a) A parallel RLC network is constructed with a 5 mH inductor and the remaining compo- nent values are chosen such that Qo = 6.5 and wo = 1000 rad/s. Determine the approximate value of the input impedance magnitude for operation at 750 rad/s; b) An RLC circuit is constructed using R = 50, L = 20 mH, and C = 1 mF. Calculate Q0, the bandwidth, and the magnitude of the impedance at 0.95wo if the circuit is (a) parallel-connected; (b) series-connected. C) Assuming an operating frequency of 200 rad/s, find a series equivalent of the parallel combination of a 500 resistor and (a) a 1.5 µF capacitor; (b) a 200 mH inductor.

a) A parallel RLC network is constructed with a 5 mH inductor and the remaining compo- nent values are chosen such that Qo = 6.5 and wo = 1000 rad/s. Determine the approximate value of the input impedance magnitude for operation at 750 rad/s; b) An RLC circuit is constructed using R = 50, L = 20 mH, and C = 1 mF. Calculate Q0, the bandwidth, and the magnitude of the impedance at 0.95wo if the circuit is (a) parallel-connected; (b) series-connected. C) Assuming an operating frequency of 200 rad/s, find a series equivalent of the parallel combination of a 500 resistor and (a) a 1.5 µF capacitor; (b) a 200 mH inductor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Similar questions

In a series RLC circuit, the applied voltage is 120V. At resonance, the frequency is 200rad/sec, and the circuit current is 6.26 A. What is the resistance of the circuit (in Ohms)? (Use 2 decimal places. Unit is not required.)
The inductance coil in the series resonant circuit is 0.2 H, and the resistance coil is 50 Q. At what capacitance value does resonance occur at 1500 kHz in this circuit? Assuming a 100 V r.m.s. e.m.f. at the source.
A tank circuit contains a capacitor and an inductor that produce 30 2 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277V is connected to the circuit. What is the total circuit current of the resonant frequency? Show your work. a) IT= 0.615 A b) IT= 0.423 A c) IT = 0.846 A d) IT= 0.321 A
In the circuit shown, the sinusoidal current "ient" (Input current) is the input quantity and the voltage "vsal" (Output voltage) is the output quantity. The parameters are R1=R2=R3=5 kΩ and L=100mH. a) Draw the Bode diagrams of magnitude and phase of the circuit. Give the magnitude in decibels and the phase in degrees. b) Analyze the drawn diagrams comparing them with the expected behavior when ω→0 and when ω→∞.
4. Given the following LRC circuit below: The circuit shown has a resonant frequency, fr=100 kHz. The circuit has a resistance value, R = 10002, capacitance value, C = 1.33nF. and an inductance value of L=1.904mH. a. Determine the quality factor, Q, for the circuit b. What is the BW of this circuit? c. Calculate the upper and lower cut-off frequencies. d. If the following triangle wave with a fundamental frequency, f, of 20 kHz is put through this filter, determine the output.
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.
In the circuit of Figure, the magnitudes of V₁ and V at the resonance are twice L C that of VD. The inductance of the coil for R* 50 Hz is 520⁰ VR www. 502 Vc ell V₁
The current at resonance in a series R-L- C circuit is 0.12 mA. The circuit has an inductance of 0.05 H and the supply voltage is 24 mV at a frequency of 40 kHz. Determine: a) The circuit resistance, and b) The circuit capacitance. ANS: (a) 2002 (b) 316.6 pF.
The current at resonance in a series R-L-C circuit is 0.12mA. The circuit has an induc- tance of 0.05 H and the supply voltage is 24 mV at a frequency of 40 kHz. Determine (a) the circuit resistance and (b) the circuit capacitance.
A resistance of 100 and a capacitance of 100 µF is connected in series to the parallel combination of a 20-0 resistor and a 15-mH inductor. The circuit is energized by a 120 Vac, variable frequency supply. Derive the formula for resonant frequency and use it to find the resonant frequency.
In a series RLC circuit, the applied voltage is 108V. At resonance, the frequency is 200rad/sec, and the circuit current is 8.38 A. What is the resistance of the circuit (in Ohms)?
A series circuit consists of a 120V, 50HZ source, a 300 resistor, a 100mH inductance, and a variable capacitance. Find the capacitance required to create a series resonance condition at this frequency. O 202.8uF 507.12uF O 101.4uF O 676.16uF