Consider a classroom for 55 students and one instructor, each generating heat at a rate of 100 W. Lighting is provided by 18 fluorescent lightbulbs, 40 W each, and the ballasts consume an additional 10 percent. Determine the rate of internal heat generation in this classroom when it is fully occupied.

Consider a classroom for 55 students and one instructor, each generating heat at a rate of 100 W. Lighting is provided by 18 fluorescent lightbulbs, 40 W each, and the ballasts consume an additional 10 percent. Determine the rate of internal heat generation in this classroom when it is fully occupied.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 27RQ: How many Btu/h would be produced in a 12-kW electricheater?

See similar textbooks

Similar questions

8. Four 20-watt lamps and two ½ - hp motors of the forced-draft evaporators are installed inside a refrigerated space. The lamps are usually switched on 16 hours per day. Calculate the heat load component of the lamps and the motors, in Btu/day.
Determine the maximum amount of heat that can be supplied to the room if this heat from the radiator is supplied to a heat engine that is driving a heat pump. Assume the heat engine operates between the radiator and the surroundings.
If a house needs a minimum heat transfer rate of 75 kJ/h (i.e., 75 kJ of heat needs to be transferred into the house during one hour) to maintain a pleasant indoor temperature. If one wants to use a heat pump with a COP of 5.55 to fulfill this heat transfer rate, what is the corresponding electricity (in kWh) consumption to run such a heat pump for one hour?
You need an apartment for rent and as shown in the figure, you can see that the 3rd floors of each of the 2, 3 and 4 blocks of the buildings, whose front faces are adjacent, are for rent. You also learn that Block 2 is heated by a coal boiler operating at 75% efficiency, Block 3 is heated by a natural gas boiler operating at 92% efficiency and Block 4 is heated by a heat pump with a COP (coefficient Of Performance) of 4.5. We know that the heating process takes place uninterruptedly for 150 days, during these 150 days, the interior of the apartment remains constant at 22 °C. average outside temperature T∞ = 0 °C and average of wind speed u* = 5 m/s Find the total heating cost for all three blocks. The average heat transfer coefficient in apartment is h inside = 10 W/m2K thermal resistance of the wall Rwall = 1 m2K/W Assume that heat is lost only from the front and back of the blocks. In addition, the electricity unit price of 0.71 $/kWh, natural gas unit price of 0.14 $ / kWh, unit…
A homeowner in Allentown, PA installs a 60° south-facing solar collectorthat (on the average over the year) replaces 1 kW of electric heat (purchased from thepublic utility at $0.11 per kWh). The homeowner is considering adding a trackingmechanism to maintain perpendicular alignment of the collector with the solar insolation.If the payback period for the upgrade is expected to be five years, what should thehomeowner be willing to pay for the tracking device?
ASAP
1. A geothermal heat pump with a COP of 1.3 provides 48000 BTU/hr of heat to a building. Assuming an electrical power rate of $0.20/kWh. answer the following questions for this system: a. What would be the monthly cost to provide heat at a rate of 48000 BTU/hr if the heat was delivered by a simple electrical resistance heater? b. How much heat is drawn from the ground by the heat pump in that month, in kWh? c. What is the savings per month enjoyed by operating this heat pump for a month vs. a simple electrical resistance heater?
14. A classroom that normally contains 40 people is to be air-conditioned with window air- conditioning units of 5- kW cooling capacity. A person at rest may be assumed to dissipate heat at a rate of about 360 kJ/h. There are 10 light bulbs in the room, each with a rating of 100 W. The rate of heat transfer to the classroom through the walls and the windows is estimated to be 15,000 kJ/h. If the room air is to be maintained at a constant temperature of 21°C, determine the number of window air-conditioning units required.
A room is heated by an iron that is left plugged in. Is this a heat or work injection? Take the entire room, including the iron as the system.
3. A classroom that normally contains 40 people is to be air-conditioned with window air-conditioning units of 5-kW cooling capacity. A person at rest may be assumed to dissipate heat at a rate of about 360 kJ/h. There are 10 light bulbs in the room, each with a rating of 100 W. The rate of heat transfer to the classroom through the walls and the windows is estimated to be 15,000 kJ/h. If the room air is to be maintained at a constant temperature of 210C, determine the number of window air-conditioning units required. draw a figure also, and explain each step by step solution.
A homeowner is trying to decide whether to heat with a furnace rated at 95% efficiency or by an electrically powered heat pump. She lives in a town where electricity is produced by a coal-fired power plant that claims to operate with 1st law efficiency that is 55% of the Carnot limit. The heat pump's CoP is advertised to be 40% of the Carnot limit. For what range of outside temperatures To would the 2nd law efficiency of the furnace be greater than that of the heat pump? Assume T+ = 400°C, T- = T= 40°C. %3D
A solar pond power plant produced power output at 350 kW and thermal efficiency of 4%.Sketch the schematic diagram of the system and determine the rate of solar energy collected.