Directions: From the illustration, identify the branch current for each resistor. Consider: RI = 100 ohms Note: Follow the polarity and direction of the loop. R2 = 5000 ohms R = 1000 ohms 1000 1KO 10v+ 5V SKO Figure 25. KCL and KVL circuit diagram

Q: H. W: - LTI System, compute zero state response analytically x(n) = a"u(n) h(n) = u(n) Find y(n) =…

A: In this question,  We need to calculate the output signal if input and impulse response are given.…

Q: QUESTION 2 A balanced Delta-connected system consists of a phase voltage of 350V RMS and a load of…

A:

Q: Solve for i(t) for t > 0. The initial conditions are i (0) = 0 and V. (0) = 0.1V. t=0 1000 mH i(t)…

A:

Q: Find the total real power dissipation in a balanced delta-connected system. Phase voltage is 100V…

A: Given: A balanced delta connected system Phase voltage, Vph=100 V Load impedance, Zph=175 Ω Power…

Q: R1 R2 20 I = 2AZ30

A:

Q: A B Y 1. D ABCD 00|0 X YZ 1 1 1 1 1 1 1 1 1 1 1 Write the expressions for the outputvariables 1 1 X…

A: A logic gate circuit along with its truth table is given in the question. We need to give the…

Q: the fundamental period of x[n]=4. sin (6.pi.n) is pi=3.14159265359 1 4 2

A:

Q: For the circuit below, what is the initial voltage across the capacitor? R =2 Q L= 2 H ll + R2=5 N…

A:

Q: Determine the flux per pole for 6 pole dc machine having 240 wave connected conductors, which…

A: Given, Number of poles, P = 6 Number of conductors, Z = 240 Wave connection so number of parallel…

Q: 4. What is the relationship between gain, feedback and Deviation?

A:

Q: B Y 2. D E F

A:

Q: as i (t ) = 125cos (5000π t −135) mA Determine the period, T, and the time, t1, at which the first

A:

Q: FE = k (q1q2/r2) Where r is the separation distance between the charged objects and k is a constant…

A:

Q: Find the acceleration (m/s?) of the mass M for the system shown. M-1 kg, F-96 N (Assume g= 10 m/s)…

A: We need to find select correct option for acceleration

Q: A parallel plate, capacitor with area of 15 m² , plates is 1mmFilled by two dielectri materiàl iwih…

A: This question is based on configuration of capacitors

Q: Which of the following equipment should be installed by the consumers having low power factor…

A:

Q: A Wheatstone Bridge is shown in Figure Q5. Determine R3 so that the Bridge circuit is in balanced…

A: aIn Wheatstone Bridge at the point of balance i.e. VAB=Vo=0 V.Both legs have equal voltage…

Q: For the circuit below, what is the initial condition across the inductor? L =? H

A:

Q: Consider the following signal: x(t) = 3 sin(300 nt) +2 sin(150 nt) + 6 sin(75 nt). %3D The amplitude…

A: Given data, Signal, xt=3sin300πt+2sin150πt+6sin75πt

Q: A 2000 µF capacitor is charged by a constant current dc source. After 100 seconds, the voltage…

A: Given, Capacitance, C=2000 μF Time interval, ∆t=100 s Voltage across capacitor raises from 100 V dc…

Q: What is the potential energy of a 2.90-kg object at the bottom of a well 11.8 m deep as measured…

A: Given : Mass of the object, m = 2.90 kg Height from ground level, h = 11.8 m

Q: Suppose R2 is a sensor whose resistance varies from SkQ to 10k0. Ve SV and R1 10KO. The maximum…

A: Given data, R1=10 kΩR2=5 kΩ to 10 kΩVs=5 V

Q: 5) Write the mesh current equations for the circuit shown below. 10 2 ww- 22 6 V ww 12 8V ww

A: Given circuit,

Q: Q3: The output for the following clipping circuit is shown below. Assuming ideal diode, calculate…

A:

Q: Quusing thevenin's thearemm, Z7.inthe Cir Cuit show.nin fig determinetha (I).thr loo 25r 180160 6lov…

A: Using thevenin's theorem in the given circuit, calculation of current 'I' through impedance Z3.…

Q: For the circuit shown, find the current in the 32 resistor. Using: A) Loop current method. 444 * 4V

A: The solution is given below

Q: A.Get the Boolean expreession of each output variable B. Simplify the three output boolean…

A: The given diagram is shown below:

Q: Define the different types of AC Generator. -  Define Three- Phase AC Generator. -  Why does DC…

A: As per bartleby guideline for more than three sub-parts only first three are to be answered please…

Q: Volume charge density is located in free space as ρν = 2e−100r nC/m3 for 0 < r < 3 mm, and ρν = 0…

A: The solution is given below

Q: If Req =85 2 in the circuit of Fig. 2.105, find R. R 10 30 Ω ww Reg 12 Ω 12 2 60 2 ww

A:

Q: 6- Draw the vector of a single phase transformer for full load lagging power factor condition of the…

A: 6- NOTE- We can only provide the solution for the first question. Post other questions separately.…

Q: why voltage decreases faster than the current increases in the Pv circuit when the Temperature is…

A: Solar Power- Power or energy which generate by the solar energy with the help of solar cell and…

Q: what can be observed in series wherein resistors with the same ohmic value

A:

Q: Controlling Light is defined as follows

A: Given We need to define the controlling light

Q: Digital signal is the signal that has continuous time & continuous amplitude continuous time &…

A: In this question we need to choose a correct option

Q: Determine the magnitude and angle of the voltages EAB , EBC, and ECA .

A: It is given that: Vab=16kV∠0°Vbc=16kV∠-120°Vca=16kV∠+120°

Q: Analyze the diagram and answer the following question and explain it. What part of the resistor…

A:

Q: Find the power dissipated by 1-ohm resistor. 10Ω ww 6 V 22 ww +-> 12 4Ω 50 8 V O 1.42 W O 1.06 W O…

A: Given:

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

A:

Q: If you have this relationship between the input and output voltage Vout=1.5 Vin+2 in which 2 is a…

A: If we have this relationship between the input and output voltage Vout=1.5Vin+2 in which 2 is a…

Q: Determine the transfer function between xX2(t) and F(t) for the followin, system (assume k=1): · x…

A: Given  Mechanical system shown  k=1

Q: Problem 3: AV= 98-V source is connected in series with an R = 1.4-kQ resistor and an L = 26-H…

A: The solution is given below

Q: Digital signal is the signal that has O continuous time & discrete amplitude discrete time signals &…

A: The answer is option B ( discrete time signal and discrete amplitude)

Q: The transfer function of a control system is: G(s) = 8/a)(a+a) G(s) = +1)(+16) %3D The value of a…

A: Given: The transfer function of control system is Gs=sas+as+1s+16 And Kp=100

Q: 3. Get the reciprocal of the Reg for each connection. Compare the value obtained with the sum of the…

A: In this problem we have to apply ohms law

Q: For the circuit in Fig. 2,determine: (a) the voltage across each capacitor, (b) the energv stored in…

A: Given, We have circuit, We have to find the voltages across each resistor. And energies. Please find…

Q: O a. Light-emitting diode • b. none of these c. Zener diode • d. Back diode

A: Given statement  A blown-fuse visual indicator uses

Q: +15 V 4.7 k2 4.7 ka Viz Vi1 Q1 B= 150 4.7 k2 -15 V

A:

Q: Given the sinusoids v1(t) = 8cos (250t +15°) V and v2(t) = 6cos (250t – 45°) V, determine the time…

A: In this question we will find the time by which v2(t) is advanced or delayed with respect to…

Q: P3/ A A sinusodail signal shown in figure (1) be low: PP =RV Time (t)

A: Solution- Given, T = 0.08 sec VPP = 12 V  f = 1/T  =  1/0.08 = 12.5 Hz  n = 4 bit Quantizer-…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.