Find the first ICMP Echo Request message that was sent by your computer after you changed the Packet Size in pingplotter to be 2000. Q6) Has that message been fragmented across more than one IP datagram? If so, how many? Q7) What information in the IP header indicates that the datagram been fragmented? What information in the IP header indicates whether this is the first fragment versus a last fragment?

Find the first ICMP Echo Request message that was sent by your computer after you changed the Packet Size in pingplotter to be 2000. Q6) Has that message been fragmented across more than one IP datagram? If so, how many? Q7) What information in the IP header indicates that the datagram been fragmented? What information in the IP header indicates whether this is the first fragment versus a last fragment?

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter8: Network Infrastructure And Troubleshooting

Section: Chapter Questions

Problem 8TC

See similar textbooks

Similar questions

OSPF messages and ICMP messages are directly encapsulated in an IP datagram. If we intercept an IP datagram, how can we tell whether the payload belongs to OSPF or ICMP?
The first of these packets is from your computer to the DHCP server telling it to release the lease on your IP address. The next 4 packets renew that lease. Note that the source address on the “DHCP Discover” and “DHCP Request” packets is 0.0.0.0. This indicates that your computer does not actually use its new IP address until the interchange has completed. Also note that the destination address in each of the 4 packets is a broadcast address[1]. It should be obvious to you why the first two packets are broadcasted, but what about the last two? Can you explain this? Answer the questions in your Word document right after you post a snapshot of the DHCP packet screen. (#4)
In protocol rdt3.0, the ACK packets flowing from the receiver to the sender do not have sequence numbers, although they do have an ACK field that contains the sequence number of the packet they are acknowledging. Why is it that ACK packets do not themselves require sequence numbers?
Use PingPlotter to ping ICMP packet of size 4000. Find the first ICMP Echo Request message that was sent by your computer after you changed the Packet Size in pingplotter to be 4000. Q8) Has that message been fragmented across more than one IP datagram? If so, how many? What information in the IP header indicates that the datagram been fragmented? What information in the IP header indicates whether this is the first fragment versus a last fragment?
In protocol rdt3.0, ACK packets that travel from the receiver to the sender do not contain sequence numbers, but they do have an ACK area that indicates the packet sequence number that they are recognizing. Why is it not required? What are the sequence numbers for our ACK packets?
What are the source and destination IP addresses of the frame's network-layer header? Is this an incoming or a departing frame? *Use the filter box to remove all frames except those with http as the source or sink protocol.
Draw a NAT Table Entry at the Router for the Computer (A) (shown with a smiley face J) trying to reach the Web Server (listening at Port 80) as shown. You may use dynamic port numbers.
An IP datagram of size 1000 byte arrives at a router. The router has to forward this packet to a network whose MTU is 100 bytes. Assume that the size of the IP header is 20 bytes. How many fragments will be created by the router and what is the size of the last fragment?
The binary value of the total length field in the IPv4 packet is 110010. The binary value of the HLEN of the IPv4 packet is 0111. What is the length of the data unit of an UDP packet encapsulated in this IPv4 packet?
Match the packets to the correct sequence of actions *PSH,ACK *SYN *RIN,RST *ACK,SYN *FIN *RST *ACK 1. server responds = 2. client requests connection to the server = 3. client responds =
For a given an IP v4 datagram, with header fields: HLEN - 5. Total length - 2220 and flag field (RDM) - 000. If this datagram is required to pass through a network of MTU - 1164 byte and need to be fragmented, choose the correct answer 1_For the given packet, the header size is 10 bytes 20 bytes 40 bytes 30bytes 2_The number of fragments to which the given packet is fragmented to pass through the network of MTU: 164: three Tour two Six Network Ineed answer after 30 min
4. Assuming that we have dumped the following Ip datagram. Identify all the fields of the IP header. 45 20 03 c5 78 06 00 00 34 06 ca 1f d1 55 ad 71 c0 a8 01 7e PAYLOAD