A 5.000-g soil sample was analyzed for potassium content by extracting the potassium using 10.00 mL aqueous ammonium acetate solution. Following the extraction, the soil was filtered and rinsed. The filtrate with rinsings was diluted to exactly 50.00 mL. Then, 1.00 mL of this solution was diluted to 25.00 mL, and this dilution was tested with an instrument. The concentration in this 25.00 mL was found to be3.18 ppm. What is the concentration of the potassium in the soil in ppm

A 5.000-g soil sample was analyzed for potassium content by extracting the potassium using 10.00 mL aqueous ammonium acetate solution. Following the extraction, the soil was filtered and rinsed. The filtrate with rinsings was diluted to exactly 50.00 mL. Then, 1.00 mL of this solution was diluted to 25.00 mL, and this dilution was tested with an instrument. The concentration in this 25.00 mL was found to be3.18 ppm. What is the concentration of the potassium in the soil in ppm

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter6: Steam Distillation, Vacuum Distillation, And Sublimation

Section: Chapter Questions

Problem 11Q

See similar textbooks

Similar questions

You want to determine the concentration of NaCl in a water. In preliminary analysis, it appears to be saline water with a NaCl content of approximately 4%. Should you dilute the sample if your titrant has a concentration of 0.1 M and you want to spend 25 mL of sample? Solution: You must dilute approximately ten times, taking 10 mL of sample and making up to 100 mL. In this way, 17.20 mL of titrant will be spent.
In the titration calculation, moles of KOH were calculated from the known molarity and measured volume. Reaction stoichiometry was then used to convert that to moles of succinic acid. At this point, how could the moles of succinic acid be converted to a mass of succinic acid rather than a concentration?
Twenty tablets (labelled 300 mg aspirin per tablet) had a total mass of 6.9117 g. The tablets were powdered and 0.5423 g of powder was added to 30.0 mL 0.494 M sodium hydroxide solution and the mixture boiled gently for 10 minutes. The excess alkali in the cooled solution was titrated with 0.475 M hydrochloric acid solution and 20.25 mL required for neutralization. Given that aspirin (C9H8O4) and NaOH react in a 1:2 ratio calculate the percentage of aspirin as compared to the labelled claim. Aspirin Mr(C9H8O4) = 180.2
The total cation content of natural water is often determined by exchanging the cations for hydrogen ions on a strong acid ion-exchange resin. A 25.00 mL sample of a natural water was diluted to 100.00 ML with distilled water, and 2.06 g of a cation - exchange resin was added. After stirring, the mixture was filtered and the solid remaining on the filter paper was washed with three 15.00 mL portions of water. The filtrate and washings required 16.30 mL of 0.0282 M NaOH to give a bromocresol green end point. a) Calculate the number of millimoles of cation present in exactly 1.00 L of sample. b ) Report the results in terms of milligrams of CaCO3 per liter. Only typed solution.
A 36.0 mL sample of aqueous sulfuric acid was titrated with 0.250 M KOH(aq) until the acid-base indicator signaled that the solution was neutralized. The mixture was then carefully evaporated to dryness, the residue was dried in a drying oven. The residue was then weighed and a value of 861 mg was obtained for its mass. Calculate a value for the volume of the potassium hydroxide solution that was used in the titration from this data. Answer with correct units and significant figures.
. The total cation content of natural water is often determined by exchanging the cations for hydrogen ions on an ion exchange resin. The cations are adsorbed to the resin which releases H+ (1:1 exchange) which can then be titrated with a base. A 25.0 mL sample of a natural water is diluted to 100 mL with distilled water and 2.0 g of a cation-exchange resin was added. After stirring, the mixture was filtered and the solid remaining on the filter paper was washed with three 15.0 mL portions of distilled water. The filtrate and washing required 15.3 mL of 0.0202 M NaOH to reach the equivalence pt. Calculate the number of moles of cation present in 1.00 L of sample.
A 36.0 mL sample of aqueous sulfuric acid was titrated with 0.250 M ROH(aq) until the acid-base indicator signaled that the solution was neutralized. The mixture was then carefully evaporated to dryness, the residue was dried in a drying oven. The residue was then weighed and a value of 861 mg was obtained for its mass. Calculate a value for the volume of the potassium hydroxide solution that was used in the titration from this data. O 12.7 mL O 19.8 mL O48.5 mL 39.5 mL
You want to determine the concentration of NaCl in a water. In preliminary analysis, it appears to be saline water with a NaCl content of approximately 4%. Should you dilute the sample if your titrant has a concentration of 0.1 M and you want to spend 25 mL of sample?
Five white, 500-mg uncoated ascorbic acid (AA) tablets with an average weight of 0.6152-g were pulverized in a mortar. A sample of the powdered ascorbic acid weighing 0.4700-g was placed in an iodine flask and was dissolved in 50-mL H2SO4 then 5-g of KBr was added to the resulting solution. The solution was titrated with 47.81-mL of 0.09640 N STD. KBrO3 to reach a faint yellow endpoint then 3-g KI and 5-mL Starch TS. The blue color solution is then titrated with 2.73-mL of 0.09123 N STD. Na2S2O3 to reach the disappearance of the blue iodostarch complex. MW: KBrO3 = 167.0 ; KIO3 = 214.0 ; Na2S2O3 = 158.11 ; C6H8O6 = 176.12 Compute the milligrams of pure AA per tablet from the assay. 293.3 mg 502.5 mg None of the choices 383.9 mg
The salt content was extracted from a 12.0000 g junk food sample. The extract was diluted to 100.00 mL. From this solution, 15.00 mL was taken and required 23.75 mL of a 0.08943 M AgNO3 solution to reach the endpoint. What is the percentage by mass of salt as NaCl (58.45 g/mol) in the junk food sample?
this type of analysis refers to the determination of the identity of the analyte in the sample
You were assigned to assay a product sample of milk of magnesia. A 0.600-g sample was reacted with 25.00 mL 0.10590 N H2SO4 . The excess unreacted acid in the solution required 13.00 mL of 0.09500 N NaOH when titrated to reach the methyl red end point. Determine the dosage strength of the product in terms of % Mg(OH)2 content. Type your answer in 2 decimal places, numbers only.