b) Find the power dissipated in the 10 Ω resistor 110 V 5Ω 4Α ΖΩ ΑΛΛ υξ 10 Ω {12 Ω

Q: e have 3 signals x(t),y(t) and m(t), name them and identify the relationship could relate them […

A: In this question,  We need to choose the correct options Some standard basic signals are given. So…

Q: Question 4. The approximate equivalent circuit of a three-phase ∆ /∆ connected 60 Hz, 4000/1000 V…

A: For a 3-phase, delta-delta connected, 60 Hz, 4000/1000 V transformer, the following specifications…

Q: 3. Use step functions to write the expression for the waveform below. Y 1 -1 2 8 → t

A: In this question we need to write the expression for the given waveform using step function.

Q: A 1000 kVA 50Hz 34500/400 Volt, Δ Y distribution transformer has an equivalent resistance and…

A:

Q: (g) z7 = (−1 + j)¹/²

A: Z7=(-1+j)0.5 Asked to convert rectangular form to polar form

Q: What are the typical deviations that occur between the most common error signals, and what do these…

A: We need to tell about deviations that occur between the most common error signals, and we also need…

Q: 1. Why is it important to know the phase sequence of a three-phase power distribution system when…

A: In this question we discuss the following Why is it important to know the phase sequence of a three…

Q: 2.12. Consider a system with input x[n] and output y[n] that satisfy the difference equation y[n] =…

A:

Q: Add the two voltages together:

A:

Q: A function of period 27 is defined over half its period by: f(t) = (π-t) (i) Extend the definition…

A: According to the question, A function of period 2π is defined over half its period by: f(t) = (π-t);…

Q: 2.21. A discrete-time signal x[n] is shown in Figure P2.21. -2-1 0 1 2 3 4 (a) x[n -2] (b) x[4-n]…

A: In this question we need to draw the signal for following  x(n-2) X(4-n)

Q: What is the noise voltage generated over 55 Ω input resistor at 23°C with 3.2 MHz bandwidth?

A: We need to find out noise voltage for given resistance and bandwidth.

Q: Q1) 1 000KVA 34500/400 Volt Dy connected distribution transformer has an electrical load of 500 kVA…

A: Line Current = (Load / Power Factor) / Low Voltage where Load is the electrical load of the…

Q: KARABÜK UNİVERSİTESİ 2. Consider the Ifm = 10 kg, b = 30 N-s/m, k spring-mass-damper system shown in…

A:

Q: R(s)E(s) If G(S) = -=-1 Find Y(s) R(s) = U (s) W (s) D(s) & D (s): = S-1 S+1 (₂(5) D(S) J + 6(S) P…

A:

Q: 2.4. Consider the linear constant-coefficient difference equation | − ¾y[n − 1] + {y[n − 2] = 2x[n −…

A:

Q: Capacitor voltage ?c(t) = ______ V in the circuit below for ? ≥ 30ms

A:

Q: + | t=0 100 V 32 ΚΩ w 0.5 μF HF 240 ΚΩΣ 60 ΚΩ

A:

Q: m Figure 2 The Fourier series of the full-wave rectified wave shown above is given by: Cos754.29t…

A:

Q: a) Find the current through 1-kohm resistor in mA. b) Find the current through the diode in mA.…

A: In this question we need to find the following the current through 1-kohm resistor in mA the…

Q: Determine the terminal voltages of each transistor with respect to ground for each circuit in Figure…

A:

Q: For the circuit below, find Vout & phase angle between Vin & Vout, identify if it's (Lag/Lead) = in…

A:

Q: t=0 ) lov A 2 кл 2,15.2 + Vont Luf a) Find the Thevenin equivalent circuit of the voltage source and…

A:

Q: Use a multiplexor to implement the following Boolean function:

A: The given boolean function should be implemented by using the multiplexer. The given truth table can…

Q: 2. Calculate the cross product between A = and B =. 3. Determine the unit vectors that are…

A:

Q: Find the current in the RLC circuit, assuming that E(t) = 0 for t > 0 R = 4 ohms; L = .05 henrys; C…

A: In this question we need to find the current in the RLC circuit .

Q: 31. For the circuit of Figure 5.71, determine the Thévenin equivalent that drives the 20 nF…

A:

Q: input find the steady state response of the following system x(t)= 10 sin 4t 5y + 10y = 3x + 12x. I

A: We need to find out the output for given system and given input .

Q: Objective 2-Know how to analyze a balanced, three-phase wye-delta connected circuit 11.6 The line…

A: In this question We need to determine the per phase impedance of the load if sequence is positive…

Q: Problem (5) Consider the control system shown in Fig. 5. The plant is critically stable at the…

A:

Q: 2. Draw the output signal with voltage values correctly in the following figure. -IV -2V +5V ικηξ…

A:

Q: 5 kW, 100 v is written on the plate of the dc serial motor. The armature resistance of the motor is…

A: In this question,  We need to determine the armature current at half load, back emf at full load and…

Q: Find the Thevenin and Norton equivalent circuit at terminals a-b for the circuit shown below, where…

A:

Q: 24VO Find t CI HH b) WT ey 4+ C2 C6 a.) CT, If C₁ = IMF C₂2nF J C3 = 4mF₁ C₂ = SMF C5 = 2nF c.)…

A: Given  C1=1uF  C2=2nF =0.002uF C3=4mF=4000uF C4=5uF C5=2nF=0.002uF C6=0.5nF=0.0005uF We need to…

Q: x (t) = 16rect (4t) Determine the numerical value of X(f) if f= 2. The numerical value of X() if f=…

A: In this question,  We need to determine the value of X(f) at the f=2

Q: Find Vo for the circuit given below, where V=29cos(4t +45°) V and R=1 Q. Please report your answer…

A: In this question we need to find the voltage Vo shown in the given circuit.

Q: Identify the nature of the signals f(1) f(0) why I f(1) Discrete time & discrete amplitude f(1)…

A: Let us consider the given signals as  a,b c,d. signals-a ,c are left side  Signals-b,d are right…

Q: 9. An FM signal has a center frequency of 154.5 MHz but is swinging between 154.45 MHz and 154.55…

A: Need to calculate the modulation index of the frequency modulation with the given center frequency,…

Q: 8. An Industrial facility has a maximum demand of 1 GW. The demand factor is given as 0.75. What…

A:

Q: use kirchhoffs Junction rule and loop rule to solve for currents I1 , I2 and I3..

A:

Q: Reduce the following block diagrams using the block diagram reduction method.

A: The given block diagram can be reduced by considering the parallel and series reduction techniques…

Q: 11.21 Fill in the timing diagram for a begins at 0. Clock S R Q falling-edge-triggered S-R…

A: Flipflop:Flipflop is a sequential circuit which stores a binary information either bit '0' or bit…

Q: + X R For the RL circuit, find the mathematical model (input-output relationship) if the output is…

A:

Q: 3) The longitudinal synchronous reactance of a salient pole synchronous generator is 0.8 pu, the…

A: As it controls the amount of actual power that can be delivered from the generator to the electrical…

Q: A linear dynamical system is described by i(t): = Az(t), where A = (a) Find the characteristic…

A:

Q: Question 7 For the open loop transfer function G(s) Determine the r (tau) 100 (3+2)²(x+8) design a…

A: Gs=100ss+22s+8 Phase margin; PM=60° To Find out We have to design a phase lead compensator and also…

Q: What type of timing relay is this print drawn up for? a On-Delay, Pneumatic b…

A: Given circuit shows ladder diagram of motor control There are two motors M1 and M2 Timing relay is…

Q: The three-phase average power rating of the central processing unit (CPU) on a mainframe digital…

A:

Q: 2.5. A 16 load draws 10 kW from a 416-V line at a power factor of 0.9 lagging. (a) Find S = P + jQ.…

A: In this question we need to find the following Find complex power  Magnitude of load current…

Q: The total inductance for this circuit is The total inductance for this circuit is The total…

A:

Star Delta Conversion

Find the input resistance between points A and B of the following resistive network: