Answered: a) The motor slip b) The induced torque…

a) The motor slip b) The induced torque in the motor c) The operating speed of the motor if the torque is increased by 150%.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 13RQ: A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is...

See similar textbooks

Related questions

Q: Question 3-) Let z(t) = sin(3at + 0.3) (a) Find the minimum period for z(t). (b) Find the fourier…

A: It is given that: zt=sin3πt+0.3

Q: List the three factors which limits the capability of the transmission system to transfer power…

A: The power transfer capability: It is the capability of the transmission line to transfer the active…

Q: S.62) The 8085-programming manual says that it takes seven T states to fetch and execute the MOV…

A: Given data: The system clock frequency, fclk=2.5 MHz Number of T states = 7

Q: *2. Using superposition, determine the current I, for each network of Fig. 18.110. R IL 30 E = 10 V…

A: In this question, We need to determine the current IL using the super position theorems?

Q: An electric duct heater has a capacity ranging from 0 to 10 kW. The proportional controller signal…

A: Gain: It is the ratio of the amount of the change in the output to the measured variable change that…

Q: Q5:- Find Vau ☆ Vms Um. Vavz o.637 Um Vrms = 0-707 Um

Q: 2- For the circuit in procedure, apply the Thevenin's theorem tocalculate theoretically the current…

Q: Example: Simplify y = ln; Vz

A: The solution is given below

Q: Example 7.12 An AM transmitter has a carrier power of 1 kW at a carrier frequency of 10 MHz. It…

Q: ample 15: Locate the center of mass of the cket-and-shaft combination. The vertical face is 50 de…

A: Solution- The above figure can be divided into 5 parts- Let the triangular shape will be taken as…

Q: In a unity feedback control system with G(s) : 4 when subjected to unit step input, it is required…

Q: O Discussion 1- What is the condition under which the superposition theorem can be applied 2-…

A: We need to state that the condition under which superposition theorem can be applied.

Q: Q.3)) Design a synchronous 3-bit twisted ring counter with illegal state recovery circuit. Draw a…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A 3 phase 6 pole star connected induction machine operates from a 120V (phase voltage) and 50 Hz…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: 3 A student creates a parallel circuit that has three branches. The student places a resistor on…

Q: Ez=+18 Find Ro-5.2 エVeN、ニー Rus6r (Ve)

A: From the figure V1 = E2 -E1 V1 = 18-(-6) V1=24volts

Q: 11. Given: P(-1, -1, 2) what is o in cylindrical coordinate P. divergenceless system? Q. cos e

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: valuate the stability of the following system by determining the poles: :) = -2 +

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: raises a (10 kg) joist atL equilibrium state of length (4 m) the rope and the reaction at A. 25…

A: Solution- AG = ABcos45 = 4cos45 = 2.83 mAZ= QD =AG2 = 1.414 mBD =…

Q: [5 Q2. Find the Laplace transform for f(t)=- 2<t<5 0 otherwise

A: Given function, ft=5 2≤t≤50 otherwise

Q: A balanced 3-phase load of 150 kW at 1000 V, 0.866lagging power factor is supplied from 2000 V, 3-…

A: Given:3-ϕ loadP=150kWV1=1000Vpf=0.866 lagging

Q: Implement the following Boolean function with a 4 x 1 multiplexer and external gates. Connect inputs…

Q: What is the minimum length of antenna required transmit a radio signal of frequency 20 MHz? O a.…

Q: Q7 A 200- V, d.c. shunt motor takes 4 A at no-load when running at 700 r.p.m. the field resistance…

A: In this question we will find speed on load , torque and efficiency of dc shunt motor....

Q: 4 k2 2 kQ 1 ka 21V. A 中 В 3 ka 1 kQ a. calculate the power at 1kQ if the diode is ideal b. calculate…

A: Power in resister: The power in the resister is calculated by the formula of I2R and this power is…

Q: Electrical Engineering A spherical volume of radius a contains a uniform volume charge and a…

A: We need to find out electric field

Q: Problem 7 Consider the circuit shown in Fig. (5) Assume that E = 1.25 p.u., and V = 1.00 p.u. a-…

Q: Problem 1 A 209-V, three-phase, six-pole, Y-connected induction motor has the following parameters:…

A: An induction motor is an AC motor that does not run at a synchronous motor it works on the principle…

Q: 4) A 1200 kHz carrier is amplitude-modulated by two tones of 500 Hz and 700 Hz. Which one is a…

A: Given data, fc=1200 kHzfm1=500 Hz=0.5 kHzfm2=700 Hz=0.7 kHz

Q: Use the pole-zero placement method to design a notch filter with the following specifications: Notch…

A: The notch filter is a type of bans pass filter that attenuates the frequency of a particular range…

Q: Q5: find the DTFT of the following two-sided sequence x(n) = (0.5)| %3D

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 5OA. If d'Arsonval…

Q: 7. Two single-phase transformers, connected in open delta will supply power to a 200 hp, three-phase…

A: Given data, Two single-phase transformers, connected in open delta. Total power to be supplied to…

Q: Determine the noise figure for a non-ideal amplifier with the following parameters: Input S/N=80 dB;…

Q: Below is a time current curve (TCC), showing the damage curve of a transformer. Draw (roughly),…

A: TCC- Time Current Curve is a plot shows the overcurrent device's interruption time which is based on…

Q: b) Describe component X 6.0v heater i. 6 The heater is designed to work from a 3.6 V supply. It has…

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…

Q: The spectrum of a train of pulses with pulse width t and period Tis shown below: Amplitude Specrtum…

A: Given, The spectra of the train pulse is

Q: 4) A 1200 kHz carrier is amplitude-modulated by two tones of 500 Hz and 700 Hz. Which one is a…

Q: Use superposition to find vo in the circuit in Fig 3(a) Submit your detail answer script via given…

Q: B. Determine the amount of time delay operation of 12-bit serial in / serial out shift register Data…

A: For 12bit SISO register We require 12 flip flops and each flip flop has a time delay Tpd. Therefore…

Q: Sketch the radiation pattern of an isotopic antenna.

A: Here, we have to sketch the radiation pattern of isotopic antenna these are such antenna that…

Q: Results/Data Tables Table 2.1 VR2 Scale (V/Div) Number of Divisions Voltage Scope Voltage DMM…

A: For the given experimental values theoretical values are calculated by using formulas as shown in…

Q: 5: Let xa(t) be aperiodic continuous-time signal x(n) = Acos(200zt)+ Bcos(500ra) That is sampled…

A: We need to find out exponential Fourier series coefficient

Q: Compare between rotor types for AC servo motor: Sequirrel cage rotor, drag-cup rotor, solid iron…

A: An electrical motor is a type that produces motion along a single axis. Based on their functioning…

Q: 3. Simplify the given Boolean function. U(x, y) = X+Y'+ X'Y + X'Y'

A: Given boolean function, Ux,y=x+y'+x'y+x'y'

Q: Q1/ In Sampling Theory solve the signal is = 3cos2000nt+5sin1500rt-10cos1400nt. %3D 1. Find Nyquest…

A: As per the guidelines of Bartley we supposed to answer first three subpart only

Q: Which statement about the photodiode array is NOT correct? All are accurate Not all are accurate A…

A: Photodiode: Photodiode is a semiconductor device it converts light into current. Current generates…

Q: 3Ω 6Ω 4Ω 9 A Select one: O a. -1.5 A O b. 2 A O C. -2 A O d. 1.5 A О е.ЗА ww

A: We need to find out the current for given circuit

Q: hase, 50-Hz induction motor with its rotor star-connected gives 500-V(r.m.s.) at till between the…

A: The solution is given below

Q: [5 Q2. Find the Laplace transform for f(t) = 2<t<5 0 o therwise

Concept explainers

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.

Question

A 2-pole, 50HZ induction motor supplies 15kW to a load at a speed of 2900 rpm. Calculate:
a) The motor slip
b) The induced torque in the motor
c) The operating speed of the motor if the torque is increased by 150%.
d) The power when the torque increases by 150%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Name three factors that determine the torque produced by an induction motor.
6. The motion in DC motor can be increased by the following factors... (you may choose more than one) * a) Using a stronger magnet b) Increasing the potential difference c) Increasing the current d) Increasing the number of turns on the coil
An induction motor has a full load slip of 0.04. It's starting current 5 times its full load current. What is the ratio of starting torque to the full load torque? Select one: a. 2 b. 0.5 c. 0.2 d. 1
A 4 pole, 300 V Series Wound DC Motor developing 25 HP and 81.57 N-m torque runs at a speed of 750 RPM when the current is 65 Amp.. a) Assuming that the Flux varies directly with the current, calculate the Torque if the load increases so that the Motor takes 75 Amp. b) Calculate the terminal voltage required so that the Motor will developed the same Torque of 81.57 N-m when the speed will be 960 RPM. Please draw the cicuit diagram
8. A dc series motor develops a torque of 20 Nm at 3 A of load current. If the current is increased to 6A, the torque developed will be (a) 10 Nm (b) 20 Nm (c) 80 Nm (d) 40 Nm
8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical power developed by the motor is ............ (i) 20 W (iii) 500 W (ii) 980 W (iv) 200 W
2. A 2-pole, 50 Hz induction motor supplies 15 kW to a load at a speed of 2950 rpm. a. What is the motor's slip? b. What is the induced torque in the motor in N-m under these conditions? c. What will be the operating speed of the motor be if its torque is doubled? d. How much power will be supplied by the motor when the torque is doubled?
22 A 400 V, 60 Hz, Induction motor has a starting torque of 125% and a pull-out torque of 375 % compared to its rated torque. The slip at which the maximum torque occurs is: 0.635 PU 0.172 PU 0.20 PU 0.268 PU
hotors a) What power is developed by a motor that turns at 1200 rpm and has a torque of 3.0 N-m?
At standstill condition , the slip of induction motor is 1. Select one: O True O False
A 250 V series motor has an armature resistance of 0.2 ohm and a series-fieldresistance of 0.18 ohm. If the speed is 6oo RPM when the current is 32 amps.What will be the motor speed when the load is reduced so that the current is18 amps, under which condition the percent flux change is 50 % of the percentcurrent change.
A 240-V series motor has an armature resistanceof 0.42Ω and a series-field resistance of0.18Ω . If the speed is 500 r/min when the current is36 A, what will be the motor speed when the loadreduces the line current to 21 A? (Assume a 3-Vbrush drop and that the flux is proportional to thecurrent.)