Consider the following statements: 1-The effect of feedback is to reduce system error. 2-Feedback increases the system gain at one frequency but reduces the system gain as another frequency. 3-Feedback can cause an originally stable system to become unstable . Which of the above statements are correct? * O 1, 2, 3 1,3 O 2, 3 O 1,2

Consider the following statements: 1-The effect of feedback is to reduce system error. 2-Feedback increases the system gain at one frequency but reduces the system gain as another frequency. 3-Feedback can cause an originally stable system to become unstable . Which of the above statements are correct? * O 1, 2, 3 1,3 O 2, 3 O 1,2

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.3P

See similar textbooks

Similar questions

Construct the signal flow graph for the following set of simultaneous equations: X₂ = A21 X₁ + A23 X3, X3 = A31 X1 + A32 X2 + A33 X3, X4 = A42X2 + A43X3. Identify the (a) input node, (b) output node, (c) forward paths, (d) feedback paths, and (e) self-loop.
3- The purpose of negative feedback is to a. Reduce the number of components in an amplifier c. Improve the gain and bandwidth of an amplifier b. Increase the transistor life d. Limit the amplifier output.
77.One condition for positive feedback is that the phase shift around the feedback loop must be _______°. 76.In order to start up, a feedback oscillator requires A. positive feedback greater than 1. B. unity feedback equal to 1. C. no feedback. D. negative feedback less than 1. 75.A circuit that can change the frequency of oscillation with an application of a dc voltage is sometimes called A. an astable multivibrator. B. a voltage-controlled oscillator. C. a crystal oscillator D. a Hartley oscillator 74.Which of the following is required for oscillation? A. The phase shift around the feedback network must be 180º B. None of the above C. ßA > 1 D. Both ßA > 1 and the phase shift around the feedback network must be 180º.
Ques 2: What is the Voltage series feedback? Explain the effect of feedback on gain and input, outputimpedance
D O Question 10 The Nyquist plot for the plant (with gain K Imaginary Axis 08 06 04 02 02 04- 06- Et 11 = 1) is given below. (15) G(s) = = 8²-58-4 2(8²+58+6) Nyquist Diagram E 17°C
Which of the following is a characteristic of the feedback function? Select a Choice Below A It is based on analysis and evaluation of processes without affecting output. B It influences the future direction of a system. C It allows for miscalculations to be concealed to reflect perfect data. D It affects processing and output in a system directly.
a- Zero. b- Slightly different from zero. O Maximum positive or negative. d- An amplified sin wave. 9-Negative feedback reduces @ The feedback fraction. b- Distortion. c- The input offset voltage. d- The open-loop gain. 10-The input impedance of a current-voltage converter is Small. b- Large. c- Ideally zero. d- Ideally infinite. a- 11-In a linear op-amp circuit, the @ Signal are always sin wave. b- Op-amp does not go into saturation. c- Input impedance is ideally infinite. d- Gain-bandwidth product is constant.
3. An ideal shunt-shunt feedback amplifier has Rs =∞. If li= 100 microAmp, I fb = 99 microAmp and Vo = 5V determine: a. Az, Bg and Azf, (including the units) b. Rif & Rof if Ri= 5 Kohm & Ro = 4 Kohm.
The voltage gain of an amplifier is 3000 when no feedback is applied. When negative feedback is applied and feedback factor is 0.01, then estimate the gain with feedback.
3) The region where an amplifier is operating in a linear format is represented by: a) The positive feedback b) The common feedback c) The negative feedback 4) For oscillator operation the noise traveling around a loop, then being amplified as converging on a sine wave at: a) Two different frequencies b) Several frequencies c) Single frequency
For the given four statements below, which of the following are not correct about an op-amp with negative feedback arrangement? i. Negative feedback reduces the gain of the op-amp circuit to desired value. ii. Negative feedback takes portion of the output and applies it back in-phase with the input. iii. Negative feedback controls the voltage transfer characteristic of the op-amp circuit. iv. Negative feedback maintains the oscillations. i and ii O i and iv iii and iv O i and iii
2-Discuss briefly the effect of both types of feedback on input and output impedance