A domestic pipe system is composed of different pipes with different elevations and diameters. Assuming no friction and no losses occur in our system and considering that the supply line has the pressure energy of 16 m, kinetic energy of 1 m, and potential energy of 1 m, determine which water pipe from the water supply line will have higher pressure energy: a) At the same elevation and the half diameter of pipe b) At the half elevation and the same diameter of pipe

A domestic pipe system is composed of different pipes with different elevations and diameters. Assuming no friction and no losses occur in our system and considering that the supply line has the pressure energy of 16 m, kinetic energy of 1 m, and potential energy of 1 m, determine which water pipe from the water supply line will have higher pressure energy: a) At the same elevation and the half diameter of pipe b) At the half elevation and the same diameter of pipe

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

B: The pump in Fig. Q3B increases the pressure in the water from 200 to 4000 kPa with a flow rate of 0.1 m³/s? The electric power of motor 275 kW. Determine the mechanical efficiency of the pump and overall efficiency pump/motor unit when the motor efficiency is 90 percent. Fig. Q3B 50 mm Pump 100 mm Water Motor
An oil refinery uses a Venturi tube to measure the flow rate of gasoline. The density of the gasoline isp = 7.10 x 102 kg/m³, the inlet and outlet tubes, respectively, have a radius of 2.36 cm and 1.18 cm, and the difference in input and output pressure is P, - P, = 1.20 kPa. P1 P2 (a) Find the speed (in m/s) of the gasoline as it leaves the hose. m/s (b) Find the fluid flow rate in cubic meters per second. m/s
Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 20 kW of useful mechanical power to the water. The free surface of the upper reservoir is 40+0 m higher than the surface of the lower reservoir. The flow rate of water is measured as 0.03 m3/s. (a) Draw EGL and HGL for the complete system b) Draw mechanical energy flow chart for the system
Water is being drained through a hole at the bottom of a tank at a velocity of 10 m/s. For a tank diameter of 1.18 m and a hole diameter of 5 cm, find the rate of change of the water level in the tank in m/hr.
R2 R, R3 A fan delivers air to a system as shown above where R1= 40 mm of water for a volume flow of 160 m3/min and R2=R3= 16.5 mm of water for a volume flow of 50 m3/min. The performance of fan is as follows: Fan volume 100 130 160 190 m3/min FTP, mm of 80 65 50 30 water Find volume of air handled by fan?
A closed vessel contains water up to a height of 2 m and over the water surface there is air having pressure 8.829 N/cm^2 above atmospher. At the bottom of the vessel there is an orifice of diameter of 15 cm. Find the rate of flow of water from orifice. Take Cd=0.60. answer (155.75 L/s)
The Water is flowing through a pipe having diameter 350 mm and 210 mm at the bottom and upper end respectively. The intensity of pressure at the bottom end is 25.85 N/cm? and pressure at the upper end is 11.6325 N/cm? & the rate of flow through the pipe is 40 lit/s. Draw a neat diagram and determine the following: 1.Velocity head at bottom of the pipe in m/s. 2. Velocity head at top of the pipe in m/s. 3. The difference in datum head between top & bottom in meter of water - 4. The difference of pressure head between bottom to top end in meter of water.- The velocity of flow of water at the bottom in m/s.
A closed vessel contains water up to a height of 2 m and over the water surface there is air having pressure 8.829 N/cm^2 above atmospher. At the bottom of the vessel there is an orifice of diameter of 15 cm. Find the rate of flow of water from orifice. Take Cd=0.60.
AP = 5 kPa Pump The driving force for fluid flow is the pressure difference, and a pump operates by raising the pressure of a fluid (by converting the mechanical shaft work to fiow energy). A gasoline pump is measured to .consume 7 kW of electric power when operating, If the pressure differential between the outlet and inlet of the pump is measuured to be 5 kPa and the changes in yelority and elevation are negligible, determine the maximu'n possible volume flow rate of gaseline.
4m A 4-meter-diameter cylindrical tank contains oil and water as shown in the figure. At the bottom of the tank is an orifice having a diameter of 0.1 meter with coefficient of contraction and coefficient of velocity equal to 0.62 and 0.98, respectively. Determine the following: 6m Oil, SG = 0.9 a. The rate of flow on the orifice (L/s). b. The time to remove water only at the tank (s). c. The time to drain all the liquids (s). 4m Water
Drinking water from a large bottle placed on high ground references Inside the Damacana with an on / off valve at the end a plastic hose is immersed. On/off valve of hose with diameter 3 mm the found tip is 80 cm below the ground. Water in Damascus (P = 1000 kg/m3) fill a cup with a volume of 0.2 L for the state that the level is 60 cm calculate the time required. Casualties are negligible. 60 CT 80 m Please choose one:
For the system shown in the Figure, Reservoir I has a water depth of 7 m and Reservoir 2 has a water depth of 8 m. The bottom of Reservoir 2 is at an etevation of 20 m above the bottom of Reservoir 1. The pump is required to deliver 400 1/s of water from Reservoir I to Reservoir 2. Given that the total energy loss in the system is 5 J/N, how much power must the pump deliver? Give your answer in kW to one decimal place. Reservoir 2 pump Reservoir 1 Power (kW) Round your answer to I decimal place