5. A long copper wire carries a current of 20A which is evenly distributed in each cross-section of…

A: It is given that: I=20 AD=4mmr=2mmresistance per unit length=5Ωkm=5×10-3Ωm

Q: A rectangular aluminum bus bar is 0.9m long, 0.15 m wide, 0.013m (1.3cm) thick. If the current in…

A: The transmission of power from one place to another is very necessary, usually, the voltage level of…

Q: Given that the expression for the current density (See Figure below) Determine the current in A…

Q: Q9: Find the length of copper wire of diameter (1mm) which will have a resistance of (IKN) and…

A: Given: For a copper wire, The diameter is d=1 mm Resistance is R=1 KΩ Conductivity is σ=5.8×107 S/m…

Q: Q17. If the dielectric strength of air is 5kV/mm, calculate the distance, D that the discharge will…

Q: copper wire of 2mm diameter with conductivity of 5.8*10 7 S/m and electron mobility of 0.00032m 2 /…

A: We need to find out charge density , current density and current and drift velocity for given Copper…

Q: A superconducting wire of radius 1.2 mm carries current uniformly distributed through its cross…

Q: The he current flowing through a 100 m long conducting wire of uniform cross section has a density…

Q: Quèstion 9 As the force between the nucleus and the valance electrons increases, the conductivity…

A: Solution Given data, Force between nucleus and valance electrons increases.

Q: A material has permittivity relaxation time constant 8.854 × 10-¹² F/m] € = : 460 and conductivity o…

A: Given, A material has permittivity, ε=4εo Conductivity, σ=10-14 Sm εo=8.854×10-12 Fm

Q: 2. An infinitely long coaxial cable has an inner and an outer conductor of radii "a" and "b"…

Q: Assume that dry soil has σ = 10−4 S/m, ε = 3εo, and μ = μo. Determine the frequency at which the…

A: Given data, σ=10-4 S/mε=3ε0μ=μ0

Q: B) The permittivity of a solid insulator is 75 and loss angle is 1 degree. If the insulator is…

A: According to question:

Q: The inner surface of a plane brick wall is at 60°C and the outer surface is at 35°C. Calculate the…

A: We have to find out thermal conductivity

Q: The wire of our appliances are insulated with a material mixed with rubber, which has a very high…

A: According to question: The resistance of the wire is calculated as…

Q: In a simple concentric spherical system, the radius of the inner electrode is 3 cm and the radius of…

A: The concentric spherical electrode system is shown below: The maximum electric field at the layer…

Q: If the ratio of the plate width to the distance between the plates is 2π mm in a parallel plate…

A: In the question, If the ratio of the plate width to the distance between the plates is 2π mm. d/D=…

Q: A simple sphere can offer resistance to a current flowing radially outward from it. If the radius of…

Q: Two equilateral triangular parallel plates (side length = 50mm) facing each other experiences a flux…

A: Given data: a=50 mmϕ=900 Nm2/CS=60 nm The expression for the flux is given as: ϕ=E×A The mass of…

Q: The resistance of copper wire with alpha = 0.00393/Co at 20oC is 129 Ω. At 78 oC, its resistance…

A: Given Copper wire α=0.00393/°CT1=20° CRT1=129 ΩT2=78° C

Q: Calculate the capacitance between surfaces r= 4 and r= 10 with dielectric of er=3 ? between these…

A: Given, Outer radius=rb=10Inner radius=ra=4εr=3Charge=Q=50Potential between two…

Q: A coil of copper wire has a resistance of 62 ohms at a room temperature of 24 degrees Celsius. What…

A: In the question, Coil of copper wire Resistance R1= 62 ohm at T1= 24°C Find the resistance R2 at…

Q: Find the resistance at 20°C of an annealed copper bus bar 2 m long and 1 cm by 4 cm in rectangular…

Q: A hollow conducting hemisphere of radius a is buried with its flat face lying flush with the earth's…

A: Hollow hemisphere are two diameter of circular base .one diameter is inside circular base and…

Q: Given a material has a conductivity of 1.255 x 107 S/m. If the electric field intensity present is…

Q: Which term refers to the maximum electric field that can produced in the dielectric before it breaks…

A: Option "a" dielectric strength.

Q: Which term refers to the maximum electric field that can produced in the dielectric before it breaks…

Q: a) In an experiment using a copper made conductor, the resistance of the conductor which has a…

A: Write the given values in the question.

Q: Discuss what happens at the microscopic level of the dielectric material when it is placed in an…

A: It is asked to discuss what happens at the microscopic level of the dielectric material when the…

Q: mea (a) How does the above expression get modified if we assume that all the electrons have same…

A: Solution- we know, frequency dependent relative permittivity εrω = 1+Nq2mε0∑jfiω2j-ω2+iωYj a) we…

Q: An infinite nonconducting sheet has a surface charge density of 0.25 µC/m² on one side. How far from…

Q: A cylindrical section of dielectric 10 mm thick with a relative permittivity of 4 contains a…

A: Given, Relative Permittivity εr= 4 height (t)= 1mm dielectric thickness (T) = 10mm 10×10-310-21 cm…

Q: Consider a material for which o = 5 S/m and e, = 1, the electric field intensity is E = 250 sin aot…

A: We need to calculate conduction current density

Q: (Part II) A dielectric material with permeability that of free space, permittivity = 9xpermittivity…

A: Given a dielectric material with Permittivity (ε)=9×permittivity of free space(ε0)Conductivity(σ)=4…

Q: Two conductors with a diameter of 20mm are separated at distance of 5 cm through a material whose…

Question

A 1,000 ft. of aluminum wire, whose diameter is 0.365 in., has a
resistance of 0.13 Q at 20°C. What is its percent conductivity?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Waveguide and Its Characteristics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A wire has a circular cross-section of radius r= 3.53 mm. The conductivity of the wire is 1x10^5 (Ohm, meter) and its lengthis 2m. The total resistance of the wire in Ohms is:O a. 0.51O b. 0.72ç. 0.26O d. 5136.07O e. 797497.60
Besides lower electrical conductivity, suggest a reason why ruthenium is not used inelectrical transmission wires. Give a detailed response
Figure 1 shows a ferromagnetic core with a relative permeability of 1850, the depth of the core is 10 cm. The air gap on the core is 0.2 cm with effective area 5 % larger than their physical size due to fringing effects. Given the number of turns N = 500 and current i = 2 x, where x is the last digit of your student ID (example: EEE1705590, then i = 20 A): (a) Find the total reluctance of the core and air gap. [CLO1-PL01:C2] (b) Find the flux density of the air gap. [CLO1-PLO1:C2] 13 cm 23 cm 9 cm 5.6 сm Air gap 31 cm N turns 7 cm Figure 1
2. When a current of 1A flows through a wire, the drift velocity of the electrons is 0.9 mm/s. What will be the drift velocity of the electrons when a 2A current flows through another wire of the same material having double the length and double the area of cross section and same temperature.
A nickel chromium alloy conductor of resitance 24 ohms is 110 inches long and has a resistivity of 640 ohms-CM/ft. Determine its diameter.
2. Anelectric current in a conductor varies with time according to the expression t0- sin t where lis in amperes and tis in seconds, What is the charge-time graph related to this curren?
As the voltage across conductors is increased, the gradient around the surface of conductor ... .. O becomes zero O remains same O decreases O increases
Nb3Sn and GaV are candidates for a superconducting application, when the magnetic field is 150,000 Oe. Which of them would require the lowest temperature in order to be a superconductor?
: Explain briefly various theories of breakdown in liquid dielectrics
What do you understand by 'instrinsic strength' of a solid dielectric? How does breakdown occur due to electrons in a solid dielectric?
What effect does temperature have on the electrical conductivity of a semiconducting material? How does this compare with the effect of temperature on the electrical conductivity of a typical metal?
Determine the mutual inductance between a very long straightwire and a conducting circular loop of radius “b” m set up “d” mapart on the same plane as shown figure.Problem: