Direction: Complete the table by writing all types of intermolecular forces (IMF) that will exhibit between the pairs of molecules. Pairs of molecules Type(s) IMF 1. O=C%3DO and O=C%3O 2. %3D and Na + H. PASI ON OF

Q: 20. Draw Lewis dot structures showing the formation of an ionic compound from each of the following ...

A: Lewis dot structure of given compounds are as follows

Q: (a) Choose the correct statement about density: O unit of density is g/L O compares the mass of an o...

A: The correct statement about density is given below

Q: The following elementary steps have been proposed to explain the gas-phase decomposition o itrous ox...

A: Given : We have to tell the rate law for the given reactions.

Q: Identify each element below. part a) i. [Ar]4s23d104p4 ______________________ ii. [Xe]6s24f145d2 ...

A: Since you have posted multiple questions with multiple sub-parts, we are entitled to answer the firs...

Q: Consider the gas-phase reaction of nitric oxide with hydrogen at 1280°C 2NO(g) + 2H2(g)→N2(g) + 2H2O...

A: The gas phase reaction of nitric acid and hydrogen at 1280 °C is given as 2 NO (g) + 2 H2 (g) → N2 (...

Q: 1. In classical Physics and general Chemistry, matter is any substance that has mass and takes up sp...

A:

Q: For a stoichiometric ethane-air reaction at 1 atm pressure and 1500 K, determine the fuel and CO2 co...

A:

Q: Determine the rate of formation of I3− if the initial concentration of I− was 0.5583 M and decreased...

A: The balanced reaction taking place is given as, => 3I−(aq)+ S2O82−(aq) ↔ I3−(aq) + 2SO42−(aq) Giv...

Q: Calculate the pH of 1.0×104M solution of HNO3. (Round to whole number).

A: Given : We have to calculate the pH of solution.

Q: 3. An empty 1.0 was filled with 5.0 moles of oxygen and 4.0 moles of nitrogen. If the amount of NO2 ...

A:

Q: Given that naphthalene is insoluble in water and sublimes easily upon heating, describe two methods ...

A: Given: naphthalene is insoluble in water and sublimes easily upon heating.  

Q: 3..Suggest how to make syndiotactic/isotactic polystyrene on the one hand and on the other hand how ...

A: Isotactic polymers have the side groups attached on one side of the backbone chain whereas the syndi...

Q: A sample of trifluoroacetic acid, C,HF,02, contains 25.3 g of fluorine. Calculate the mass of the tr...

A: One molecule of C2HF3O2 contains 2 atoms of carbon, 1 atom of hydrogen, 3 atoms of fluorine and two ...

Q: Give the IUPAC name of the compound below. Br Br

A:

Q: a) Propose a synthesis route to prepare 3-methylhexan-3-ol from pentan-2-one. Note that more than on...

A: For a synthesis of compound 3-methylhexan-3-ol from pentan-2-one in two step reaction we follow a re...

Q: Select the reagents you would use to synthesize the compound below from benzene. Use the minimum num...

A: The organic compound given is 

Q: Он

A:

Q: A stainless steel alloy is to be analyzed for its chromium content. A 3.30 g sample of the steel is ...

A: Given Mass of sample steel = 3.30 g volume of solution = 250 ml Mass of BaCrO4 = 0.145 g M.m (molar ...

Q: The alloy brass contains lead as an impurity in the form of lead sulphate (PbSO,). By dissolving bra...

A: Since you have asked multiple questions, we will answer only first question for you. In order to get...

Q: Find | grxn (in kilojoules) when 1.00 g of calcium oxide is reacted with 250 mL of water to form cal...

A: consider the given information, mass of calcium oxide = 1.00g volume of water = 250 ml the change in...

Q: A.) What volume of 8.4N Al(OH)3 will be used to prepare 350mL of 2.1M solution? B.) How many mL of w...

A: Given,  Initial Concentration = 8.4 N  Final volume, V2 = 350 ml  Final Concentration, M2 = 2.1 M 

Q: At which pH is most of the carbon species H2CO3? А. 2 В. 7 С. 10.33 D. 14 8. Which one is a better e...

A:

Q: when you mix 20ml sugar and 50ml water in a 250ml beaker, what is the volume of the sugar and water ...

A: Volume of mixture can be calculated from individuals volumes.

Q: Identify the Brønsted-Lowry acid, the Brønsted-Lowry base, the conjugate acid, and the conjugate bas...

A:

Q: Is the unusual dication below aromatic/non-aromatic/anti-aromatic? Anti-aromatic; the overlapping p ...

A: Aromatic compound:  Those molecules that follow the huckle rule. condition: 1) cyclic molecule  2) c...

Q: Methane and water react to form carbon monoxide and hydrogen, like this: CH,(2)+H,O(2) -→ CO(2)+3H,(...

A: The reaction shifts towards the side which has fewer moles or pressure.

Q: Calculate the pH of the following solutions in which the [H+] is a) 0.01, b) 1.0 x 10 –8 , and c) 4....

A: Given that -  Hydrogen ion concentration , [H+] are -  a) 0.01 b)1.0 x 10 –8  c) 4.67 x 10 –4  Then,...

Q: Consider the following data on some weak acids and weak bases: acid base K. name formula name formul...

A: The solutions given are, And the data given is,

Q: T0.03g 1. Mass of empty small evaporating dish (nonalpe noin2.24g 2. Mass of small evaporating dish ...

A: The mass of empty small evaporating dish is = 70.03 g The mass of small evaporating dish + mixture i...

Q: Rank the following alkenes in order of decreasing values of Amax- structure A structure B structure ...

A:

Q: Trizma base is a commonly used buffer in biochemistry labs with a pKa of 8. How much 1 M HCl must yo...

A: Buffers are the solutions that have two major components i.e. a weak acid and its conjugate base. pH...

Q: letter = e value = OMIT )nodal planes = ) (f) An atomic orbital that has three nodal planes is (g) W...

A:

Q: Once the layers were created, it needed to be separated or else what could have occurred? t-pentyl ...

A: When t-pentyl alcohol reacts in HCl, it forms t-pentyl chloride. This reaction follows the SN1 mecha...

Q: Refer to the number ndnds (2 and Use the drop-down features to describe the two curved arrows that s...

A:

Q: describes them. Color Density in g/cm Melting Point in Substance Kelvin Aluminum Oxidane Xenon Сoppe...

A: Fill in the table

Q: NH2 HO. HO HO

A: The solution is as follows:

Q: 4. The Haber process for the synthesis of ammonia from nitrogen and hydrogen gases in an exothermic ...

A: When equilibrium is disturbed by changing condition, then system shifts towards the direction where ...

Q: Determine the molecular equation for the reaction of zinc carbonate with hydrochloric acid. + Determ...

A: The molecular equation and net ionic equation for the reaction of zinc carbonate with hydrochloric a...

Q: What is the difference between a chemical process and a physical process in chemistry

A:

Q: A nitrogen sample occupies 246 mL at STP. If the same sample were collected over water at 25°C and 6...

A: For the phase change of the ideal gas the temperature, pressure, and volume of the initial state and...

Q: CH3 CH2 CH3 (с) (а) (b) PPH

A: Concept IUPAC nomenclature; 1) According to IUPAC nomenclature system longest chain is selected whic...

Q: 3-Explain why the radionuclides of the neptunium decay series are not found in nature

A: Neptunium is a  radioactive natural elements which is often produced artificially.  So the radionucl...

Q: The reaction A → B + C is second order in A. When the initial [A] = 0.100 M, the reaction is 20.0% c...

A: Given : We have to calculate the rate constant of the reaction.

Q: Explain briefly in 2 sentences andin your OWN words. 1. NH4CNS used in the test for cobalt must be a...

A: Gravimetric analysis is one of the most accurate analytical methods available. It is concerned with ...

Q: 1.0 mole of an ideal gas is initially at T1=298 and has volume of v1=2.0L. it is then reversibly exp...

A:

Q: Prevacid is used to treat gastroesophageal reflux disease (GERD). The chemical formula of Prevacid i...

A:

Q: Write the letter of the pair of compounds that illustrates the given isomerism. CH, CH3 CH CH, он D ...

A: Here we have to find the pair compounds from the given compounds which are cis-trans geometrical iso...

Q: Prepare 1 liter of 0.5M sulfuric acid from a concentrated aqueous solution. Sulfuric acid density is...

A: H2SO4 We have to determine the concentration of H2SO4 first and then dilute to prepare 1 L of 0.5 M ...

Q: The “normal” lead content in human blood is about 0.40 part per million (that is, 0.40 g of lead per...

A:

Q: In an experiment to study the formation of HI(g), H2(g) + I2(g) ⇌ 2 HI(g) At equilibrium, [H2]...

A: