b) For a transmission line of 500 km length, show that V, = VR c) Construct the relevant circuit of the vector diagram as depicted in the Figure 3c given below. Also, explain the phenomenon and its solutions for a three phase transmission line of 700 km long.

b) For a transmission line of 500 km length, show that V, = VR c) Construct the relevant circuit of the vector diagram as depicted in the Figure 3c given below. Also, explain the phenomenon and its solutions for a three phase transmission line of 700 km long.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Transmission Line is connected in Nominal-Pi Circuit. Select one: True False

Q: Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line…

A: GMR stands for geometric mean radius which is also known as self GMD it is mean of the distance of…

Q: Q4 Suppose the voltage waveform shown in Figure Q4a was observed at the sending end of a 50 2…

A: Note: Since we solve up to 3 subparts, we are solving here part(a) and its subparts (i), (ii) and…

Q: A 15-km, 60Hz, single phase transmission line consists of two solid conductors, each having a…

A: Given data: The given loop length=15×103m Total inductance use formula L =15×103μπlogeDr+μi4π…

Q: A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function…

A: First calculate the wavelength of the signal by measuring the distance between two peaks.

Q: An air co-axial transmission line has a solid inner conductor of radius ‘a’ and very thin outer…

A: In the given question co-axial cable is having an inner radius "a" and outer conductor radius "b"…

Q: A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line…

Q: Q1: a) Discuss the effect of earth on the capacitance of a line : b) Derive in expression for the…

A: (a) The earth can be considered as a conducting infinite equipotential plane. The electric flux…

Q: is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the dielectric…

Q: :State the primary transmission line constants and talk briefly about them.

A: The explanation is as follows.

Q: A Three-Phase, 180 KV, 75 Hz Transmission Line consists of 1.2 cm radius conductors spaced at 2.4…

Q: 1/In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit.…

A: According to the question we have to discuss about transmission line simulator,the Transmission Line…

Q: Q2. A 3-phase, 132 KV, 50 Hz, 100 Km, single circuit bundle conductor transmission line as shown in…

Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three - phase…

A: Inductance per km is determined as shown below

Q: Q4. A 3-phase, 60 Hz, 500-kV transmission line is 300 km long. The line inductance is 0.97 mH/km per…

Q: A single-phase transmission line is composed of two solid round conductors having a radius of 0.45cm…

A: In this question we need to find the value of the inductance per conductor and the inductance of…

Q: One circuit of a single-phase transmission line is composed of three solid 0.5 cm radius wires. The…

A: Inductance | phase | m L=2×10-7 ln(DmDs) H|m For conductor 'x' Dm = (D11' D12')×(D21'…

Q: A 3-phase transmission line using 20 mm diameter conductor. When these conductors are placed at the…

A: As per the guidelines of Bartleby we supposed to answer first question for remaining questions we…

Q: The arrangement of conductors of a single-phase transmission line is shown in Figure wherein the…

A: According to the question we have to calculate the inductive reactance of the line.

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: 1..>>Capacitance of line without effect of ground Radius of conductor is 0.4cm Distance…

Q: What is the justification in neglecting line capacitance in short length transmission lines?

Q: The capacitance per unit length and the characteristic impedance of a lossless Transmission line are…

A: It is given that, the capacitance per unit length and the characteristic impedance of a lossless…

Q: A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic…

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: 7. Does the length of an ac transmission line affect the values of the characteristic impedance and…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: A 3-phase, 60 Hz, 600 kV, lossless transmission line is 600 km long. The line inductance is 2…

A: Given- VL-L=600 kVf = 60 HzL = 2 mH/km/phaseC = 20 nF/km/phase To Find- Phase constant Surge…

Q: State the secondary transmission line constants and talk briefly about them.

A: According to the question we have to State the secondary transmission line constants and talk…

Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three- phase…

A: Given, r=1.2 cm d1=7.5 mD=42+0.752=4.07 md2=42+7.5+0.752=9.17 md3=82+7.52=10.97 md4=7.5+0.75+0.75=9…

Q: In a three-phase transmission line with a length of 150 km, a voltage of 250 kV and a frequency of…

Q: In which Transmission Line classification is Capacitance negligible in its Equivalent Circuit? A.…

A: Short Transmission Line Only In short transmission line capacitance is negligible because of small…

Q: Calculate the weight due to ice on a transmission line where the Total weight of conductor = 3.6…

Q: 4.6. One circuit of a single-phase transmission line is composed of three solid 0.5- cm radius…

A: Given arrangement of conductor assume it is conductor x and y Radius of conductor x is = rx Radius…

Q: 2. A 15-km, 60Hz, single phase transmission line consists of two solid conductors, each having a…

Q: sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of…

Q: Find the characteristic impedance and signal velocity for a transmission line consisting of two…

A: Given: A transmission line consisting of two parallel strips with a width ω and a separation d.…

Q: The transmission line has the following data weight of the conductor = 6.4 kg/m, Tension in the…

A: The correct answer is 63.04 m sag is given bys=wl28T In the above equation l=Distance between tower…

Q: b) In your own words, define the "skin effect" in transmission lines and discuss how can it be…

A: Skin effect: The non uniform distribution of current through the conductor caused to non uniform…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

Q: In medium transmission line, capacitance is considered as O a. Lumped parameter O b. Distributed…

A: Given : Generally depending on the type of the medium we classify them parameters. Distributed…

Q: Q3: Derive an expression that defines the propagation constant y starting from the basic…

Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three- phase…

Q: "In medium transmission line modeling, which of parameter is considered to be lumped?" Resistance…

A: In this we will write about medium transmission line modelling...

Q: Suppose the voltage waveform shown in Figure Q4a was observed at the sending end of a 50 Q…

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: Return loss for a transmission line in terms of its reflection co efficient is given by:

A: The return loss is a parameter that is used to measure the amount of energy that is reflected back…

Q: What is meant by transmission line and Attenuation in transmission lines and why it is happen?…

A: Transmission line A transmission line is a specialized structure designed to conduct…

Q: Following are types of Transmission Lines EXCEPT A. Medium Line B. Long Line

A: In this question we will answer of transmission line questions....

Question

It's urgent please solve asap.

b)
For a transmission line of 500 km length, show that V, = Vr|
elsoofte-jsoof
c) Construct the relevant circuit of the vector diagram as depicted in the Figure 3c given below.
Also, explain the phenomenon and its solutions for a three phase transmission line of 700 km
long.
Ic*X
Ic
Ie*R
Figure 3c

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4 b)

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3: A single circuit three-phase transmission line is composed of four ACSR conductors per phase with the horizontal configuration as shown in the figure below. Find the inductance per km length of the transmission line. The radius of each conductor in the bundle is 1.25 cm. O0.5 m Q0.5 O0.5 m 4 m
One circuit of a single-phase transmission line is composed of three solid 0.5 cm radius wires. The return circuit is composed of two solid 2.5 cm radius wires. The arrangement of conductors is as shown in the following figure. Applying the concept of GMD and GMR, find the inductance of the complete line in mH per km. 5 m 5 m 10 m 5 m Conductor X Conductor Y
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
"In medium transmission line modeling, which of the parameter is considered to be lumped?" Resistance Inductance Capacitance All options are correct
Solve this math : A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line. Note: In the below i have added similer type of math and its ans.In the above math, there is just changes of values and Main Change is ACSR ROOK which is given to then question and in the below question which is solved it was ask ACSR Parakeet. So notice that. Follow This Book for help"POWER SYSTEM ANALYSISAND DESIGN;FIFTH EDITION, SI;J. DUNCAN GLOVER" Now solve the math according to the given way solve the math. "A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 25…
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determine the inductance of the line in millinery’s per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
g) Why the Capacitance effect is neglected in Short Transmission Line. h) Distinguish between Lumped or Distributed elements in a Transmission Line.
The impedance of the 500 km long transmission line is Z = 0.1 + j * 0.4 ohm / km. At the end of the line, 988.1 A current is drawn under 400 kV interphase voltage. The angle of the current is -68. It is 6 degrees. With the short transmission line equations, the amplitude value of the phase neutral value of the busbar voltage to which the generator at the beginning of the line is connected is given correctly. A) 231.34 B) 52.35 C) 400 D) 380.28 E) 388.57
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determiņe the inductance of the line in millihenrys per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
g) Why the Capacitance effect is neglected in Short Transmission Line.