A solenoid with an inductance of 0.25 H and a resistance of 100 is connected to a 120-V 60-Hz source. The current is: Please check the closest answer that applies. X L 120 V 60 Hz R. O0.226 z-16.3° A O 0.224 2-312 A

A solenoid with an inductance of 0.25 H and a resistance of 100 is connected to a 120-V 60-Hz source. The current is: Please check the closest answer that applies. X L 120 V 60 Hz R. O0.226 z-16.3° A O 0.224 2-312 A

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: Base on the image, Calculate the power dissipated by each resistor.

A: Power dissipated by resistor =(voltage across the resistor)2/resistance).

Q: 2. process that we discussed in the class, to analyze the following circuit, show all the steps with...

Q: A disk with radius 0.1m is oriented with its normal vector at an angle of 30° to uniform electric fi...

Q: Which gate does the following circuit represent? + V A Surce is study ared va В - A. XOR B. XNOR C. ...

A: Given, Implementation of logic gates using CMOS . The Answer for the above question is option D .i e...

Q: Simplify the given Boolean Expressions below using K-Map. 1. F(X,Y,Z) = ∑(0,1,3,5,6,7) 2. F(A,B,C...

Q: can bias a diode forward or reverse. Soon: a) Directly polarizing means connecting the positive of ...

Q: What is the dimensioning system shown in the figure below? 1.31- 67 - .31 51

A: Unidirectional dimensioning system The dimensioning system used in given figure is unidirectional d...

Q: 0, 5, 10, 30, 50,

A: Answer AVE means Average arithmetic mean

Q: Using branch current method, solve

A: This question belongs to circuit theory . It is based on the calculation of current in the circuit b...

Q: The voltage and current at the terminals of an auto- mobile battery during a charge cycle are shown ...

Q: Explain in broad the theory about Common Emitter Amplifier

A: A common emitter amplifier is the type of BJT configuration in which there are three terminal that a...

Q: Q 2 A 3-ph,4 –pole, 50 Hz synchronous machine has the following data as given below: Kw of Rotor =0....

A: The data for a synchronous machine is given below,Kw = 0.976Air gap = 1.5mmMean air gap diameter = 2...

Q: Find the voltages using nodal analysis

A: Given circuit :

Q: A single phase half wave rectifier is used to supply power to a load of impedance 12 from 230 V, 50 ...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: What does modulation/demodulation refer to and how analogue signals can be used/modified for the pur...

A: Data communication- The process of transferring information from one computer to another is known as...

Q: shows a BCD counter that produces a four-bit output representing the BCD code for the number of puls...

A: BCD - counter that counts from (0000)2 to (1001)2 a) xa = high when BCD counter value = 2,3 or 9 b)...

Q: Two resistors, R1 = 100 N and R2 = 200 Q are connected in series, if the voltage across R2 is 20 V, ...

A: Given Data Resistance R1=100ohms Resistance R2=200ohms Voltage drop across R2=20volts Current=voltag...

Q: block diagram reduction method.

Q: three-phase load draws 250 kW at a power factor of 0 707 lagging from a 440 V line In parallel with ...

A: Power factor: It tells how much active power is utilized from the apparent power.

Q: o18 V 4.7 k2 R1 Ic oVc = 12 VB o VE 5.6 k2 1.2 kM 1.60 V

Q: In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of B is. .......... а. 100 О. 50 O c. about...

Q: +9V(Vcc) Rc 2.5k Ic + VCE 50k RE 4.3k -9V(VeE) 1.93mA, 5.17V 2.93mA, 4.17V O 1.93mA, 4.17V O 2.93mA,...

Q: 7.4.8 Circuit analysis. Give the number of switches in each of the following. a. Register bit b. Mem...

A: Note: Considering a switch that has 2 states - ON/OFF a. The function of the register is to hold inf...

Q: Problem: Consider the following canonical form of a Boolean function F(W,X,Y,Z) F(W, X,Y,Z)=E (1,3,4...

Q: A 2,500 kVA, three-phase, 60 Hz, 6.6 kV wye-connected alternator has a field resistance of 0.45 ohm ...

Q: 1. Calculate the current for a 3v battery and a 1.5 kilo ohm resistor. Then, calculate the silicon v...

Q: 30.determine the values of VCB and IB for this circuit.

Q: d) The accuracy of measurement. e) Repeat the aboveif a voltmeter has a resistance of 2500k2. f) Sta...

Q: Suppose you are an electronic circuit designer. How you can use the center-taped step down transform...

A: Center Tapped Step down Transformer- In this type of transformer, a wire is connected exactly at the...

Q: A lightbulb marked "75 W [at] 120 V" is screwed into a socket at one end of a long extension cord, i...

Q: What is the relationship between the clipping level and the DC voltage?

A: Clipping is a type of distortion of waveform which occurs whenever the amplifier is over-driven &am...

Q: A bipolar junction transistor (BJT) network is shown in FIGURE Q1. Vcc 12 V 2.2 k2 220 ka 10 µF Z. 1...

A: Given: A BJT network is shown below as: To find: (a) What will be the impact on input impedance, Zi...

Q: Determine the base voltage VB in the circuit. * F15 Vcc R 22 k2 RC 1.5 k2 B = 150, R2 4.7 k2 SRE 680...

A: Base Voltage: It is the value of voltage that is connected to the base terminal of the BJT. It is de...

Q: Find the voltage in the z axis of a structure centered in the origin. The electric field of this str...

A: The solution is given below

Q: Find the Thevenin equivalent circuit with respect to V. Z, = 40 + j202 Z3 = 15290°N %3D V = 10430°V ...

Q: (a) Minimise the following logic function using the Karnaugh maps method: f(x, y, z) = x'y' z' +x'y+...

Q: Calculate the Fourier transform of the 'off-on-off' pulse f(t) defined by

Q: ollutant. (Use 4 significant figures.) * Each sample of water has a 10% chance of containing a parti...

A: Here,The probability of containing the particular organic pollutant is,P=10%Samples, n=18Pollutant, ...

Q: An aluminium wire 7.5 m long is connected in a parallel with a copper wire 6 m long. When a current ...

A: 4

Q: 1) The true value of a current through a resistor is 10A Themeasurement finds a value of 9.95A, dete...

A: As per guidelines we are supposed to answer only first question when multiple questions are given. S...

Q: Given the following logical circuit

Q: A step up auto transformer has its winding consisting of two portions one with 68 turns and the othe...

A: This question belongs to electrical machine . It is based on the concept of auto transformer . Probl...

Q: From the figure, find the average power (Average power) supplied to the elements. When the current s...

Q: An electric stove with four burners and an oven is used in preparing a meal as follows. Burner 1: 40...

A: The solution is given below

Q: A certain appliance uses 350 W. If it is allowed to run continuously for 24 hrs, how many kilowatt-h...

Q: Show how you solve the equation

A: The given circuit diagram is shown below,

Q: The atomic radius of a BCC crystal if a is the sides of the cube is? Select one: a. a b. a/2 c.

A: In this question we will write the atomic radius of a BCC crystal if a is the sides of the cube is.....

Q: ) Given a transmission line with a characteristic impedance of Za = 50 Ohms, determine the character...

Q: Describe fabrication steps of CMOS inverter

A: CMOS Technology is used as it dissipates less power. Fabrication steps of CMOS inverter are- Choos...

Q: Q3/ A- Design a logic circuit using only NOR gates to implement: F(A,B,C)= (A+B+C)(A+B+C)?

A: The given boolean function is shown below: F(A,B,C)=(A+B+C)(A+B+C)

Concept explainers

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).

Question

100%

A solenoid with an inductance of 0.25 H and a resistance of 100 Q is connected to a
120-V 60-Hz source. The current is: Please check the closest answer that applies.
X
L
120 V
60 Hz
O0.226 2-16.3° A
O0.224 2-31.2° A
LO

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
Value of series impedance if inductance is 4mH , resistance is 40 ohm and frequency is 50 Hz.
Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
Ohmic components have a V-I curve O Non-linear VI curve. Parabolic VI curve. Sinusoidal VI curve. Straight line VI curve.
Q4. Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH Figure Q4 reee L3 6.6 mH L4 2.8 mH rele L5 7 mH
QUESTION 3 An inductor and a 330 ohm resistor are connected in series with a function generator. The current is 89.8mA RMS 5kHz. The reactive power is 3.04 var. Find the value of the inductance. O 12mH O 24mH O 6mH O 18mH
Problem 5 Find the equivalent inductance Leg for the network shown below. 72 mH oooo Leg 49 mH elle elle 313 mH elle 64 mH elle 80 mH