difference between sensors and detectors.
Q: Q3) if R(S) is input and CCC) is output given syste as X ($) R. ($) - LX(S) S Z($) = X($) +Y(S) C($)…
A:
Q: 2. Given ID= -4mA at VGs=-2V, determine loss if Vp=-5V. a.11.11mA b.22.22mA c.33.33mA d.44.44mA
A: We need to select correct option for given current and voltage
Q: Determine the thermal voltage for a diode at a temperature of 20°C
A: The thermal voltage of the diode is given by the expression as shown below: VT=kTqq=1.6×10-19…
Q: The intrinsic stand-off ratio for a UJT is 0.65. If the interbase resistance is 10 kΩ ,find the…
A: UJT is the uni-junction transistor it is the three terminal device that are used to gate pulse,…
Q: convert the transfer functions into linear differential equations: a) 1/(1.896s+1) b)…
A: Given data : Transfer functions are (a). 1(1.896s+1) (b)130.19(s2+8.22s+130.19)
Q: an amplifier with a noise temperature of 125k and gain 20db is connected to another amplifier with a…
A: An noise figure is the increase of the noise power of the system from the input of the system to the…
Q: The parameters in the circuit in Fig. P14.33 are R = 2.4 k, C = 50 pF, and L = 2 μH. The quality…
A: Given: Consider the following figure: The parameters in the circuit in the figure are: R=2.4 kΩC=50…
Q: Simplify the following block diagram. 63 G, ܣܩܟ H1 G4 H 62
A: Given data, Block diagram is given as,
Q: If vi(t) is a step voltage in the network shown find the value of the resistor such that a 25%…
A:
Q: he efficiency, at unity p.f. of a 6600/384 V 200 KVA, 1-phase transformer is 98% both at full load…
A: An single phase transformer has single phase inputs and single phase outputs. The demand for single…
Q: A conductor carries a current that is equivalent to a 5-amp continuous current in one direction and…
A: In a full wave rectifier that convert the complete cycle of AC into a pulsating Direct current. It…
Q: A single phase full-wave controlled rectifier using center-tap transformer is fed from a 230 V, 50…
A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…
Q: Find vl across the inductor
A:
Q: [t) 16.39 16.5. мее 1 H 292 i(t) 0.5
A:
Q: The reactance data for the given power system is as follows: Item X¹ X2X G₁ G₂ Ti T2 Line 1-2 0.10…
A: Per unit system is the provide the unit of the power, current, voltage, and admittance and two unit…
Q: (A) Consider the following system, Draw the Polar Plot for the open loop T 100 G(s) = (S+2)(S+4)…
A: Rules for Drawing Polar Plots- Substitute, s=jω in the open loop transfer function. Write the…
Q: Equipment for immersion cooling of electronic components has an installed value of $182,000 with an…
A: Immersive cooling is a method used for cooling electronic components, they are immersed in a…
Q: AXY flip-flop has four operations clear to 0, no change, complement and set to 1, when inputs X and…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: 46. In PNP BJT, ........current is highest current. a. Base. O b. Collector. O c. Source. O d.…
A: We need to select the correct option for current
Q: Find the Current Io. In figure (2). Чта 2mA Ika v Ika Iy 2 KA m In lkn Is • Is 6V 13 lkn 16mA
A: In this question, We need to determine the current Io as shown the circuit. We are solving this…
Q: H(s) = 4 s² +s+25 s³ +100s²
A: The given function is H(S) =4 S2+S+25S3+100S2
Q: A digital communication system uses a repetition code for channel encoding/decoding. During…
A: Concept: Probability for r number of success is given by CrnPr1-Pn-rwhere p is the probability of…
Q: Figure P14.33 R Vi C L Vo RL The parameters in the circuit in Fig. P14.33 are R = 2.4 k, C = 50 pF,…
A: The quality factor of the parallel RLC circuit is, QP=R2CL The quality factor of the above-loaded…
Q: 1. For the network given on Figure 44, determine the IpQ, VGSQ, VDs, and Vs. + VGSQ 18 V 2.2 ΚΩ IDQ…
A: We need to find current and voltage for given circuit
Q: Q2 If the unit step response of a network is (1 - e-at), then Find its unit impulse response
A: Unit step response is given by: y(t)=1-e-αt
Q: 3. From the circuit shown below, what should be the value of R1 for the circuit to have a gain of…
A: As per our company guidelines we are supposed to answer only first question kindly repost the other…
Q: 12. GIVEN THE CIRCUIT AS SHOWN, WHAT IS THE EXPECTED APPROXIMATE OUTPUT DC VOLTAGE IF DIODE D1 IS…
A: 12) To find the approximate output DC voltage if diode D1 is defective or open in the given bridge…
Q: a. IB. b. Ic c. VCE. d. Vc. e. VE- f. VB. g. VBC. For the emitter-bias network, determine: Vi 430 ΚΩ…
A: The fixed bias circuit can draw as There is typing mistake. Bias voltage can't be negative. I am…
Q: Consider a transmitter sending 4-bit codes at a rate of 64 kbps over a 4 kHz channel. the number of…
A: number of Fourier Harmonics can be transmitted = bit rate /(frequency * number of bits)
Q: R(S) 2s³+4s²+s+5 C(s) 3s4+7s3+2s²+3s+8' Given the transfer function G (s) write the corresponding…
A:
Q: In the resistance welding process, select the factor/s that contribute to accomplish coalescence:…
A: Resistance welding: Welding means joint the metals. In resistance welding, the current is applied to…
Q: Find the current I if: V₁=2V, V₂=1.5 V, R₁=20 KM2, R₂-10 K and R3=5 KM. V₂ V₁ R₁ R₂ ww R3 R₂ R₁
A: Given data :
Q: Find the Current Io. In figure (2). Чта 2mA IT Ika I2 I kn Iy 2ks m Io lkn. Is Fig.2 ) 6V Elkr 16 MA
A: The circuit given as
Q: For the multivariable system shown, find the transfer function T₁1 (s) = R₁(s) G₁(s) R₂(s)-> G4(s)…
A:
Q: A three-phase transmission line is designed to deliver 190.5 MVA at 220 kV over a distance of 63…
A: Dear student as per our guidelines we are supposed to solve only one question in which it should…
Q: A lossless T-junction power divider has a source impedance of 50 2. Find the output characteristic…
A: Characteristic impedance:- I is also called surge impedance. It is the ration of amplitude of…
Q: b) Derive the formula for total voltage and impedance for series RC circuit. Find the equation of…
A:
Q: Explain briefly various theories of breakdown in liquid dielectrics.
A: Transformers, circuit breakers, high power cables, and capacitors are all impregnated with liquid…
Q: Determine the value current supply (IT) in figure (1). Fig.1 lon Голі 55 u Гол Slov IT 24V VT
A: This question belongs to circuit theory . It is based on the concept of calculation of current in…
Q: 2. For the Network given on Figure 45, determine VG, VGS, ID, VDS, IE, IB, VD, and Vc. VG 91 ΚΩ 18…
A: Given: Consider the following network: To find: VG, VGSQ, IDQ, IE, IB, VD, VC
Q: Q2/ Find the input impedance for the circuit below Zja 10 Ω j12 Ω j15 Ω 20 Ω j40 Ω -j5 Ω
A: Coupling : Coupling means mutual inductance between a coil it is mainly of two types : electrical…
Q: For the circuit shown below, derive the amplifier gain. Vo V₂ - V₁ V₁ Find the current I if: V₁-2V,…
A:
Q: What is the velocity of an electromagnetic wave in free space?
A: In this case, the velocity of an electromagnetic wave in free space is to be determined.
Q: Find the Current Io. In figure (2). Чта 2mA Ika -m Ika Iy 2KA HA 12 lkn Is 13 lkn 6mA
A:
Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…
A: This problem comes under electrical network theory. It is about superposition theorem . Problem…
Q: Draw the graph of the voltage in the 1 K resistor of the circuit of figure Nº3, knowing that the…
A: This is the clamper circuit. Here we need to find the output voltage response w.r.t supply.
Q: according to the circuit determine the voltage, current and power of each resistance applying…
A: Given: Consider the following circuit: To find: Determine the voltage, current, and power of each…
Q: A digital communication system uses a repetition code for channel encoding/decoding. During…
A: From the question, it is given thatCrossover probability P=0.1We know that probability of error…
Q: The current in an inductor is changing at the rate of 72 A/s, and the inductor voltage is 34V. What…
A: This question belongs to circuit theory . It is based on the concept of induced voltage in…
Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…
A: In this question, We need to determine the current supplied by the voltage source using the super…
difference between sensors and detectors.
Step by step
Solved in 2 steps
- Cite some advantages of oscilloscope over analog/digital meters.Explain why the detector signal is negative1. How does speaker convert electrical energy to sound energy? 2. How does microphone convert electrical energy to sound energy? 3. How does antenna convert RF energy electrical energy? 4. How does thermistor vary the resistance with respect to temperature change?
- This type of detector is simple, convenient, highly sensitive and the application is widespread.If the load resistance in an envelope detector is doubled, will the charging time constant change or not?Solar collectors are devices used for converting solar radiation into O a. thermal energy O b. electromagnetic energy O c. kinetic energy O d. mechanical energy