Determine the alkalinity and total hardness of given water sample IonConcentration, mg/L Atomic WeightCa**6040Mg*3024.31HCO;40061

Following are the given concentration of the ions in the water sample: Ion Concentration, mg/L…

Answered: Determine the alkalinity and total…

Engineering

Civil Engineering

Determine the alkalinity and total hardness of given water sample

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter15: Experimental Methods

Section: Chapter Questions

Problem 1CQ

See similar textbooks

Related questions

Q: Calculate the carbonate and non-carbonate hardness of the given water sample.

A: Following are the given concentration of the ions:

Q: Why are the sum of the anion concentrations and the sum of the cation concentrations are not…

A: Brief concept introduction- Cation ions- These are the positive ions. For water, cations are H+…

Q: ncentration of 100 mg/L using a settling column was carried out in a oratory. The results of the…

A: Given - L = 45 M B= 12 m Q =8.1 MLD =8.1×106 LD Q =8.1×103 m3/sec24×60×60 Q=0.09375…

Q: Following data are given for water sample taken from irrigation water: [Na+] = 250 mg/ml [Ca2+] =…

Q: A sample of water was analyzed through titration with 0.01 N HCI. 150 ml of the water required 30.0…

A: Alkalinity is defined as the ability of water to neutralize acids. Alkalinity is caused by hydroxyl…

Q: Amount of organic suspended sediment is one of the chemical properties for irrigation water that…

A: The amount of organic suspended sediment is one of the chemical properties for irrigation water that…

Q: e moisture content of a sludge is 95% with a volume of 1000 m3. If the volume of dewatered dge is…

Q: A groundwater sample was found to contain 500 mg/L total dissolved solids (TDS). TDS (in %) present…

A: TDS is the measure of sudpended and dissolved solid in water. It is generally measured in mg/l or…

Q: Find the dry density and the total density in the laboratory with a porosity of 0.32, a moisture…

A: Given data- Porosity n =0.32 Water content (w)= 0.25 Specific gravity (Gs)=2.7 To find- Dry density…

Q: Fresh sludge has moisture content of 99% and, after thickening, its moisture content is reduced to…

A: Given- For fresh sludge- moisture content- w1=99%, For thickened sludge- moisture content- w2=96%.…

Q: Calculate chloride (mg/L as CF) content of the water sample.

Q: The data from a standard Proctor test are shown in the table below. a. Determine the maximum dry…

A: Diameter of mould (d) = 101.4 mm height of mould = 116.7 mm mass of mould = 4196.50 gm specific…

Q: lon mg/L as ion Ca2+ 80.98 Mg2+ 20.55 Na+ 30.79 НСОЗ 235.48 33.55 55.67 CO2 20.05 [Hints: Step…

A: given question, total hardness =total hardness=Ca2+ in mgequivalent weight of Ca2+×equivalent…

Q: Determine the total alkalinity and total hardness for the following sample. Ion |Concentration, mg/L…

Q: A soil has a liquid limit of 40% and plasticity index of 20%. The plastic limit of the soil will be…

A: Given data : Liquid limit (L.L)=40%Plasticity index (IP)=20%

Q: . The difference between the free water levels in two wells 48 m part in an aquifer is 0.6m. It took…

Q: tank

Q: 1. If concentration of Na+, Cat+ and Mg++ in a water sample are 345, 60 and 18 mg/I respectively,…

Q: In activated sludge system, SRT is governed by

A: Activated sludge system:

Q: The concentration of dissolved oxygen in a sample of waste water decreases from 9 x 10^3 g/L to 6.2…

A: Given data, Initial Concentration of DO = 9×103 g/l Final Concentration of DO = 6.2×103 g/l Number…

Q: The Langelier Index is an approximate indicator of the degree of saturation of calcium carbonate in…

A: fACTOR NOT Taken into account while comuting is langelier index is water turbidity

Q: Determine the effective size (d10, in mm) and the uniformity coefficient (UC) for the sand filter…

A: Sieve no. And percentage wt.passing is given and finding out D10 and coefficient of uniformity.

Q: In a laboratory test of an aquifer materia fully saturated sample of volume 5 liters was taken and…

A: Given:- V=5litres W=97N To find:- unit weight of water =9.79kN/m3 To find:- specific yield and…

Q: A laboratory provides the following analysis obtained for a wastewater sam Total Solids = 200 mg/L…

A: GIVEN DATA:- TOTAL SOLIDS OF SAMPLE=200 MG/L TOTAL SUSPENDED SOLIDS OF SAMPLE=160 MG/L FIXED…

Q: (c) An analysis of a water sample has produced the following concentrations, as shown in Table 1(c).…

Q: Microbial growth in an activated sludge system can be described by the Monod model. If the maximum…

A: µ=specific growth rate = .6 day-1 µmax=maximum value of μ = 1.2 day-1 KS=saturation constant =…

Q: the DO meter showed a concentration of 8.8 mg/L. m RPD of 9% what is the saturation concentration c

A: Given:- concentration=8.8mg/L Maximum RPD=9% To find:- saturation concentration

Q: c) An analysis of a water sample has produced the following concentrations, as shown inTable 1(c).…

Q: Water quality and characteristics discuss: 1. Organoleptic parameters 2. Nitrate 3. Solids

A: 1) Organoleptic Parameters- These are defined as the parameters in which results are obtained after…

Q: The lab apparatus shown in the figure maintains a constant head in both the upper and lower…

Q: Search for reliable sources and identify how the water sample can be classified in terms of its…

A: Source of the hard water: The natural source of the hard water is sedimentary rocks which has…

Q: The hydraulic conductivity (K) of a homogeneous sandy clay mix aquifer is 2x10-3 cm/sec. The…

Q: Water analysis was carried out for a groundwater sample. The sum of the anions is equal to the sum…

Q: Using kinetic equation, estimate sludge age (SRT) based on the following conditions: saturation…

Q: 1. In a total solids determination on a 100 ml sample of river water the following results were…

A: My dear, We are given with Weight of empty dish after firing Weight of dish + weight of dry…

Q: Please make presentation about this question How to determine chlorides in a water sample.?…

Q: Calculate the carbonate hardness of the given water sample.

A: Following are the given concentration of the ions:

Q: The sample of substance has a moisture of 13%. weights 800 gm and has bulk density of 1.4 gm /cm.…

Q: 5. For a constant head laboratory permeability test on a fine-sand, the following values are given:…

A: L=10in t=2min H=22in

Q: A falling-head permeameter contains a sample of length 10 centimeters a centimeters. The…

A: Given:Sample length, L=10 cmSample diameter, d=4 cmInside diameter of tube=1 cmTemperature of water,…

Q: (c) An analysis of a water sample has produced the following concentrations, as shown in Table 1(c).…

Q: the field, the total volume was 1150 cubic centimeters, the total mass was 2290 grams, and the…

Q: Q2. A settling tank sludge sample is tested for solids. The sample and the dish weight (74.69) g,…

A: Given that: Weight of sample and dish, w1=74.69gWeight of dish, w2=21.2gWeight of…

Q: The analysis of water quality from an artesian well presented the result Alkalinity at bicarbonates…

A: Given data in question Concentration of calcium and magnesium Equivalemt weight of calcium and…

Q: A sample of water from a surface stream is analyzed with the following results: Calcium = 98 mg/L,…

Question

100%

Determine the alkalinity and total hardness of given water sample

Ion
Concentration, mg/L Atomic Weight
Ca**
60
40
Mg*
30
24.31
HCO;
400
61

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Material structure and physical properties

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Analyte the beam as showen in fig. by MPM. DAam BMD. assume EI: Coustont. 20KH/m 250KN A 12m 12m 4m 4m
IR R. 220 2 c.1 Determine the range of values of Vi that will maintain the Zener diode in the "on" state. Refer to the figure in the right. Vz = 20 V IZM = 60 mA RL 1.2 k2 V %3D
In Figure below if a metlic c:ube of a 1 2 inch side length weighing 46 kg, floats at a two layer fluids mercury and sea water. Detennine the position of the block at mercury- water interface when it has reached equilibrium. (mass density of sea water ; 63.92623 lb/fts) and for mercurv : 845 lb/ftS).
solve very very fast in 15 min please
Solve the solutron 50 g He DE 4-54 %3D
(2) lakai * In fig. below i2= A 5V 100 10V 10v 3A 109
A metallic cube of 30 cm side and weighing 500 N is lowered into a tank containing two fluid layers of water and mercury. Top edge of the cube is at water surface. Determine the position of block, at Water-Mercury interface when it has reached equilibrium. (30-1) Water Interface Mercury
9:16 A
9. For the circuit shown in figure find (a) The resonant frequency o (b) Zin(@) Lin ww ΙΩ ele 9 μF 20 mH 0.12
Which of the following best describes a Venturi Meter? an opening having a closed perimeter in a wall or partition used for measuring flow of fluids are flow measurement instruments which use a converging section of pipe it can be used to measure fluid flow velocity by converting Kinetic Energy to Potential an opening in a dam or other Ohydraulic structure to control the passage of water Trapezoidal weir with side slope of 1 horizontal to 4 vertical Suttro Weir V-Notch Weir Cipoletti Weir Contracted Weir
Include proper explanation this is fluid mech problem
the most common used infiltrometer A single ring B double ring c tube-type infiltrometer D lysimeter