Before investigating the scene, the technician must dilute the luminol solution to a concentration of 4.00x10-2 M. The diluted solution is then placed in a spray bottle for application on the desired surfaces. How many moles of luminol are present in 2.00 L of the diluted spray?

Before investigating the scene, the technician must dilute the luminol solution to a concentration of 4.00x10-2 M. The diluted solution is then placed in a spray bottle for application on the desired surfaces. How many moles of luminol are present in 2.00 L of the diluted spray?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter8: Sampling, Standardization, And Calibration

Section: Chapter Questions

Problem 8.14QAP

See similar textbooks

Similar questions

> EL session.masteringchemistry.com MasteringChemistry ROSTER-2019-SPRI-PULLM-CHEM-101 blackboard wsu Google Search MasteringChemistry: HW 8 KHW 8 Applications for Dilution Calculations K8 of8 Dilution as a procedure in analysis We sometimes purposely dilute solutions if the analyte concentrations wavelengths in the visible (and sometimes uitraviolet) range. Based on the dissolved solute's properties, we can quantify that solute's concentration are too high to permit an accurate measurement. For example, a spectrophotometer can measure the amount of light that passes through a sample solution for If the solute's concentration is too high, a relatively small amount of incident light having the wavelength that corresponds to the solute's absorption behavior will less light is absorbed, and the detector in the spectrophotometer can generate more reliable data. reach the dete ctor, which results in an inaccurate measurement (consider the result if you blocked the light with an opaque…
The purpose of digestion process in gravimetric analysis is to: 1. O decrease the particle size of the precipitate 2. O evaporate the solvent 3. O dry the precipitate 4. O coagulate the precipitate
To /bbhosted.cuny.edu/webapps/assessment/take/launch.jsp?course_assessment_id%3_2032634_1&course_ id= 201483.. Remaining Time: 1 hour, 09 minutes, 31 seconds. * Question Completion Status: A student makes a solution by dissolving 25.4 g of NaOH into 450 g of water. What is the mass percent (m/m) concentration of this solution? QUESTION 4 13.9 g Sodium sulfate (Na2SO4) has a solubility of in water at 20 °C. Which of the following mixtures will yield 100 mL a saturated solution at this temperature?. O 0.50 g of Na,SO4 in 1.0 mL of water O 125 g of NazSO4 in 1.0 L of water O 0.50 g NazSO, in 100 mL of water O 4.3 g Na,sO, in 100 mL of water O 17 g of Nazs04 in 0.500 L of water Click Save and Submit to save and submit. Click Save All Answers to save all answers. Save All Answers re to search 50°F Mostly sunn DELL DII home prt sc F10 F1 end inse F3 FS F9 F12 %23 %24 3 4. 5 7 8. Y D R E
< Week 8-1 X Week 8-1 X C 2 https://app.101edu.co K Formula Bara | PDF: SIF: Caf + 1 - 131 Sunny A Z "7 S ALEKS-13 x A ALEKS-Ti A ALEKS-TX Week 8-1 X m X Ksp 1.7 x 10. 36 x 10 - 4.3 x 10 3.5 x 10- x - Exam No.: x co DESU Calc X(427) mam xLog In | Fe x # Q Search Question 8 of 16 Which of the following salts would have the greatest solubility in water? _____________ __________ S L hp الالا alt A) BaF₂ B) PbF₂ C) SrF₂ D) CaF₂ ال A ctri لا pause < G Aktiv Chen a backspace X ● ه به enter GWhich oft X+ 3 T ما دیا ... T shift end 1 7 home 1 A ے h 1:0
A 1.59 g sample containing KI was analyzed gravimetrically and 0.0538g of Barium Iodate was recovered... express the results of this analysis as percent posassium iodide.
) - O + 88 www-awu.aleks.com Files Lecture 16 - The Punic... Rhetorical Analysis Essa... Journal Assignment: Pre... Document3.docx ALEKS - Anniston Stovall... b Answered: One way the... O CHEMICAL REACTIONS Anniston V Solving for a reactant in solution 1/5 One way in which the useful metal copper is produced is by dissolving the mineral azurite, which contains copper(II) carbonate, in concentrated sulfuric acid. The sulfuric acid reacts with the copper(II) carbonate to produce a blue solution of copper(II) sulfate. Scrap iron is then added to this solution, and pure copper metal precipitates out because of the following chemical reaction: Fe(s) + CUSO 4(aq) Cu(s) + FeSO4(aq) Suppose an industrial quality-control chemist analyzes a sample from a copper processing plant in the following way. He adds powdered iron to a 100. mL copper(II) sulfate sample from the plant until no more copper will precipitate. He then washes, dries, and weighs the precipitate, and finds that it has a mass of…
THE QUESTION IS AT THE PICTURE... 2 QUESTIONS ONLY.. AND THE GIVEN PROBLEMS IS THE ONE I TYPED........ATTACHED PHOTO IS MY ANSWER BUT PLEASE CORRECT ME IF I AM WRONGA. Concentration1. Place 3 mL each of 6N, 3N, & 1.5N hydrochloric acid in separate test tubes.2. Drop simultaneously equal lengths (about 1cm) of magnesium ribbon and note thetime it takes for the magnesium to dissolve in each use.B. Surface Area1. Weigh a small iron nail to the nearest hundredths of a gram and weigh an equalamount of iron fillings.2. Place them in a separate test tubes.3. Add simultaneously 3 mL of 3N hydrochloric acid and compare the rates of reaction.C. Temperature1. Place 5 mL each of 0.1N sodium thiosulfate solution into 5 test tubes.2. Place all five test tubes in the water bath and let it stand for 1 minute.3. Record the temperature of the water bath. Remove the first test tube from thewater bath and place it in the test tube rack.4. Add 1 mL of 0.1M sulfuric acid and stir with a glass rod.…
Aktiv Chemistry → C < + app.101edu.co b Answered: A student combined [ENG SUB] I Belonged To You X + Time's Up! What quantity in moles of NH, are there in 70.3 mL of 0.200 M NH₂? 3 1 4 7 +/- G 0.0735 mol 2 3 5 8 6 9 =S 0 Submit X C x 100
THE QUESTION IS AT THE PICTURE... 2 QUESTIONS ONLY.. AND THE GIVEN PROBLEMS IS THE ONE I TYPED............. PLEASE TYPE YOUR ANSWER PLEASE....A. Concentration1. Place 3 mL each of 6N, 3N, & 1.5N hydrochloric acid in separate test tubes.2. Drop simultaneously equal lengths (about 1cm) of magnesium ribbon and note thetime it takes for the magnesium to dissolve in each use.B. Surface Area1. Weigh a small iron nail to the nearest hundredths of a gram and weigh an equalamount of iron fillings.2. Place them in a separate test tubes.3. Add simultaneously 3 mL of 3N hydrochloric acid and compare the rates of reaction.C. Temperature1. Place 5 mL each of 0.1N sodium thiosulfate solution into 5 test tubes.2. Place all five test tubes in the water bath and let it stand for 1 minute.3. Record the temperature of the water bath. Remove the first test tube from thewater bath and place it in the test tube rack.4. Add 1 mL of 0.1M sulfuric acid and stir with a glass rod. Record the time it takes…
A prod01-cnow-owl.cengagenow.com -Content C OWLV2 | Online teaching and learning resource fr... Fool Car note CAU EMAIL CANVAS Pirate Ship MYJSCC BLACKBOARD Vacancies | A... Birmingham New NCO [Review Topics] [References] Use the References to access important values if needed for this question. The mass of barium phosphate that is dissolved in 175 mL of a saturated solution is grams. Submit Answer Retry Entire Group 5 more group attempts remaining DEC 3 tv 3
Course Contents... LA Problem Set Unit 5 Q10 Elemental analysis is performed on an organic liquid with a fishy odor. Vaporization of 260.0 mg of the compound in a 140 mL bulb at 130°C gives a pressure of 430.0 torr. What is the molar mass of this compound? Submit Answer Tries, 0/99 M CAL 8:00- esc This discussion is closed. 10:50- A CI 12:00 1 Q ! www 16. FI S OCT 2 21/ @ W 2 F2 C 43 # E 80 F3 $ 4 R a F4 er de % 5 T ↓ FS ^ 6 Y tv A MacBook Air Fó & 7 © U * F7 * +00 8 I DII FB ( 9 DD F9 0 O ) 0 Timer P F10 Notes 3 F11 Evaluate +11 = A F12 Feedback Send Feedback delete
Q1: What is the density (g/ml) of a 3.6M Sulfuric acid solution that is 29% H,So, by mass (Mwt. = 98)? Q2: Fill the blanks with suitable answers 1: The is the thing being dissolved. ......... 2: The branches of quantitative analysis are and 3. The filterability of the precipitate depend on the of practices. Q3: Which one is correct? 1. Molality changes with temperatures. 2. Molality does not change with temperatures. 3. Molarity changes with temperatures. 4. Normality changes with temperatures. Q4: What weight of pyrite ore (impure FeS,) must be taken for analysis so that the BaSO, precipitate weight obtained will be equal to one-half that of the percent S in the sample? Note: Mwt. of Ba =32, Mwt. of BaSo4 =233, Mwt. of FeS, =119