A hemispherical container, 26 inches in diameter, is filledwith a liquid at 20 ° C and weighed. The liquid weight isfound to be 1617 ounces. ( a ) What is the density of thefluid, in kg/m 3 ? ( b ) What fluid might this be? Assume standardgravity, g = 9.807 m/s 2 .

Q: A belt moves upward at velocity V, dragging a fi lm ofviscous liquid of thickness h , as in Fig. .…

A: (a) Since there are no other non-zero velocities along x and z directions, the momentum equation in…

Q: (b) Water flows from a large tank as shown in Figure Q3. Atmospheric pressure is 101 kPa (absolute)…

A:

Q: Using II-Theorem method to Express (n) in terms of dimensionless groups.Th iency (n) of a fan…

A:

Q: You have two identical cylindrical tanks. One is partially filled with water (p = 1.0 x 103 kg/m³)…

A:

Q: A Ping-Pong ball weighs 2.6 g and has a diameter of 3.8 cm.It can be supported by an air jet from a…

A: Consider the free body diagram of the ping-pong ball as shown below. For the ball to float in the…

Q: A two-dimensional Rankine half-body, 8 cm thick, isplaced in a water tunnel at 20°C. The water…

A: The cavitation bubbles start to form at the point of the vapor pressure of the fluid. The vapor…

Q: Under laminar conditions, the volume flow Q through asmall triangular-section pore of side length b…

A:

Q: We are given laboratory data, taken by Prof. Robert Kirchhoffand his students at the University of…

A: Writing the parameters in MLT system as follows,

Q: A hole is placed in the front of a cylinder to measure thestream velocity of sea-level fresh water.…

A: Assumptions Density of water = 1.936 slug/ft3 sea level pressure = 2117 lbf/ft2 The velocity at the…

Q: Here, a liquid's density is to be determined by a 1-cm diameter cylindrical hydrometer whose…

A:

Q: In compressible fluids, which is not assumed to simplify calculation  a. Steady flow b.…

A: Compressible fluids are the ones which can be compressed whose volume decreases and density…

Q: 4. A flat plate 200mm× 750mm slides on oil(µ = 0.85N · s/ m²) over a arge plane surface, What force…

A:

Q: An infinite plate is moved over a second plate on a layer of liquid as shown. For small gap width,…

A:

Q: Consider a large, helium-filled party balloon with a volume of 1.23 ft^3. The lifting force on the…

A:

Q: Base radius ro Oil 20 A solid cone of angle 104.8 degrees, base 15.2 cm, and density 2745 kg/m3 is…

A:

Q: SAE 10 oil at 20 ° C fl ows between parallel plates 8 mmapart, as in Fig. P4.86. A mercury…

A: Given Oil temperature = 20 C Pressure taps = 1 m Register = 6 cm = 0.06 m To find Flow rate of oil

Q: The belt in Fig. P1.52 moves at a steady velocity V andskims the top of a tank of oil of viscosity μ…

A: This numerical is based on the Dimensional Analysis area. Dimensional Analysis technique is widely…

Q: Liquid flows out of a hole in the bottom of a tank as in FinConsider the case in which the hole is…

A: Given, h2 = 2h1 For a free flowV=2ghV2=2ghsquare of velocity is proportional to…

Q: An important parameter in certain types of fluidflow problems when a free surface is present is the…

A: Froude number 'Fr' is defined as ratio of Inertia force (Fi) to the gravity force (Fg). Here it is…

Q: Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23…

A: The shape of streamlines will change with the direction of resultant velocity changes. For…

Q: A flat plate of area 2x10 cm is pulled with a speed of 0.5 m/s relative to another located at a…

A: Given       Area, A = 2 x 104 cm2   Velocity, v = 0.5 m/s Distance, y = 0.2 mm Find   Force…

Q: A smooth sphere of diameter d is dropped into a calm ocean. Data: d = 20 cm; Sphere material's…

A: Given that, Diameter of sphere, d=20 cm,Density of sphere, ρsm=3000 kg/m3Density of sea water,…

Q: Would a wooden cylinder (s = 0.61) 660mm in diameter and 1.3m long be stable if placed vetically in…

A:

Q: Suppose that the U-tube of Fig.  is rotated about axisDC . If the fl uid is water at 122 ° F and…

A: Draw the schematic diagram for the above problem.

Q: A 7-cm-diameter solid aluminum ball (SG = 2.7) and asolid brass ball (SG = 8.5) balance nicely when…

A: Given data Sal=2.7Sb=8.5Dal=0.07 m

Q: Q1) Under laminar conditions, the volume flow rate Q through a small triangular-section pore of side…

A:

Q: When tested in water at 20°C (density of 998 kg/m3 and viscosity of 0.001 kg/m.s) flowing at 2 m/s,…

A: Given,

Q: A vortex ring is travelling from a less dense environment p, to denser medium p2 so that P2 > P1. If…

A: Give, Vortex ring is travelling from less density to high density, i.e., ρ2>ρ1 The size of the…

Q: Example: A Styrofoam cylinder, filled with water, sits on a table. You then poke a small hole…

A:

Q: Two large surfaces with a gap of 34 mm width were filled with oil having a kinematic viscosity of…

A:

Q: Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23…

A: Given: An inviscid and incompressible flow ρ=1.23 kg/m3P=1.01×105N/m2 To find: if velocity V∞ is…

Q: The pressure coefficient is defined by the ratio between the static pressure difference and the…

A:

Q: The density of a fluid is given by the empirical equation: ? = 70.5exp(8.27×10^−7 ?), where ? is…

A:

Q: . What force in Newton is required to drag the block at 3 m/s,

A: Need to find Force ( drag)

Q: In Falling ball Viscometer, the density of the ball is p=7746.8 kg/m and its radius is 4 mm, the…

A: in a falling ball viscometer there is an equilibrium achieved between Gravitational pull, buouancy…

Q: If the white fluid is air, the blue fluid is water, the red fluid is oil (S = 0.86), and the green…

A:

Q: A solid cone of angle 20, base rɔ, and density Pc 1s rotating with initial angular velocity wo…

A:

Q: 1. A solid cone of angle 20, base ro, and density p. is rotating with initial angular velocity mo…

A: Consider an elementary ring of radius r at a distance x from the apex. let r + dr be the radius at x…

Q: Consider a rapidly rotating (ie, in near geostrophic balance) Boussineq fluid on the f plane. A)…

A: Dependent upon the limitation on p communicated is the arrangement . It shows that the geostrophic…

Q: A compressed-air tank holds 5 ft 3 of air at 120 lbf/in 2“gage,” that is, above atmospheric…

A: Given: The atmospheric pressure is Patm=1 atm. The gage pressure is Pgage=120 lbf/in2. The volume of…

Q: Les m. The Q3/A dash pot is 0.2 m in diameter and 0.25 m long and it slides down in a vertical…

A:

Q: 1. The Stokes-Oseen formula for drag force Fon a sphere of diameter D in a fluid stream of low…

A: The dimensions of the drag force is as follows: F=kg·ms2F=MLT2F=MLT-2 The dimensions of 3πμDV is as…

Q: Directions: Solve the following problems completely, and make a detailed solution. Any incomplete…

A:

Q: A sample of powdered zinc oxide, density 5.60 g/cm 3 , is allowed to settle under the acceleration…

A: Given Data⇒ Sample - Powder zinc oxide The density of powder zinc oxide ρ=5.60gmcm3 Acceleration of…

Q: Derive an expression for the capillary height change h for afluid of surface tension Y and contact…

A: Find the weight of the liquid of h in the tube by using the below expression.

Q: A passenger train, Keretapi Tanah Melayu (KTM) moves from A, to B at constant speed of 60 m/s. The…

A: Write the given data with suitable variables. V=60 m/sL=15 mρ=1.164 kg/m3v=1.6×10-5 m2/s

Q: A diver 50 m deep in 10°C fresh water exhales a 1.0-cmdiameter bubble. What is the bubble’s diameter…

A: From the given information, Surface pressure : Therefore,

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.