Assuming that an ion of tin-120 is at rest before being accelerated, show that the final speed after acceleration is 177km/s
Q: The following is an acceleration-time graph of a particle with a starting velocity and the distance ...
A: a=t-14 a=dvdt∫dv=∫adt∫60vdv=∫10t(t-14)dtv-60=t22-14t+90v=t22-14t+150 at t=18 velocity v=60m/s
Q: What is Binding Energy?
A: Introduction: Binding Energy is the smallest amount of energy required to remove a particle from a s...
Q: what is the best answer?!
A: Diffusion is the mixing of molecules due to their random motion, liquid or gas. Now we know that kin...
Q: Question 14! This is applied thermodynamics (please consider equations for thermo)! Please make sure...
A: Given : Initial mass of solution = 5 Kg = 5000 g (S...
Q: A helicopter carrying Dr.Evil takes off with a constant upward acceleration Of 5.00 m/s². se cret ag...
A: Relevant theory: Newton's first law states that an object in a state of rest or motion will continue...
Q: A wire has a resistance of 20.5 ohms. If its length is 230ft , how much length must be cut off from ...
A: Given data: The resistance is R1=20.5 Ω. The resistance is R2=19 Ω. The length is L1=230 ft. The e...
Q: Q2 Find the current passes through the load (48 2). Assume the diodes are Si with (1 2) resistance f...
A: The current would only flow through the diodes which would be forward biased. The modified circuit d...
Q: A student pushes a 40 kg box with a force of 50 N at an angle of 60 degrees above the horizontal. If...
A: Given: The mass of the box is 40 kg. The force applied is 50 N at an angle of 60 degrees.
Q: A new temperature scale is being developed using acetic acid (°X), wherein 0 and 100 degrees corresp...
A: Given A new temperature scale is being developed using acetic acid (°X), wherein 0 and 100 degrees c...
Q: A flat-bottomed scow is built with vertical sides and sloping ends. Its length on deck is 24.56m, on...
A: Given: The long length of the trapezium side of the scow l1 = 24.56 m. The short length of the trap...
Q: 1. Ap-type silicon sample with the geometry shown in Figure 5 has parameters L= 0.2 cm, W= 102 cm, a...
A:
Q: The block has a weight of 20 N and is being hoisted at uniform velocity. The system is held in equil...
A:
Q: A farmer wants to install a solar energy system for pumping water through a standalone PV system sit...
A: Given that,A farmer wants to install a solar energy system for pumping water through a PV system at ...
Q: (B) - you have the wave function >=(a*)"|0> Find the value of a"|n > and the expected value < 2m
A: Given: The wave function is |n>=1n!a+n|0>. Introduction: Creation operators create one quantum...
Q: Find the Norton equivalent circuit of the circuit in Fig.6 o a 2 A 5Ω 12 V o b
A: Let us denote the resistances in the given circuit with notations R1, R2, R3 and R4 as shown below i...
Q: Question:- TNO plane waves which have and circular polarization ( left and light). show that the Sup...
A: Given: The angular frequency is ωk. The amplitude is p. Introduction: Circularly polarized light con...
Q: A point rotates about the origin in the xy plane at a constant radius of 0.204 m with an angular vel...
A: The point is rotating in the xy plane with a constant radius of 0.204 mSince the point is rotating i...
Q: A 3*10°C charge is at (0, 0). A-1*10“C charge is at (1, 0). A-2*10“C charge is at (0, 1). (a) Calcul...
A: (a) Given: The three charges are 3×10-6 C at 0,0, -1×10-6 C at 1,0 and -2×10-6 C at 0,1. Introductio...
Q: Q3) Find the solution of Laplace's equation in rectangular coordinate?
A: Given, Laplace equation in rectuangular coordinate
Q: has nominal low-pass filer Constant-k impe dance f 752 & cutoff frequency af 2MAZ find L & C T- seet...
A: Nominal impedance Znom of the given circuit is 75 Ω and is defined by the relation Znom=LC ...
Q: Problems QI: A bar of intrinsic silicon having a cross section area of 3x104 m² has an n=1.5x1016m3....
A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...
Q: Q5. (a) In the uniform circular motion derive the expression for the components of angular accelerat...
A: uniform circular motion: Motion, in a circle at a constant speed is called uniform circular motion...
Q: Points A and B are 5.0 m apart. The force indicated by the arrow acts on the block with a magnitude...
A: Here work done by the applied force is W= Force applied×displacement=2×5=10 Joule Work done by the F...
Q: A 3*10°C charge is at (-1, 0). A -4*10°C charge is at (2, 0). (a) Calculate the field at the origin....
A:
Q: In an experiment to determine the acceleration due to gravity using a simple pendulum.
A: 1. this is because for the smaller mass center of mass of bob would be near the end of the string(be...
Q: Considere el siguientes circuito con 4 capacitores donde C1=C2%=D2C, y C3=C4=14C (donde C es un valo...
A: The equivalent capacitance of capacitors connected in series is given by, 1Cs = 1C1 + 1C2 + 1C3 + .....
Q: Determine the volume of the three-dimensional figure. 6 cm 3 cm 3 cm
A:
Q: part d Consider an Ar atom trapped in square box with length 1 m. Assume that the energy of the Ar ...
A: (a) Given: The energy of the Ar atom is 3kBT2. The temperature is 250∘C. Introduction: The particle ...
Q: Problem B) The mass of the Earth is 5.97 × 102ª kg and the mass of the Sun is 1.99 × 1030 kg. The av...
A:
Q: • For constant a, v = v +2a, (x, – x,): • Gives final velocity in terms of acceleration and displace...
A: Introduction: Consider a particle moving in a straight line with uniform acceleration. The accelerat...
Q: 1) Graphically trace all the tributar beams and girders for the framir shown by colors and dotte spa...
A: Given: The reaction to the girder includes G-2 (A3-D3). The value of the beam started with B-1 and ...
Q: One wire in a high-voltage transmission line carries 1 000 A starting at 560 kV for a distance of 27...
A: P=IV
Q: Explain with neat diagram of instrument for the measurement of sunshine hours.
A: 1.PyrheliometersA pyrheliometer is used to measure direct solar radiation from the sun and its margi...
Q: For the force system shown, a fifth force F must be added so that the resultant of the five forces w...
A: Given: The force system includes the fifth force F having the value of 450 N force. The magnitude of...
Q: Explain Fermi Paradox?
A: This is a question related to astrophysics. Fermi Paradox: Fermi paradox can be defined as the appar...
Q: The next two questions pertain to the situation described below. Three point charges Q1 =5 μC, Q2 =-...
A:
Q: The diagram below shows two horizontal parallel conducting plates in a vacuum. +350 V A 10ст A small...
A: The upper plate is at a potential of +350 VAnd the lower plate has a potential of 0 So, the potentia...
Q: Assume V=0 at r= infinity for problems on this worksheet
A: The electric voltage or potential at a point is the work done to bring a unit positive charge from i...
Q: For a sphere of radius "a" and charge Q what is the potential difference going from "a" to infinity?...
A: Potential at a distance r from the charge Q is given by V=Q4π∈0r Potential at the surface of the sph...
Q: Q1: If you know that the degree of accuracy in measuring momentum and positioning (it was treated as...
A: The total energy of a harmonic oscillator is the sum of its kinetic energy and its potential energy....
Q: Assume that the rate of decay of a radioactive substance is proportional to the amount of the substa...
A: Given: The decay rate is directly proportional to amount of the substance being present. On consider...
Q: A 4.0 kg block starts up a 30° incline with a friction coefficient of 0.3. If the bundle starts up ...
A: Given: The mass of block is m=4.0 kg. The angle of inclination is θ=30∘. The coefficient of frictio...
Q: Find the voltage V, in the circuit O 20 V Si Ge VA 3 ΚΩ
A: 20 V voltage is greater than cut off voltage of both Si and Ge diode. So, we replace both the diode...
Q: For glass baking dishes, Pyrex glass is used instead of common glass. A cold Pyrex dish taken from t...
A: For glass : Glass breaks when a small part of it is heated while the rest of it remains colder. The ...
Q: Question 6! This is applied thermodynamics (please consider equations for thermo)! Please make sure ...
A: Given data- Mass(M)=1000 kg Distance moved by mass is d=1000 m along 450 to direction of gravita...
Q: 4. The Bohr model (Neils Bohr, 1913) treats the hydrogen atom as a minature solar system. Although t...
A: (a) Let m be defined as the mass of the electron. Let v be defined as the speed of the electron and ...
Q: Use the formula for „P, to solve the following question. A dlub with sixteen members is to choose th...
A: The total number of selections to be made are 3, one for president, one for vice president and one f...
Q: Use the free body diagram and Newton's 2nd law to determine an expression for the Tension in the str...
A: as shown in figure, in vertical direction for equilibrium net force Fv must be zero. net force in v...
Q: (a) Calculate the resistance per unit length of a 44 gauge nichrome wire of radius 0.642 mm. (b) If ...
A: Ohm's Law The potential difference across a conductor is directly proportional to the current flowin...
Q: Example 1 R. Determine the P.D. which must be applied to a 2 k may flow.
A: Given data: R=2 kΩ or 2000ΩI=10 mA or 10×10-3 AThen Potential difference(P.D),P.D=?
The diagram shows a mass spectrometer used for measuring the masses of isotopes. It consists of an ion generator and accelerator, a velocity selector and an ion separator, all in a vacuum.
In one experiment, tin ions, each of which carries a charge +1.6 × 10-19C, are produced in the ion generator and are then accelerated by a p.d. of 20kV. Tin has a number of isotopes, two of which are tin-118 (118Sn) and tin-120 (120Sn).
- Assuming that an ion of tin-120 is at rest before being accelerated, show that the final speed after acceleration is 177km/s.
Step by step
Solved in 2 steps with 2 images