An opaque surface, by 2 m, Is malhtalhed at K and is exposed to solar irradiation with G = 1200 W/m2. The surface is diffuse and its spectral absorptivity is al = 0 0< A < 0.5 um = 0.8 0.5 um 2.0 um Determine the absorbed radiation, the emissive power and the net radiation heat transfer.

Q: I1 代)4°V -jin7 + Vx 1Ω I2 I3 10 jin 2Vx Is I4 ell

A:

Q: DETERMINE THE VOLTAGE BETWEEN THE NODES A 2. and B IN THE CIRCUIT BELOW. A + 10 VE C C В C = 1 µF…

A: We need to find voltage for given circuit

Q: The Fourier Saries

A:

Q: pole in the electric motor (electromagnet) if it loses its magnetic field How to recharge the

A: A magnet is used to create the magnetic field. it may be an electromagnet or a permanent magnet,…

Q: *48. Perform the following operations, and express your answer in rectangular form: (4 +j 3) + (6 -…

A: The solution is given below

Q: 1 Find the activity factor at the output of each gate if P at A, B and C are all equal to 1/2. A B C…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Design a circuit using op amps, to perform the following operation: vo = 4va + 5vB – vc Now, choose…

A: The output of the circuit formed by the op-amps is,  vO=4vA+5vB-vC The circuit is,

Q: What is the production cost per month of LOAD 1?

A: Most of human energy requirement is meet by generating electrical energy. Once electrical energy is…

Q: Use Thevenin's theorem to find Vo in the network. 2Ix -j102 10 jニ 220°A 10 10 Vo 6/5°v Ix ll

A:

Q: a. A toaster has a resistance of 140 Q and is plugged into a 1200-V outlet. What is the current in…

A: We need to find current and resistance for given circuit

Q: Q3. A three-phase, 50 Hz, completely transposed 345 kV, 200 km line has two conductors per bundle…

A:

Q: Determine the output waveform for the network of figure below and calculate the output dc level.

A: It is given that:

Q: 10 jio -jior 220 A 10 10 10 Vo ll

A:

Q: Q3. A three-phase, 50 Hz, completely transposed 345 kV, 200 km line has two conductors per bundle…

A: Three Phase System: The three-phase system is a cost-effective means to transmit large amounts of…

Q: Using excess-15 notation, what is the decimal equivalent of this binary number 1011001110000000.…

A: The formula for converting Excess-N to Decimal is given by: (Decimal Value)- N = (Excess-N value)…

Q: A six pole, three-phase SCRIM is connected to 60 Hz supply. At full load the rotors induced emf…

A: In an induction motor slip = rotor frequency /stator frequency. Frequency is the no. Of cycles per…

Q: A total current of 60 A is divided among 3 parallel branches having resistances of 10, 6, and 12…

A: It is given that a total current is divided among three parallel branches of resistance 10, 6 and 12…

Q: Show your solutions with checking. 1. Convert the decimal number 10 to a binary digit.

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: For the transistor circuit a. what is VCE when VIN=0 V? b. What minimum value of IB is required to…

A:

Q: Using excess-15 notation, find the decimal equivalent of this binary number 0011101100000000.

A:

Q: 39 42 sin 8t V /00

A:

Q: For the given network, determine the signal voltage at the base ofthe transistor with Ie = 3.58 mA.…

A:

Q: 10. Calculate the value of Rp that will provide an I D(on) of 10 mA for each of the following values…

A: In this question,  We need to determine the resistance RD  if drain current ID = 10mA VDD  is given.…

Q: For the transistor circuit a. what is VCE when VIN= 0 V? b. What minimum value of Ig is required to…

A: The transistor circuit is shown below:  a. The collector-emitter voltage is calculated as:…

Q: Find / in the network using Norton's Theorem. 12 2.5IA -j22 T20230°v j42 ll IA

A:

Q: torque. Ans[40.5 N.m, 63.6 N.m, 1333r.p.m] The resistance and standstill reactance of each phase of…

A:

Q: Calculate the V(UTP) and V(LTP) in Figure * : bellow R; Vin oW Vout(max) =±10 V R1 47 kN R, 18 kN…

A:

Q: -15 V to +15 V, if the slew rate is 0.5 V /μs

A:

Q: Use Kirchhoff's Laws to solve the branch currents in the network below. I1 a I2 -j1N A) 4230° 4. 1Ω…

A:

Q: H w 2 Design oscillote at 10MHZ,if the Lz is HarHley oscilafor to a equal to ten times of Li

A:

Q: Please use NODAL ANALYSIS to solve for the breanch currents thank you. Show clean and complete…

A: The given circuit is as shown below,  We need to find the branch currents I1, I2, I3, I4, and I5.

Q: se Thevenin's theorem to find Vo in the network. 12 2Ix -ji27 220°A 12 10 12 Vo 65°v Ix ll

A:

Q: A grating has 1000 lines/mm of width. How wide must the grating be in order to resolve the mode…

A:

Q: 1. Design a combinational logic circuit that compares two 4-bit numbers A and B. The circuit should…

A: 4-bit magnitude comparator: The 4-bit comparator has 2 inputs A and B (each having 4 bits i.e.,…

Q: Q2. A three phase, 350 MVA, 13.8 kV AC generator has a synchronous reactance of 1.20 per unit. The…

A: The solution is given below

Q: Find the Fourier series expansion of the function

A:

Q: Use mesh-current analysis to find the branch currents indicated in the network shown below. I1…

A:

Q: I1 800 + Vx x - 10 I2 I3 10 2Vx Is I4 「ト ell

A:

Q: 1. Design a fixed bias-transistor circuit using VBB = Vcc= 10 V for a Q-point of Ic = 5 mA and VCE 4…

A:

Q: 11. A 3-phase, 10 pole, 60Hz Induction motor has full load slip of 0.075.What is the slip speed of…

A: In this question,  We need to determine the slip speed of the motor relative to the revolving field…

Q: 1. Time constant of excitation system iš A. much smaller B. smaller C. greater D. much greater 2. A…

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you…

Q: What will be the Magnetic field value at the center of a current-carrying coil?

A: The solution is given below

Q: Problem solving 1. A building has 21 housing units. Each housing unit has the following circuit…

A: Electrical demand factor can be explained as the Maximum demand of system divided by total connected…

Q: Q2. A 0.5 µF capacitor has a periodic voltage as shown in Figure Q2. Determine and plot as a…

A: In this question,  Voltage waveform across the capacitor is given We need to draw the current in the…

Q: Please show your clean and compl

A:

Q: - Use superposition to obtain vx

A:

Q: Q1)information signal is PCM using 8 levels quantization if the signal is given as cos(4t) with…

A: According to the question, An information signal is PCM using 8 level quantization if the signal is…

Q: 38. Sketch v, for each network of Fig. 182 for the input shown. 120 V Ideal Ideal 20 V (a) (b) FIG.…

A:

Q: For F(A,B,C,D,E)=Em(0,2,4,7,8,10,15,17,20,21,23,25,26,27,29,31), label the essential prime…

A:

Q: current and impedance

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.