Find ? A cage-rotor induction generator is drivensuccessively at two speeds N₁ and N₂. Thestator outputs to these speeds are 12 kW.N.The ratio of N₂ is 1.091 and synchronousspeed of generator is 1000 rpm, then speedN₁ will be (neglect rotor reactance andstator resistance) rotor voltage per-phase atstandstill = 150 V.

Given- Cage-rotor induction generator, Speeds N1 & N2, Stator outputs = 12 kW, Ratio N1N2=1.091,…

A cage-rotor induction generator is driven successively at two speeds N₁ and N₂. The stator outputs to these speeds are 12 kW. N₁ The ratio of N, is 1.091 and synchronous speed of generator is 1000 rpm, then speed N₁ will be (neglect rotor reactance and stator resistance) rotor voltage per-phase at standstill = 150 V.

A cage-rotor induction generator is driven successively at two speeds N₁ and N₂. The stator outputs to these speeds are 12 kW. N₁ The ratio of N, is 1.091 and synchronous speed of generator is 1000 rpm, then speed N₁ will be (neglect rotor reactance and stator resistance) rotor voltage per-phase at standstill = 150 V.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 6 pole wave wound d.c. shunt generator has 500 conductors. A generator delivers 50 kW of power at 250 voltage at full load. The resistance of the field circuit is 125 2. Actual brush shift is 10°. Then find the demagnetizing and cross magnetizing ampere turns per pole and how many additional turns must be wound on each pole to eliminate the demagnetizing effect.
Two 30 AC generators are such that one has twice the linear dimensions of the other. The field windings of each are excited to give identical sinusoidal air gap flux density waveform. Both have the same number of stator slots and identical winding patterns. The conductors per slot in big generator in K times that of the smaller one. The value of K to get equal no-load voltage at same frequency is (a)8 (b) 8 1 (d) 7 (c) 4
Discuss the effects of rotor resistance in T-S characteristics of 3 phase induction motor.
Explain the conditions for parallel operation of synchronous generators. A three phase, wye connected, synchronous generator is rated 150 MW, 0.85 lagging power factor, 12.6 kV, 60 Hz, and 1800 rpm. Each winding has an armature resistance of 0.05Q and a synchronous reactance of 0.6Q. Draw the phasor diagram with values, show torque angle and determine the induced voltage for the condition of rated load.
A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then line current is a. 2A b. 1A c. 9A d. 10A
The armature reaction occurs when a separately excited generator supplies rated load: Is always present Is always absent May be sometimes present None of the above
What will be the front and back pitches of the 6-pole dc generator with a simplex 2-layer wave winding having 36 conductors and the winding is retrogressive?
A synchronous generator is connected to a pure capacitive load. The field excitation is kept constant and the stator resistance is assumed negligible. Explain, with the help of phasor diagram(s), how the generator’s terminal voltage will vary when the capacitive load is increased while the power factor is kept constant.
A 4 pole dc shunt generator with a shunt field resistance of 100 ohm and an armature resistance of 1 ohm has 378 wave connected conductor in its armature. the flux per pole is 0.02wb, if the load resistance of 10 ohm is connexted across the aemature terminal and the generator driven at 1000rpm, calculate the power obsorbed by load
(use 2-decimal digits for solutions) A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216slots, each containing 5 conductors arranged in a full-pitched winding for 3-phasestar connection. All the conductors of each phase are in series and the flux perpole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emfinduced in each phase winding and the terminal voltage.
True False In self-excited DC generator, the residual flux is primary condition in e.m.f generation Answer by true or false * True False The flux of shunt wound DC generator induced during loading
7 A three-phase, 60-cycle, 32-pole synchronous generator has a sinusoidally distributed air-gap flux of 0.025 weber/pole. The armature core has 324 slots. The armature winding is Y-connected. There are two coil sides per slot and two turns per coil. The coil pitch is 9 slots. Find the generated voltage between the line terminals. Ans. 2,445 V