A missile is fired and a radar on the ground shows that the missile follows the law of movement · (v₁²³ +25° r(t) = vt² arctan Answer what is proposed below: (A)) Find the speed, acceleration and shaking of the missile. (B) Find the curvature and torsion of the missile trajectory in t = 2 (C) Find the mobile frame (T, N, B) in t = 1. (D) What is the length of the path traveled by the missile from its launch in t= 0 to its impact in t=10

A missile is fired and a radar on the ground shows that the missile follows the law of movement · (v₁²³ +25° r(t) = vt² arctan Answer what is proposed below: (A)) Find the speed, acceleration and shaking of the missile. (B) Find the curvature and torsion of the missile trajectory in t = 2 (C) Find the mobile frame (T, N, B) in t = 1. (D) What is the length of the path traveled by the missile from its launch in t= 0 to its impact in t=10

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A steel ball is tethered to the end of a cable. The ball is attached to a spinning axle that causes the ball and cable to rotate in a vertical circle counter-clockwise. The ball moves in a circle of radius R=.50 m centered at a height of 5 m above a flat surface. The rate of rotation increases very slowly until the cable snaps. the cable snaps when ac=20 m/s2. (x=0 at center of circle) a) how long does it take for the ball to hit the ground after the cable snaps? b) Relative to the position of the axle over the floor, what is the horizontal displacement of the ball( magnitude and direction)? c) What is the magnitude and direction of the velocity with which the ball hits the ground?
A car is modeled as shown in Figure. Derive the equations of motion and find matrix M, C, and K. Mass = M, mass moment of inertia = JG .000 m1 k₂ F1 1 k2 000 k₁ k₁ m2 F2, X2 ell
A rocket of mass 2.5 × 10°kg , launched with speed 3004 requires a force of 1.5 x 10*N to give it a velocity 500". Using Newton's second law, model this problem and solve the differential equation of the model to find a. How far the rocket has travelled after 10 seconds? b. How much work is done by the rocket after 20 seconds? (work = force x distance) c. How much power is consumed by the rocket after 20 seconds? (power = work/time) d. The change in the kinetic energy of the rocket after 40 seconds?
Az Ay α = 0 A || y Eat Ice Cream X kg An advertisement can be modelled as a thin plate with uniform density distribution, p = 80 If the m² supporting wire at B suddenly snaps, what is the angular acceleration of the advertisement and the reaction forces at A at that instant? The sign has a width = 2 m and a height h = 1.5 m. Force directions should match the x and y directions on the image XN N rad W CW B h UBC Engineering
Consider the system shown in the following figure, which is pivoted at point O. Suppose the system is moving in a horizontal plane. Assume that a0.4 m,b-1m M=2 kg the mass of the bar m 4 kg. k10 N/m, c 93 kg/s and F(t)= F6 (t) N where F = 3Ns Assume zero initial conditions and the moment of inertia of the bar about point O to be Determine the mnaximum tip response amplitude in mm. ww- Rigid bar M F() 6154 mm 13.90 mm 8.93 mm 83.37 mm 19.85 mm O00 00
The figure shows air track setup to verify Newton's law. The distance between the two gates is X = 60 cm. The flag length L=1.5 cm. The kinematic acceleration (ak) is: * 25ms 15ms gate 1 gate 2 puley L=1.5cm X=60cm ******** Gider bangng mass O 6.17 0.5333 5 O 4.71 O 2.9178
A solid bar of mass m and length L stands vertically on a frictionless table and is then released to fall down. The moment of inertia about the center of mass is Ic = mL²/12. At the moment when the top end B just reaches the ground (0-0), (a) what are the angular velocity and angular acceleration? (b) what is the center-of-mass acceleration? (c) what is the normal force of the ground to end D? Hint: It may be helpful to find out the instant rotation axis. В m. L D
As shown in the figure. A plot of potential energy U versus position x of a 2 kg particle that can move along x-axis. The graph has these values U_A=9J, U_C=20J and U_D=24J. The particle is released at position x=5 m with kinetic energy 4 J where the potential energy is U_B=12 j. What is the kinetic energy of the particle at x =3.5 m. Upt ... Uc UAF-- 4 6 7 x (m) A) 8J B none of them C 7J D 7.5J
Asap
Given that the slot (for the cord) in the cylinder with 17.6 kg in the figure below has a negligible effect on Ic, find the time required for C to move 3.7 m down the incline if 0 = 55°. R = 1.4 m,r = 0.6 m, and u = 0.11. Cord R Figure is from "Engineering Mechanic An Introduction to Dynamics", McGill and King.
2of7: A 4kg circular ring, shown in the figure, rolls down the inclined plane without slipping with an initial angular velocity of 10 rad/s @ s=0. Find the translational and angular velocity of the ring after it has traveled the distance s = 2m. µs = 0.25, µk = 0.2. For a ring: IG = mr2. G 0.25m i Ref f 30° O a. v=4m/s, w=4 rad/s O b. v=16m/s, w=4 rad/s O . v=4m/s, w=16 rad/s O d. v=16m/s, w=16 rad/s
The rod OA in Fig.1 rotates counterclockwise, its angular position (0) varies with time (t) according to Eq.1. Two pin-connected slider blocks, located at B, move freely on OA and the curved rod whose shape is a limacon described by Eq.2 14 ) exp(1 t+2 t°) 3 (rad) (1) where t is in seconds. r = 8 – 15 cos(0) (тm) (2) B. r = 100 (2 – cos 0) Figure 1: Prob.1 1. Derive an expression for 0(t) as a function to time. 2. Derive an expression for ŕ(t) as a function to time. 3. Derive an expression for 0(t) as a function to time. 4. Derive an expression for ï(t) as a function to time.