A solid sphere (M = 5.0 kg and R = 60 cm ) is rolling down an inclined surface with a height of 2.0 meters and an inclined angle of 25 degrees. 15. find the linear acceleration of the sphere, in m/sec². a. 2.48 b. 2.76 d. 2.96 c. 4.14 16. for the sphere to make pure rotation, find the magnitude of the static frictional coefficient us =? a. 0.466 b. 0.133 c. 0.187 d. 0.155 0 h ↓

A solid sphere (M = 5.0 kg and R = 60 cm ) is rolling down an inclined surface with a height of 2.0 meters and an inclined angle of 25 degrees. 15. find the linear acceleration of the sphere, in m/sec². a. 2.48 b. 2.76 d. 2.96 c. 4.14 16. for the sphere to make pure rotation, find the magnitude of the static frictional coefficient us =? a. 0.466 b. 0.133 c. 0.187 d. 0.155 0 h ↓

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A wheel with radius 0.465 m0.465 m rotates 5.035.03 times every second. Find the period ?T of this motion. What is the tangential speed ?v of a wad of chewing gum stuck to the rim of the wheel?
A centrifuge rotor with moment of inertia 2.48 is rotating with constant angular velocity 3.07. What is its change in angle, in radians, after 1.76 seconds? All quantities are given in SI units and the answer should be given as a positive number in Sl units. Only type a number into the answer box, do not type in units.
An engine flywheel initially rotates counterclockwise at 5.93 rotations/s. Then, during 21.3 s, its rotation rate changes to 2.27 rotations/s clockwise. Find the flywheel's average angular acceleration (including its sign) in radians per second squared. Define counterclockwise rotation as positive. average angular acceleration?
6.3 A (solid) spool of mass M and radius R is supported by an axis about which it can rotate freely. A piece of thread is rolled around the spool, and a mass m = (where B is some positive number) tied to the end of the thread. What will be the mass m's speed v after it has descended a distance h, starting from rest? Express your result in terms of g, h and B. = BM M
An optical disk drive in your computer is spinning at 10,000 rpm (1045 rad/s). It decelerates to a rest in 0.42 s. a. Find the angular acceleration. b. If the disk is 0.115 m in diameter, what is the magnitude of the tangential acceleration at a point 1/2 of the way out from the center?
17. A wheel of mass M and radius R is projected along a horizontal surface with an initial linear velocity Vo and an initial angular velocity wo as shown in Fig. 1.150, so it starts sliding along the surface (wo tends to produce Fig. 1.150.
A typical hard disk in a desktop computer is a uniformly solid, 400 gram disk 3.5 inches in diameter, and takes 70 milliseconds to spin from rest up to a frequency of 7200 revolutions per minute (r.p.m.). Problem 2.1. What is the period of the disk in seconds when it’s at its final spinning rate? Problem 2.2. What is its angular speed in rad/s when it’s at its final spinning rate? Problem 2.3. Assuming it is constant throughout this spin-up process, what is the angular acceleration of the disk in rad/s2?
Consider an annular disk rolling down an inclined plane. The annular disk has mass 154 [g], inner radius 8.00 [cm] and outer radius 12.0 [cm]. The inclined plane has a slope that forms an angle of 44.6° with the ground. A. Suppose that the coefficient of static friction ?s is large enough so that the annular disk rolls without slipping. What is the magnitude of the translation acceleration felt by the annular disk's center of mass in the direction parallel to the slope? B. What is the minimum value that the coefficient of static friction ?s must take so that the annular disk rolls without slipping?
An electric fan is turned off, and its angular velocity decreases uniformly from 550 rev/min to 200 rev/min in 3.00 s. 1. Find the angular acceleration in rad/s2. 2. For the fan in the previous question, find the number of revolutions made in the 3.00 s interval.
A car tire is 60.0 cm in diameter. The car is traveling at a speed of 24.0 m/s.Part A: What is the tire's rotation frequency, in rpm? Part B: What is the speed of a point at the top edge of the tire?Express your answer twith the appropriate units. Part C:What is the speed of a point at the bottom edge of the tire?Express your answer with the appropriate units.
A new car is tested on a 270-mm-diameter track. If the car speeds up at a steady 1.3 m/s2m/s2 , how long after starting is the magnitude of its centripetal acceleration equal to the tangential acceleration? Express your answer to two significant figures and include the appropriate units. the anwers is not 0.32 14 14.4
The tips of the blades of the Chinook helicopter lie on a circle of diameter of 18.29 meters. What is the airspeed v of the tip of the blades when they are rotating at 225 rpm? Express your answer in meters per second to three significant figures. Consider the part of a blade that is 4.00 meters from the central hub. What is the velocity v of this part when the blades are rotating at 225 rpm? Express your answer in meters per second to two significant digits.