An AC generator produces. cycle(s) per revolution for each pair of poles.

Q: 15.30 Design a bandpass filter, using a cascade connec- tion, to give a center frequency of 500 Hz,…

A: Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: wg three-phase system: a +2₁) H+21 25 S b Iab ZENN [HZ] Load # 1 (201 Calculate the phase current of…

A: In this question We need to determine the all unknown parameters.  We know Current in the impedance…

Q: If an LED emits light of wavelength 500 nm, the energy gap between the valence band and conduction…

A: In this question we need to find the energy gap between the valence band and conduction band

Q: 5.1 Determine the steady-state error for constant, ramp, and parabolic inputs to canonical systems…

A: In this question We need to determine the error constant and error for different different inputs.…

Q: Advatages of FETS to BJTS

A:

Q: Q=1/(2pisqrt(L*C)*R) Simplifying the expression, we get: Q=1/R* sqrt(L/C) The unit of quality factor…

A: In this question We need to determine the all unknown parameters.  We know Current in the impedance…

Q: For a capacitive load: a) Investigate the complex power in terms of real power, reactive power, and…

A: Complex power :  it is also called apparent power. The total power produced by a source of…

Q: 12. Determine V₁, V₂, and I for the network of Fig. 2.162. Voy I 1 ΚΩ 20 V 0.47 ΚΩ Si FIG. 2.162…

A:

Q: ww X₂ Xc For the RLC circuit shown in the figure, if R-30, XL-20, and XC-60, the Power Factor of the…

A: Resistance R=30 Ω, XL=20 Ω, XC=60 Ω. Circuit diagram is given as.

Q: 3. Find the transfer function of the system for the step responses in Figure 2 and Figure 3.

A: Given,  Step responses are We need to determine the transfer function of the system for the above…

Q: 10. Determine V, and Ip for the networks of Fig. 2.160. FIG. 2.160 Problems 10 Ge 20 V Si 2.2 ΚΩ 64…

A: As cut in voltage of Si<GaAs only Si will be ON &GaAs diode will be OFF. V0=12-0.7=11.3V…

Q: Two capacitors A and B having capacitance of 20uF and 30uF respectively are connected in series to a…

A: In this question we need to find the p.d across each other. If a third capacitor C is connected in…

Q: 18. Determine Vo -5 V O OV Si K Si 1kQ FIG. 2.164 of Fig. 2.164. Vo

A: In this question We need to determine the output voltage Vo as shown the circuit.  Assume forward…

Q: Q2) Find the bandwidth of TDM system have 20 voice channel with 4KHZ message frequency.

A: TDM system having voice channels N=20 message frequency fm=4kHz

Q: Q1(a) Analyze the polar form of this waveform in Figure Q1(a). 310 Figure Q1(a) est

A: Waveform is given as,

Q: A set of normally closed timed open contacts will open after the time period delay.  True  False

A: In the given questions, we need to discuss about the Normally Closed Timed open Contact (NCTO).

Q: yv. J₁=4A Ⓡ Find 16 and 14 and i3 Ⓒ If y 1₂=2A 3 Iy 32 Is = 1A (13

A: In this question we need to find the value of current i6 , i4 & i3

Q: 9.47 The Max Selector below has two 4-bit, unsigned inputs, A and B. Its output Z = A if A≥ B and Z…

A: The complements of 1 and 2 are two binary representations of negative integers.In order to determine…

Q: D7.7. A series RLC circuit has the following properties: R = 42, wo = 4000 rad/s, and BW= 100 rad/s.…

A:

Q: Many electronic timers can be intended to be plugged into an 8 or 11- pin base.

A: Many electronic timers can be intended to be plugged into an 8 or 11- pin base.

Q: What type of components placed in series are used to make a voltage divider?

A: The voltage divider circuit is used to divide the total given input voltage into the required…

Q: V₁ Ζή Ce • 330 ΚΩ 0.47 ΚΩ 0 22 V 15.6 ΚΩ Το ↓ Ho Ce β=80 1.2 ΚΩ CE 16

A:

Q: y(t) = x (t + 2) + 8x (t) + e, Find the impulse response "h(t)" if possible y(t) = cos(t+n) 8(2t -…

A: To Find: yt=xt+2+8xt+e-∞ ; Find ht yt=cost+πδ2t-14π yt=rt*ut-3 yt=rt+4*δt+6; Find dytdt…

Q: Electronic timers are much less expensive that Pneumatic timers.    True  False

A: Neumatic timers are used in applications such as medical facilities where electrical currents can…

Q: and Rc parameters: VBE places. Given the PNP differential amplifier circuit below with Vcc 3.3k,…

A:

Q: 1st node V₂(s)-V₁(s) S V;(s) S 2nd node V;(s)-V. (s) S V₁ (s)-Vo(s) 1 + + Vo(s) = (s + 1 + ²) V₁(s)…

A: We need to show the calculation part to get the transfer function.…

Q: Exercise 2: An amplifier circuit has Avmid = 33 dB, find the following: a) Av in dB if the frequency…

A: We need to find out gain at lower cut off frequency.

Q: Given base kVA for 3 phase systems is 30 000kVA and voltage base line to line 120kV. Find: SB, 14 V.…

A:

Q: A resistance R is connected in series with a parallel combination of two resistances 70 and 9 Q.…

A: In this question,  We need to determine the resistance R.  Power P= V2 /R

Q: Suppose we are to convert the phasor current I(jw) to the sinusoidal current i(t). Which of the…

A: 1- THE MAGINITUDE OF THE PHASOR CURRENT I(JW) IS EQUAL TO THE AMPLITUDE OF THE SINUSOIDAL CURRENT…

Q: In recent years, South Africa has been faced with a power shortage challenge. This challenge has led…

A: THE ENERGY CRISIS IN SOUTH AFRICA IS A COMPLEX ISSUE THAT REQUIRES A MULTIFACETED APPROACH. AS A…

Q: This circuit charges a dead battery E: 1.5A 3 Ω + E 6.5A 1Ω 12 V + VI A: Determine the current I in…

A: The value of current through the branch of 3 Ω resistance is 1.5 A. The value of current through the…

Q: 6-32D Design an RC OP AMP circuit to implement the block diagram in Figure P6-32. vs(t) → d dt 100…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: A) Draw circuit diagram and output voltage waveform of three phase inverter (120- degree condition )…

A: In this question we solve the following  we draw the circuit diagram and output voltage waveform of…

Q: Design a 3bit flash A/D converter

A:

Q: A 5 HP (1 HP = 746W) single-phase motor operating at 380 Vrms with a power factor of 0.8 lagging…

A:

Q: Two coils, A and B, are positioned such that 80% of the flux produced by coil A links with B. When…

A: The value of current in the primary, I=5 A The value of flux, ϕ1=2 mWb The number of turns in coil…

Q: For the ideal op-amp circuit at right, a. Show that the transfer function is H(s) = == 600s…

A:

Q: Consider the transfer function Hc(s) Bilinear transformation with a sampling period of 0.1 s is…

A: Hcs=1s+1s+3,Ts=0.1 seconds.

Q: As conductor radius is increased, :corona loss Increase Decrease Remains constant

A: In transmission line radius of the conductor is directly proportional to the disruptive voltage so…

Q: Consider the BSC shown in figure below X1 X2 0.3 0.7 7 0.6 1- Find the output probabilities if the…

A:

Q: b. Analytical Calculations for Circuit 2: Perform the necessary theoretical analysis to calculate…

A: A signal in digital electronics can go from a low voltage level to a high voltage level, or the…

Q: Given: unity feedback system.. Find root locus for positive k

A: In this question we need to draw a root locus of the given system

Q: 6-25 The OP AMP integrator in Figure P6-20 has R = 22 k2, C = 0.001 µF, and vo(0) = 0V. The input is…

A:

Q: The voltage v(t) shown in Fig. P7.85a is given by the graph shown in Fig. P7.85b. If iL(0) = 0, how…

A: In this question we need to find how much power is supplied by the source at t = 4 sec .

Q: 8. Label the output lines (D0 to D7) to denote this circuit as a proper 3-to-8 decoder.

A: The decoder must be labelled based on the selection line connection.one of the selection line is…

Q: The Laplace transform of g(t) = (te¹ cos (t)) can be found in multiple ways. Identify the methods by…

A:

Q: 6. A 3-phase, 50 Hz overhead transmission line, 100 km long, 110 kV between the lines at the…

A: Nominal Pi representation, sometimes referred to as the Pi-equivalent model or the Pi-model, is a…

Q: The simplified form of the equation (240/75°+160/-30°) (60-j80) (73+j84) (20/32°) is +

A: In the given questions, we need to simplify the given complex expression.   Also, I need to…

Q: Residential AC voltage for many European countries is 230 VRMS at 50 Hz. Calculate the following…

A: Ac voltage V = 230 V(rms ) frequency f = 50 Hz  Time period T = 1/f in  (msec) VP - peak voltage in…

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.