ExampleA sinusoidal voltage wave having an amplitude of 10 V and1frequency 1MHZ is applied across two plane parallel plates kept2 cm apart in vacuum. An electron is released with an initialvelocity of 1.5×106 m/second along the lines of force at aninstant when the applied voltage is zero. Find an expression forthe speed and distance of the electron at any subsequent time t.Solution37

Example A sinusoidal voltage wave having an amplitude of 10 V and frequency 1MHZ is applied across two plane parallel plates kept 2 cm apart in vacuum. An electron is released with an initial velocity of 1.5x106 m/second along the lines of force at an instant when the applied voltage is zero. Find an expression for the speed and distance of the electron at any subsequent time t. Solution

Example A sinusoidal voltage wave having an amplitude of 10 V and frequency 1MHZ is applied across two plane parallel plates kept 2 cm apart in vacuum. An electron is released with an initial velocity of 1.5x106 m/second along the lines of force at an instant when the applied voltage is zero. Find an expression for the speed and distance of the electron at any subsequent time t. Solution

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Where is electrical energy stored in an inductor? O In the electric field surrounding its coils. O In the magnetic field surrounding its coils. O In both the electric and magnetic field surrounding its coils. O An inductor never stores electrical energy.
A particle is moving from higher electric potential to lower electric potential and its kinetic energy is decreasing. What kind of a particle is that? An electron A proton A proton None of the answers
Draw the inductance and resistance voltages on an oscilloscope screen in accordance with their polarity. In the drawing, it should start with voltage changes and values and should be stable. Write the Time/Div and Volt/Div steps made on the oscilloscope during the measurement on the oscilloscope screen drawing. Specify the voltage labels in the drawing. The current through the circuit has the same variation as the resistor voltage measured from the equation V=I/R, but is 1/47 times the value.
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
Write down the equations for the instantaneous charge and current for charging and process in a dc RC series circuit. At t = RC, find the percentage of charges and currents in both the processes? How to find the time constant from current vs. time and charge vs. time graphs.
Okay for Determine the mathematical expression for the voltage vC and the current iC for the discharge phase. I got Vc = 8e-t/0.2s V and iC = -4e-t/0.2mA But I need help with the last question Plot the waveforms of vC and iC for a period of time extending from 0to 2 s from when the switch was thrown into position 1.
Which of the following is not true for ferromagnetic materials? Please choose one: a. High?mthey have value. b.Above the Curie temperature, they lose their non-linear properties. C. a fixedµrthey have value. D.The energy loss is proportional to the area of the hysteresis loop.
What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?
QUESTION 5 A 20 ohms resistor is connected in series with a capacitor of 0.01 farad and an emf in volts given by 40e-3¹ +20e-6. Assuming that the charge and current on the capacitor are zero at t=0, determine the charge and current at any time.
A coil has a resistance of 18 when it mean temp is from 20o C to 50o C. Find its mean temp rise when its resistance is 21 and the surrounding temp is 15o C. A potential difference of 250 V is applied to a copper field coil at a temp of 15o C and the current is 5A. What will be the mean temp of the coil when the current has fallen to 3.91 A, the applied voltage being the same as before.
4. Find the net potential (voltage) at pt. p produced by the charges as shown in the figure. Q8= +1uC Q3=-6nC Q4=-3nC 1m pt.p Q2=+5nC Qs=-5nC 1m 2m 2m Qı=+3nC Q6=+6nC Q7=+1nC
What is the period in milliseconds for a given voltage having an equation of v(t) = 100sin377t?