I need the answer quickly A carrier signal given by cos 47 (105)t volt is AM/SSB+ /SC modulated by themessage signal given by 3 cos 6n(103)t volt.1) Prove that the modulated signal ØssB. (t) is (A cos 2nft), then find the value of Aand f.2) Find ØsSB,f).3) Calculate sideband power and transmission efficiency.

Answered: Image /qna-images/answer/13e1d053-64ae-4990-8fe4-3cdd71c6c005.jpg

Answered: A carrier signal given by cos 47(105)t…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q2. For the scheme shown in Figure Q2, i. Draw the spectrum of the baseband signal (multiplexer output) for the multiplexer. ii. Determine the bandwidth of the baseband signal (multiplexer output) for the multiplexer. i. Determine the minimum transmission bandwidth of the multiplexer. Explain, briefly, the modification needed for the multiplexer in the figure to achieve this bandwidth. 4 kHz cos 10,000xt Basebund signal cos 24,000mt cos 2000mt cos 32,000nt Figure Q2
(a) Explain on the AM Single Sideband Full Carrier (SSBFC) and compare to DoubleSide Band Full Carrier (DSBFC) on their:(iv) Carrier power.(v) Sideband power
If the carrier signal is given as c(t)=5cos10000t, and the modulating signal is given as m (t) = 4e2rtthen the power (in watt) of the modulated DSB-SC signal is:
Q2: A modulating signal is used to modulate a carrier signal(AM modulation). Let Pr . Pc. PSB. PuSB. PLSB and u are the total power, carrier power, side band power, upper side band power, lower side band power and modulation index respectively. Prove the following: a. Pc = Pr () c. Pusn = Pisn =) Pr m2 b. Psn = Pr %3D 2+m2 LSB 2+m? (2+m2
then second questrion po eh eto 2. Determine the over-all transmittance of the signal flow graph shown below.
Question 2 (a) Briefly explain the advantage of the following Amplitude Modulation (AM) type and state ONE (1) application for each AM type: i. Double Sideband Full Carrier (DSBFC) ii. Double Sideband Suppressed Carrier (DSBSC) iii. Single Sideband (SSB). (b) The AM waveform for the modulated signal is illustrated in Figure 1. i. Calculate the percentage of modulation index, m. ii. State the type of the modulated signal. Justify the answer. iii. Write the equation for the modulated signal. iv. Calculate the percentage of power efficiency. 3V -1IV Figure 1
i)Modulation process takes place in the modulator with two injection signals namely data orinformation and carrier. It is a vital step in generating a decent signal for electronic communication.Whenever the carrier is modulated by the information signal, new signals at different frequenciesare generated as part of the process. These new frequencies occur in the frequency spectrum withinthe range of the carrier frequency. Conclude these frequencies and mathematically explain itsgeneration with the help of diagrams. A) Upper sideband and lower broadbandB) Lower sidefloor and upperside floorC) Lower peak and upper peakD) Upper sideband and lower sidebandE) Lower bandwidth and upper gainF) All of the aboveG) None of the above
A carrier signal given by 10cos2r×108t volt is FM modulated by single tone message 4cos2nx103t volt if the modulation constant is 1000 Hz/Volt a) Compute max. frequency deviation and deviation ratio. b) Write the equation of modulated wave. c) Sketch the spectrum. d) Calculate sidebands carrier and total power.
A 1.5MHZ carrier signal is modulated with 3.4kHz modulating signal. The modulated carrier voltage. is 28V, and 14V, min across a 100 resistive load impedance. a) Peak amplitude of the unmodulated carrier . b) Coefficient of modulation. c) Carrier power d) Sideband power . e) Total power. f) Upper and lower sideband frequencies. g) Bandwidth
PM modulated signal is demodulated using: Select one: a. Costas PLL O b. Discriminator Oc. Discriminator followed by integrator O d. Carrier reinsertion method A PLL can be used for the generation of an in-phase carrier for the coherent demodulation of DSB-SC Select one: O True O False
AC H.W Fc A carrier signal given by 10 cos 2n x 10t volt is FM modulated by single te Hz message 4 cos 2n x 10°t volt if the modulation constant is 1000 Am Volt Fm a) Compute max. frequency deviation and deviation ratio.A. E b) Write the equation of modulated wave. Ac c) Sketch the spectrum. d) Calculate sidebands carrier and total power.
The equation of an angle-modulated voltage is v = 10 sin (l08t + 3 sin 104,). What form of angle modulation is this? Calculate the carrier and modulating frequencies, the modulation index and deviation, and the power dissipated in a 100-ohm resistor.

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

A carrier signal given by cos 47(105)t volt is AM/SSB+ /SC modulated by the message signal given by 3 cos 6n(10³)t volt. ) Prove that the modulated signal ØSSB, (t) is (A cos 2nft), then find the value of A and f. e) Find ØssB, (f). ) Calculate sideband power and transmission efficiency.