a magnetic circuit has a length L=15cm cross-section area A=20cm and relativity permeability 1200.A current I flows in a coil with uniform flux is 0.05wb and the number of the turn is N=248. calculate the current I

a magnetic circuit has a length L=15cm cross-section area A=20cm and relativity permeability 1200.A current I flows in a coil with uniform flux is 0.05wb and the number of the turn is N=248. calculate the current I

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Related questions

Q: For the circuit shown above, what is the magnitude of the load impedance Z₁ that will result in…

A: The circuit diagram is shown below, Where,R=25 ΩXC=23 Ω

Q: Find the values of R₁, R2, R3, and R4, if V2 = R₁ 0.625 A 40 Ω + 50V- R2₂. Element 50 V source…

Q: 21is 300i 700 Ω {R a b

A: Introduction The Norton equivalent circuit is a simplified circuit that represents a complex circuit…

Q: 1. For the circuits shown below, if A=∞, Calculate a) The overall input resistance, Rin b) The…

A: Introduction Voltage gain is the measure of how much an amplifier increases the amplitude of an…

Q: 7) (−3+12i)(−6-3i)= 8) 9) 1+2i -6-31 3+ 2i -6-31

Q: 9. Given the following circuit, find Ix. – 20 mA από το 3 ΚΩ 41x 4 mA 6 ΚΩ 10 ΚΩ

A: In this question we need to find the current Ix shown in the circuit

Q: For the circuit given below, find the Thèvenin equivalent at terminals a- b, where R = 8 2. Please…

Q: Problem 2: For the circuit shown below: Use the nodal-analysis method and the supernode concept to…

Q: A 100-hp open drip-proof de motor rated at 500 V and 1750 rpm has the following parameters at rated…

A: Given : 100 hp , V = 500 V , N = 1750 rpmRated field current = 153.71 La = 1.83 mHRa = 0.088 ΩKb =…

Q: The maximum clock frequency in MHz of a 4-stage ripple counter, utilizing flipflops, with each…

A: We need to find out frequency for given circuit.

Q: [CLO-4] A lossless transmission line of length 50 cm with L-10 pH/m C= 40 pF /m is operated at 30…

Q: QUESTION 12 For the following voltage and current phasors, calculate the real power in Watts. V =…

Q: When it comes to the installation of cable systems as well as their ongoing maintenance, why is it…

A: To explain: When it comes to the installation of cable systems as well as their ongoing maintenance,…

Q: what will happen to frequency if load increases ?

A: Given: What will happen to frequency if load increases?

Q: 6. Use this information to answer Question 6-8: Consider a one-sided step pn junction made of…

A: Given,In a one-sided step pn junction made of silicon,the doping density in the n-side is much…

Q: Question #2: Answer the following questions. Use DTFT tables. (a) Compute the DTFT of (b) Compute…

A: Note: Since you have posted multiple question we will provide solution to the first question as per…

Q: Given P(42, 11, 8) in rectangular coordinate system, what is r in spherical coordinates of P?…

Q: ell 7.5 mH 12 92 R ww Z For the circuit shown above, what is the maximum average power that can be…

Q: 3. Some GPS receivers use 1 bit ADCs (Analog-to-digital Converters) to sample and quantize the…

A: Given: GPS receivers use 1-bit ADCs. The output of the ADC is simply 2 quantization levels.

Q: R(s) 1/s -5 1/s -2 1/s -3 x1 x2 -10 -20 -30 Y(s)

Q: What is v(t) equal to for t> 0 if C=0.1 F? 4u(t) A 6523 THE Ov(t) = 24-25e¹ (1+0.5t) [V] Ov(t)=-et…

A: In this question we need to find the voltage v(t) for t>0

Q: large flat roof is covered with PV-modules. The system is expected to annually deliver 50 000…

Q: 100 V + 千 560 0

Q: For the circuit given below, find the Thèvenin equivalent at terminals a-b, where R = 30. Please…

Q: Q7) Draw a logic diagram of your own provided that it has at least three inputs and three gates…

A: Given: Draw a logic diagram of your own provided that it has at least three inputs and three gates…

Q: For the circuits in Fig. 14.81, find the resonant frequency, the quality factor Q, and the bandwidth…

A: Given: The given figure is, To find the resonant frequency, the quality factor Q, and the bandwidth…

Q: Filter functions like as sed and awk are often used when it comes to formatting data contained…

A: We need to tell whether the given statement is correct or wrong.

Q: 4. Calculate the voltage v, conductance G and the power P. 6 MA ↑ 18 ка Iki ≤ v

Q: 4. Given the following circuit, solve for Io and V. Must use Current Divider. 12.4 ΚΩΤ 10 www 5ΚΩ §…

A: Given:

Q: Consider the following circuit with R 500 2, Xc= 300 2. The supply voltage is SV. 150 Ω, Χ, Find the…

A: The RLC circuit diagram is shown below, Where,R=150 Ω.XL=500 Ω.XC=300 Ω.V=5 V.

Q: A shunt motor on a 240- V line has an armature current of 75 A. If the field- circuit resistance is…

A: Introduction A shunt motor is a type of direct current (DC) motor that has a field winding in…

Q: Find the inductance of a solenoid 50 cm long and 4 cm diameter wound with 2000 turns of wire

A: Given- The length of the solenoid, l = 50 cm Diameter, d = 4 cm Radius, r = 2 cm Total number of…

Q: Solve for the Voltage, current, and power associated with resistor R4.

Q: Example 15. Determine the output level for the positive logic AND gate of Figure 17. (1) E₁ = 10 Vo…

A: Given:

Q: QUESTION 5 Find the magnetic force when a charge 3.5C with flux density of 4 units is having a…

A: The magnetic force on a charge moving in a magnetic field is given by the formula: F = q(v x B)…

Q: 3. Draw the output voltage waveform for each circuit in Figure 2 and include the voltage values.

A: The required output waveform can be drawn based on the condition of diode and the drop across the…

Q: Are there poles on the imaginary axis for G(s)? A) G(s) = (s+3)/(s(s-1)) B) G(s) =…

Q: Problem 2 Draw a Nyquist plot of the following G(s) and examine the stability. G(s) = 1 s(s² +0.8s +…

A: In this question we need to check the stability of the given system by using Nyquist plot.

Q: Solve for the voltage, current, and power associated with R4 using Ohms Law and Kirchoffs Laws.

Q: Given points P(3, -23, 46) and Q(31, 40, -49), what is the distance between P and Q? (Use 4 decimal…

A: Here we have calculated distance between P and Q

Q: 3. Find the Fourier transform and obtain the magnitude and phase responses of the following signals:…

A: Given the signal , a) xt=eat , for 0≤t≤T0, otherwise b) xt=tζ, -ζ≤t≤ζ0, otherwise

Q: QA IRIJ, Iz (↑) + R₁=1K₁2 7, IP Vy=0.6V Vr=0.6V 0.2v Plot FR₁ Vo ; ID II for 0 to 2m A

Q: Plot the bode plot of the system described with the transfer function below 10(s² +0.4s + 1 s(s² +…

A: Solution - The given transfer function is as follows,Gs=10s2+0.4s+1ss2+0.8s+9.

Q: 1. Given the following circuit, solve for Vs. Must use Voltage Divider. Vs 8 ΚΩ 48 ΚΩ 0.2 mA 96 ΚΩ

Q: Exercise 7: The frequency response of this filter is x[n] If the input signal is FIR FILTER H (6)…

A: Given the Hω^=cos12ω^e-jω^ xn=7+2cos0.5πn+π for -∞<n<+∞

Q: A balanced Wheatstone bridge ABCD has the following arm resistances: RAB = 1 kn + 2.1%; RBC = 10022…

Q: 5. Given the bit pattern 0110, encode this data using ASK, BFSK, BPSK. ASK BFSK BPSK 0 1 1 1 1 1 1 1…

A: Given data Bit pattern=0110 To find out We have to encode this data using ASK, BFSK and BPSK.

Q: How would you calculate the Spacing between transmission lines?

A: The spacing between transmission lines is typically determined by considering several factors such…

Q: Q3/ Design maximum size multiplexer by using the following (Note that all multiplexers and all…

A: According to the question, we need to design maximum size of multiplexer with the help of given…

Q: ig ( ↑ R 1000 Ω m 160 nF 100 mH For the circuit shown above, what is the average power supplied by…

A: In this question We need to determine the average power supplied by source. We know Power P= I2 R…

Question

a magnetic circuit has a length L=15cm cross-section
area A=20cm and relativity permeability 1200.A
current I flows in a coil with uniform flux is 0.05wb
and the number of the turn is N=248. calculate the
current I

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What's the rise time for this system with its closed-loop poles as shown? 14 -6 -4 12 -j6 Select one: a. 0.607 sec b. 3.14 sec C. 1.80 sec d. 0.254 seC e. 0.554 sec
circut for the core. (₁ For the ferromagnetic core shown in the gure below draw the magnetic The magnitudes of the reluctances are not important but clearly indicate on your circuit every reluctance which should be calculated for the given core. 10 15 = 0.5A d DNI 15 0.03 N2 1₂ = 0.1A 9
The rotor in a certain electric motor is a flat, rectangular coil with 88 turns of wire and dimensions 2.50 cm by 4.00 cm. The rotor rotates in a uniform magnetic field of 0.800 T. When the plane of the rotor is perpendicular to the direction of the magnetic field, it carries a current of 9.9 mA. In this orientation, the magnetic moment of the rotor is directed opposite the magnetic field. The rotor then turns through one-half revolution. This process is repeated to cause the rotor to turn steadily at 3600 rev/min. (a) Find the maximum torque acting on the rotor. Tmax= N-m (b) Find the peak power output of the motor. Pmax = W (c) Determine the amount of work performed by the magnetic field on the rotor in every full revolution. W = (d) What is the average power of the motor? Pavg = W
in lab winding schemes, The-2 induced emf in a coil is emf in .coil for wave winding a) greater than b) smaller than O c) equal to O
A coil that consists of 450 windings is wound around a Bakelite ring. The mean diameter of the ring is 100 mm and the diameter of the Bakelite core is 20 mm.The current through the coil is 3A. Determine the field strength
For the following magnetic circuit, the flux density is 1 T and magnetic field intensity is 700 At/m. The material of the core is d C cast iron cast steel sheet steel None of the above
arcing c
The conversion of an AC to DC Source is by using the A) Commulator B) None of these C Round ring D) Slip ring
The primary and secondary coils of a transformer each have an inductance of 200 x 10-6 H. The mutual inductance between the windings is 4 x 10-6 H. What percentage of the flux from one coil reaches the other?
The rotor winding of the induction motor at no load condition is equivalent to connected to an inductive load short circuited connected to a resistive load O open circuited
Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
Q1- The given ferromagnetic core relative permeability is 800. Determine the total reluctance of the core. 35 cm 10 cm 20 cm 5 cm 15 cm 45 cm 15 cm 15 cm 10 cm