(B)- Choose the correct answer for the following questions (Choose FIVE Only) 1. Assume AL register 7FH, it would become. . after executed NEG AL instruction. .... a. 8FH b. 18H с. 81H 2. The unknown value for ????:B000H=25000H physical address is .. . a. 001A H b. 1A00H c. 100AH 3. A microprocessor has ... .. address bus a. unidirectional b. bi-directional c. Both 4. Instruction queue allows up to . . of instruction code to be pre-fetched. a. 16 bits b. 6 bytes c. 6 bits 5. To activate the address bus or data bus in ADo-AD15 signal the .. should be either logic 1 or 0. a. MN /MX b. RD c. ALE 6. According to Moor's Law.... a. number of transistors on b. number of transistors on c. number of transistors on an integrated circuit an integrated circuit tripled an integrated circuit not doubles every two years every two years change.

(B)- Choose the correct answer for the following questions (Choose FIVE Only) 1. Assume AL register 7FH, it would become. . after executed NEG AL instruction. .... a. 8FH b. 18H с. 81H 2. The unknown value for ????:B000H=25000H physical address is .. . a. 001A H b. 1A00H c. 100AH 3. A microprocessor has ... .. address bus a. unidirectional b. bi-directional c. Both 4. Instruction queue allows up to . . of instruction code to be pre-fetched. a. 16 bits b. 6 bytes c. 6 bits 5. To activate the address bus or data bus in ADo-AD15 signal the .. should be either logic 1 or 0. a. MN /MX b. RD c. ALE 6. According to Moor's Law.... a. number of transistors on b. number of transistors on c. number of transistors on an integrated circuit an integrated circuit tripled an integrated circuit not doubles every two years every two years change.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

2) Convert Hexa-decimal to Octal a. 7E6A(16)=?(8) b. C350(16)=?(8) c. 9E36.7A(16)=?(8) d. EADD.EBEF(16)-?(8)
The microprocessor unit that responsible for instruction queuing is .. O EU O ALU BIU O Segment registers O None of the above
8085 microprocessor went through its manipulation operation in the ALU, the results was transferred on the data bus and status of the results was stored in the flag register for indications . With your knowledge and understanding illustrate a complete bit configuration of 8085 flag register and show the functions of the represented bits in the register.
4. Write a simple complete program with LOOP instruction for 8086 microprocessor, and explain the processes for each line of the program.
We need to generate a PWM signal with frequency of 2 KHz, and duty cycle of 20%. The clock frequency is 1 MHz and the counter is configured in count-up-down mode. Determine the values that we need to write in LOAD and COMPARE registers. You can use either pwmA or pwmB.
) What is the term “Reduced Instruction Set Computer (RISC)” mean in the Microcontroller Architecture. N I T L o T T . . T T I e, A T T .
1. Draw the figure showing the types of registers in an 8086 microprocessor. Write the register group types explaining the functions shortly for each one.
Problem #4: Consider the Programmable Array Logic PAL module below '1' A B C D F₁ F2 F3 1. Determine the corresponding product term per row PRODUCT TERMS 000000
4) Design and draw these memory units with their control circuits. Explain operations. a) A single EPROM 2716 is used with an 8088 microprocessor so that this microprocessor will see only X bytes of memory between the address range of DF800 –DFFFF or DD800 - DDFFF instead of 1M byte that it expects. Draw this circuit. What are X bytes? Do not use 74138 decoders. b) Design and show a 16K x 16-bit memory circuit by using 8K x 8-bit RAMS. Explain its operation. Do not use decoder 74138 chip.
Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address). Give an example solution to find the physical address in a segment from the logical address for 8086 microprocessor.
Which statement describe a digital signal? a. is a smoothly and continuously varying voltage or current. b. will take on finite set of voltage levels. c. take on all possible values of amplitude. d. can have an infinite number of values in a range
Q1) List the main internal elements of a microcontroller. And explain the function of each of them. Q2) What is the difference between the Von-Neuman Microcontroller Architecture and Harvard Microcontroller Architecture. Q3) Compare between the (EEPROM) and the Non-Volatile RAM - (NVRAM). Q4) What is the term “Complex Instruction Set Computer(CISC)” mean in the Microcontroller Architecture.