A resistor of resistance R = 15 MN is connected in series to a capacitor or capacitance %3D C = 19 µF and power supply of emf E = 5.0 V and negligible internal resistance. How %3D %3D long does it for the capacitor to reach a voltage V. = 1.1? Express your answer in seconds with 2 decimal places. Do not write the unit.

A resistor of resistance R = 15 MN is connected in series to a capacitor or capacitance %3D C = 19 µF and power supply of emf E = 5.0 V and negligible internal resistance. How %3D %3D long does it for the capacitor to reach a voltage V. = 1.1? Express your answer in seconds with 2 decimal places. Do not write the unit.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
4. In what form is the energy of a capacitor stored?
A)For the inductive element of Figure 2 , the voltage and current in phasor form is B)the value of impedance and capacitance for capacitor in figure 2 is
For the series-parallel inductor circuit shown in figure B19, answer the following questions. 2mH 4mH SmH 3.5mH 8mH 8mH n2mH Figure B19 Determine the inductance, L value. If E is the energy stored in inductor for current, I. Calculate the energy if the current value is increased twice.
What will happen to the value of the current if the capacitance will be increased or decreased? Explain further
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor?
What is the maximum voltage come across in capacitance
A 100uf capacitor and a3.6kohm are connected in series. How long will it take for the capacitor to change its charge completely?