Argillaceous materials are those: Owhich have lime as the main constituent O which easily break when hammered lightly O which produces heat upon addition of water • which have alumina as the main constituent Clear my choice

Q: För ån equal tangent vertical curve g1 = -4%, g2 = +3%, L = 300.00 ft, BVC Station = 10+00.00, BVC…

A:

Q: how many sheet of plywoodwill be needed to form the decking

A: The requirement of number of plywood sheets  is calculated by dividing the area to be decked by the…

Q: The dilution water which is to be used for the BOD analysis on an industrial waste was seeded with…

A:

Q: 15.) Conduct research to find the specific heat capacity of water ___________________ and iron…

A: Specific heat capacity- It is defined as the quantity of heat (J) absorbed per unit mass (kg) of the…

Q: Problem 1. Draw the shear and moment diagrams for the simply supported beam. (15 pts) 20 kN 25 kN/m…

A:

Q: The rigid beam is supported by three 25 mm diameter steel rods with E=200 Gpa. If the rigid beam…

A:

Q: A square footing has a dimension of 1m x 1m. Unit weight of soil is 18.1kN/m3 with cohesion of…

A: Stress on the soil = 590/1= 590 KN/m2. Ultimate Bearing capacity of the soil as per terzaghi's…

Q: В L

A:

Q: A .05kg bullet is moving to the right with a speed of 450 m/s when it strikes a 20 kg box that is…

A:

Q: 15 A uniform T-shaped arm of weight W, pinned about a horizontal point C, is supported by a vertical…

A:

Q: A soil sample has a wet mass of 151.2 g and a dry mass of 141.5 g. Calculate the moisture content of…

A: Moisture content = (Weight of wet soil -Weight of dry soil)/Weight of dry soil *100

Q: A sand deposit is 10 m thick and overlies a bed of soft clay. The sand above the ground water table…

A:

Q: A trapezoidal canal has a depth of 7.382 feet. It has a mean velocity of 2.953 fps. Determine the…

A: Use width formula and slope for efficient section.

Q: Consider a farm irrigation ditch in a loam soil having the following dimensions: bottom width, 0.5m;…

A: Bottom width = 0.5m Total depth = 0.6m Side slope 1H:1V means slope m= 1        tan450=1 Depth of…

Q: simply supported beam has a maximum moment equal to 25 KN.m. The beam has a width of 200 mm and a…

A:

Q: Problem 2. Express the shear and moment functions in terms of x, and then draw the shear and moment…

A:

Q: Problem 2. Express the shear and moment functions in terms of x, and then draw the shear and moment…

A:

Q: An aluminum pipe with a length of 60 m at a temperature of 10°C rests freely on the ground. An…

A: Thermal stress In mechanics and thermodynamics, thermal stress is mechanical stress induced by a…

Q: GL 700 Sand Water table is at ground level Water content = 20% 5 m Specific gravity of solids 2.7…

A:

Q: Determine the slope at points B and C of the beam given. If E = 200 GPa and I = 360 × 10 mm". 5m…

A: Apply double integration method to obtain rotation and deflection at any point or across the…

Q: SITUATION: A rectangular footing, a = 3.5m, b = 2.5m, has a thickness of 700 mm. The column load is…

A:

Q: Determine the complete set of zero force members in the given N-type truss subjected to concentrated…

A:

Q: 4. Suppose that a compound curve deflection angle is 152° and the tangent length of the compound…

A: Solution (a)  Compound curve s drawn above: Elements of curve given are, Deflection angle , I =…

Q: SITUATION: A liquid limit test conducted on a soil sample in the cup device gave the laboratory…

A: To find liquid limit

Q: pavement

A: 'Pavement rehabilitation program refers to the initiative taken by any Government or organization in…

Q: The water–cement ratio is important because it influences all of the desirable qualities of…

A: Solution-(a)The water cement ratios is calculated using voids that are not filled with asphalt.(b)…

Q: No. 2. A rigid bar ABCD is pinned at end A and supported by two cables at points B and C (see…

A: Solution -The given values are as follows,The diameter (dB)=12mmThe diameter (dC)=20mmThe modulus…

Q: Determine the slope at points B and C of the beam given. If E = 200 GPa and I= 360 × 10 mm. 5m 10KN…

A:

Q: A footing 2 m x 3 m in size transmits a bearing pressure of 140 kN/m2 on a soil having E= 5 × 104…

A:

Q: In a location of highway construction project , where the ( cross and longitudinal ) sections of the…

A: Given Data:b= 16mslope= 2:1s= 2d for cutting= 1.75+2.3+2.0753= 2.04md for filling= 1.8+1.3+1.153=…

Q: 3.6 kips/ft 1.8 kips/ft A C B 6 ft – 6 ft –

A:

Q: The ground line slopes uniformly at -5.5% from station 40 + 310, which has a center height of 4.50 m…

A:

Q: 15. What is the value of the reaction at the hinge support D  in KN?

A: No. of member (m) = 2 (AB, BD)  No. of joint (j) = 3 ( A,B,D)  No. of reaction (r) = 3  Degree of…

Q: b) For a normally consolidated clay, given o = 20° and ø' = 28°. If a CU triaxial test is conducted…

A:

Q: A commercial building is located 7 m from the centerline of the inside lane of a curve section of a…

A:

Q: Example: The beam is subjected to the concentrated loading shown. Determine the reactions of the…

A:

Q: SITUATION: A cylindrical tank with radius 0.5 m and 2 m high weighs 1200 N. The tank is to float in…

A:

Q: A rectangular beam has a dimension of 210 mm x 260 mm. The simply supported beam is 5-m long and…

A: To Determine Maximum flexural stress of the beam.

Q: For a reservoir having fetch of 36 km and wind velocity of 16 km/hr, the height of wave from top of…

A: given- reservoir area F=36 kmwind velocity V=16 km/hr

Q: Given the beam loaded as shown. 60 KN 3 m 50 kN/m 10 kN-m A D 1m 5m

A:

Q: Problem 3a. A compression member is built up from a W14 × 90 and a W10 49, both of A992 steel.…

A: Given  W14×90 , W10×49 of A992 steel KxL = KyL = 30ft According to ASTM A6, the properties  for…

Q: What is the value of gradient for a BG track such that the grade resistance together with curve…

A: given- weight of the train let Wrequired gradient Xdegree of curve =2ruling gradient=1 in 200

Q: An equilateral triangulated 2D truss as shown below is subjected to a load 20 kN at B. The force (in…

A:

Q: A soil profile is shown in the following figure. A new footing will be placed on the ground and the…

A:

Q: Which of the following is not correct? edimentary Rocks usually not as strong as igneous rocks…

A: Igneous rocks are stronger than sedimentary rocks so statement 1 is correct . Soils which remain in…

Q: Define tack coat, concrete slab, plate bearing test, California design method, flexible pavements,…

A: There are different type of coating used in thr construction of the pavements. There are different…

Q: A constant-head permeability test was conducted on a clean sand sample.  The diameter and length of…

A: dia=15cmLength…

Q: 10. Given the following information and figure determine Qr. O. = 3 days V= 100,000 m³ X (MLVSS in…

A:

Q: simply supported beam has a maximum shear equal to 20 KN. The beam has a width of 200 mm and a depth…

A:

Q: 23.114 KJ 94.031 KJ 53.933 KJ 46.612 KJ

A: ASKED: To determine the work done to raise the water from the given tank.   Given, Diameter of the…