A two level system has N1=6000 and N2=4000 when the temperature is 700K
Q: In a hydro-electric station the volume of water which can be utilized per annum is 5* 10m³ with a…
A:
Q: QUESTION 9 With reference to the instruction below, what is the value of the number stored at N7:20…
A: We need to select correct option for given instructions.
Q: Problem 2 Known Ep = = 480 V Np = 275 turns Ns = 525 Z = 1.2 kΩ Find Es, Ip, Is, and Ratio Problem 3…
A:
Q: Draw a ladder diagram that is equivalent to the digital logic diagram in Figure D D A B A +8 2 F
A: Convertion of Boolean to ladder logic is based on the following conditions. Boolean logic to…
Q: B-Draw the modulation and demodulation block diagram of AM-VSB. C- If m(t)-Am cos(wt) v, find and…
A:
Q: Show all complete solutions. Consider the circuit R ww L m Cy(t) Determine the frequency response…
A:
Q: 40. Determine the output voltage waveform for each circuit in Figure 2-104. ww www 2.2 ΚΩ 2.2 ΚΩ +30…
A: 40)
Q: FINITE STATE MACHINE A washing machine starts when a coin is deposited. It sequences through: a)…
A: FINITE STATE MACHINE
Q: Q3: For a binary communication system, find which input is more probable given that the receiver has…
A: Given the binary communication system, Receiver output= 0 input equally divided to be 0 or 1…
Q: 19. (a) For different settings of the variable resistor (potentiometer) in Figure P1.19, what range…
A:
Q: 1. Using the superposition principle, find io and vo in the following circuit. 1 10Ω 20 Ω 6A 40 Ω 30…
A:
Q: 2. Find the surface current density, K, for the following boundary condition: (Ħ₁−Ħ₂)×î = K‚K is the…
A:
Q: 19. After closing of the switch in this circuit (immediately below), what will be the steady-state…
A:
Q: Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel to a string of 4…
A:
Q: Extra problem 3: Determine the time-domain function f(t) for each of the following frequency-domain…
A: Laplace transform L [ f(t) ] = F(s) Inverse Laplace transform f(t) = L-1 [ F(s) ] For obtaining…
Q: Design a circuit limit a 25 V rms sinusoidal voltage to a maximum positive amplitude of 18 V of…
A:
Q: An FM signal, 2000 sin(27x10t+2sinx10¹) is applied to a 5002 antenna. Determine the carrier…
A: Given, FM signal is S(t) = 2000 sin(2π×108t + 2 sin(π×104t)) This FM signal is applied to an…
Q: The resonant frequency of a micro-cantilever is given by: f0=(1/2pi) * (k/m) ¹1/2 where k is the…
A: When an analyte of mass "M" is put on a micro-cantilever, its resonance frequency changes. The new…
Q: (a). For the following circuit, graph the output voltage v.(t) when the input voltage is a square…
A: (a).given that input voltage is pulse tarin with positive maximum voltage of 10 V and negative…
Q: such that the current is five times the current flowing through R1 where I=46 A and R1=2,772 Ohms?
A:
Q: Find the effective current of the network below where I1=229 A and 12=1,391 I1 Your Answer: I2
A: The two current sources are in parallel and are in the same direction. Hence Ieff= I1+I2
Q: For the circuit shown, the neutral current (A), IN is most likely, VA = 277 V<0° VB = 277 V<120° Vc…
A: In this question We need to determine the current in the neutral. We are solving this problem using…
Q: A 20-KVA 8000/277-V distribution transformer has the following resistances and reactances: R₂ = 3292…
A: Given a 20 KVA,8000/277 V distribution transformer and resistance and reactances are To find (a)…
Q: 1 Unbalanced Bridge An equivalent circuit for an unbalanced bridge is shown below. Calculate the…
A: The given circuit is shown below, The resistor is, R1=1x1 kΩR2=2x2 kΩR3=5x3 kΩR4=2x4 kΩR5=4x5 kΩ
Q: V1 9V R1 1K D1 1N751, 5V1 VR1 5K ...
A:
Q: What is the maximum clock frequency for a cascaded counter constructed from two 54160 counters?…
A: Cascaded counter The cascaded counter is the larger counter which is formed by adding the series…
Q: Truth table for two-input AND gate Input 2 Output 0 0 1 0 b C 1 1 Input 1 0 0 a 1 O a = 0, b=1, C =…
A:
Q: K (S-1)(s-4) (s²+6s+25) Q2) For the system G(s)= Do the following: 1- Find the imaginary-axis…
A: Since you have posted a question with multiple subparts we will provide the solution only to the…
Q: What is the value of I?
A:
Q: et V₁= 50 uc) what e-t IF Vs= 50 uct) v₁ circuit? Use TH Any Fourier applicable 2F Vo(t) Determine…
A:
Q: Mark all that apply for the circuit below: 60 Ω 40 Ω ο i1 + i2 = -6A ο i3 + i4 = - 10A ο i1 = -4.8A…
A: Choose all the correct options for the circuit: Options: All the options are given in question…
Q: Determine the effective resistance of the network shown below when R1=1,880, R2=1,916, and R3=…
A:
Q: Use the Laplace Transform to solve the following initial-value problem. y-y=e', y(0) = -1.
A: Given data y'-y=et y0=-1 We have to solve the initial-value problem using Laplace transform. Note:…
Q: A three phase induction motor take a starting current of 42 ampere when full voltage is apply across…
A:
Q: the circuit below, obtain the Thevenin's Equivalent at terminals a-b by: Find Rth Find Vth Draw the…
A:
Q: 4. Compute the Fourier transform of the following signals. (a) x(n) = u(n) - u(n - 6) (b) x(n) =…
A: 4)
Q: What are the positives negatives of the optical dna sensor and electrochemical dna sensor?
A: Here is the positive and negatives of the optical dna sensor and electrochemical dna sensor.
Q: Capacitor capacities are C1=1 μF, C2=3μF, C3=4μF and C4=3μF. Also I calculated: C1 and C2=…
A:
Q: a) Describe the function of TLBs in improving paging efficiency.
A: A translation lookaside buffer (TLB) is the memory cache that will stores the recent translations…
Q: Q2) find the signal at each indicating point of figure 1. a3-3-4) kHz, X (X 3 BPF USB and AV-VOD. 10…
A:
Q: B-6-3. Plot the root loci for the system with K s(s+ 0.5)(x² + 0.6s + 10) G(s) H(s)-1
A: given that open-loop transfer function is G(s) =ks(s-0.5)(s2+0.6s+10) feedback path gain is H(s)…
Q: Ov 2.2 K52 B₂ 2.1 km Find VA and VB і вз Ike 3.3Kr m B Rs 3.9Kr
A:
Q: R5 = 100, R₂ = 200, R3 = 9N, and R₂ = 172. 15 = 0.9 A. Determine E. Enter your answer in V rounded…
A: The resistor R3 and R6 are in parallel so it can be reduced in to single resistance and by using…
Q: A 300:5 CT with a normal ratio K = 60, magnetizing current - 1 A and loss components of the…
A:
Q: Sketch the Bode plot (only the magnitude response) for the system 2(s + 4) (s + 10) (s + 1)(s +40)…
A:
Q: How many protons are required to create a total charge of 50 mC?
A: In this question We need to determine the number of protons required for the total charge 50mC. We…
Q: (a). For the diode shown, calculate 2 points that belong to the diode equation P₁ = (VD₁ = 0.2V, ID₁…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: You are given the circuit shown below. Note that the connected to the + terminal of the capacitor…
A:
Q: Question 3 Answer the safety questions accurately below. You should never [Select] [Select] You…
A: The question is about properties of inductor and capacitor.
Q: What is the value of VB? VA Jov. (1) 4 1ov 10-2 24 44 m بسلا + VB
A: Calculation of voltage VB for the given circuit. Note: In upward branch i can observe thevalue of…
A two level system has N1=6000 and N2=4000 when the temperature is 700K.
Step by step
Solved in 3 steps
- mp?attempt=2176198&cmid%3D1088508page%3D6 Question 7 Not yet anwend Marked out of 10.00 Hlag question The line shown in the figure has a linear charge distribution of 101 nC/em. If R=8 cm, find the Electric Potential at the point indicated by the dot. Scan clearly your detailed answers and upload it in question 8. R. 2R V=224016.68 V V=134410.01 V V=448033.36 V V=672050.04 vConsider a metal with an electron density of n = 6.01 E28 m3.Calculate the Fermi energy of this metal. Enter the Fermi energy in "ev" units. Type your answer.Question 2: a. [PI-1.c] The following graph presents two curves corresponding to Fermi functions of a material at two different temperatures. Knowing that Ty is higher than T., specify which temperature correspond to which curve. Explain your answer. P 02 Curve 1 Curve 2 C4 0.5 The Fermi Function CA
- 3. A particle with a charge of 8nC is 4m away from a charge of 10C. What is the electric potential energy?8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 352. When a current of 1A flows through a wire, the drift velocity of the electrons is 0.9 mm/s. What will be the drift velocity of the electrons when a 2A current flows through another wire of the same material having double the length and double the area of cross section and same temperature.
- P1.15. A copper wire has a diameter of 2.05 mm and carries a current of 15 A due solely to clectrons. (These values are common in residential wiring.) Each electron has a charge of -1.60 × 10-19 C. Assume that the free-electron (these are the electrons capable of moving through the copper) concentration in copper is 1029 electrons/m'. Find the average velocity of the electrons in the wire.ANS: 5) You use a voltmeter to measure potential difference from a very long wire carries a uniform linear charge density 2. The meter reads 450V when one probe of the meter is placed 4.5 cm from the wire and the other probe is 2.5 cm farther from the wire. What is 2? a) 9 x 107 C/m b) 9 x 10 C/m c) 2.5 x 10-7 C/m d) 2.5 x 10 C/m e) none of above ANS:1.00 MQ A conducting sphere is charged by an emf source & through a 1.00 MN resistor. When the sphere is fully charged, it has 2 µC charge. The highest current during the charging was I mA. What is the electrical potential energy of the sphere when it is fully chargeď? Give your answer in mJ.
- 7. Each of three insulators forming a string has self-capacitance of "C farad. The shunt capacitance of each cap of insulator is 0-25 C to earth and 0-15 C to line. Calculate the voltage distribution across each insulator as a pecentage of line voltage to earth and the string efficiency. [31-7%, 29-4%, 38-9%; 85-7%]2 Curront is definad as the rate of charge flow. It a charge offo.0065 Golombs passes a given point in a conductor in loo millisesands, Calcutate the? a) current in amperes (Hint: I=) b) Current in milli ampares- a.given Ans: a)o.065 A b) 65 mAFour point charges are placed at corners of a square . At the top left is a charge of - 1 C, at the top right is a charge of - 2 C, at the bottom right is a charge of -3 Cand at the bottom left is a charge of - 4 C. What is the direction of the net electric force due to the four point charges on a positive charge Q located at the center of square ? O due North O due South O Sw O SE