Answered: Find the latency of Token Ring (in…

Find the latency of Token Ring (in bits) where data rate of link is 20 Mbps and 40 stations separated by 100 meters and bit delay at each station is 1 bit. (Assume propagation speed as 2x105 m/sec)

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 27VE

See similar textbooks

Related questions

Q: 8- A binary source sending x1 and x2 over BSC, if the probability of x1 is 0.4 and probability of…

Q: A path in a digital circuit-switched network has a data rate of 1 Mbps. The exchange of 1000 bits is…

A: Here, we have to write solutions for the above questions.

Q: Find the latency of Token Ring (in bits) where data rate of link is 20 Mbps and 40 stations…

A: Data given- Propagation speed = 2 × 105 m/s Bit delay = 1 bit Data rate = 20 Mbps = 20 × 106…

Q: A 20 Kbps satellite link has a propagation delay of 400 ms. The transmitter employs the "go back n…

A: Introduction :Given , Implementation of "go back n "link bandwidth = 20 Kbps Tp = 400 ns n= 10 Frame…

Q: Ten signals, each requiring 3000 hz, are multiplexed onto a single channel using FDM. How much…

A: Here in this question question we have given Ten signals, each requiring 3000 hz.we are using FDM…

Q: Find the Normalized BW Delay Product Efficiency: 1-Two-Stations (show your work) (in terms of…

A: Answer:)

Q: A 20MHZ bandwidth is reserved for a particular communication system with maximum transmission rate…

A: I have answered the question in step 2.

Q: 1-If CS-24F6H and IP-634AH, determine: the physical address and the upper range of the code segment.

A: ans is given below

Q: Given the maximum lifetime of a segment is 30 sec and link capacity is 500Mbps, find the no. of bits…

A: Introduction :Given , A segment Maximum lifetime = 30 sec.Link Capacity = 500 Mbps We have to…

Q: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal for…

Q: A 3000km long trunk operates at 1.536 Mbps is used to transmit 64 byte frames. If the propagation…

A: The Answer is

Q: Consider an ethernet with length of the cable is 1800 meter and speed of the signal cable is 3 x…

A: The answer is...

Q: H.W: Thirty signals, twenty of them have 4kHz bandwidth, the other have bandwidth of 3 kHz are…

Q: On a given satellite link of a length 30 Kilometers, the bit rate is given to be 10 Mbps. Assuming…

A: Minimum frame size required = 2Tp*BW.

Q: Calculate the link budget ( only from Tx to Rx ) for the 12km transmitting distance of 10w power…

A: d. link margin = 11.69dB , link is poor

Q: Calculate the length of cable through which a signal can be sent before its power decreases to half…

A: Here we are given the attenuation values for three type of transmission cable and we need to find…

Q: 2. Sam wants to send 4000 8-bit characters of data. Find the total number of bits he will transmit…

A: Given: characters = 4000 1 character = 8 bits

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Given, TDM-based circuit switching with 8000 frames per second 32 time slots per frame During each…

Q: 1.11 A channel has a bit rate of 4 kbps and one-way propagation delay of 20 ms. The channel uses…

A: Introduction Given , Bit rate of channel = 4 kbps Prop.Delay = 20ms Stop and wait protocol is…

Q: A channel has a bit rate of 4 kbps and one-way propagation delay of 20 ms. The channel uses stop and…

A: Introduction:Channel bit rate = 4 kbps1-way propagation delay = 20 msProtocol used = Stop &…

Q: Q2. A signal travels from point A to point B through a link. It was found that at point B, the…

A: We are given the following data : Signal at point A : 98 W Signal at point B : 65 W We need to…

Q: a) A pure ALOHA channel is going to be shared among some number of stations. Each station is…

A: Actually, 1 byte =8 bits. given each station is transmitting a 1024 -byte frame average every 28…

Q: Data Communication & Computer Network Suppose that Jon's and Jenny's computers are connected by an…

A: Here I uploaded handwritten solution for u Hope it helps u

Q: Assume having a low-pass noiseless channel that spans from a Frequency of 0Hz to 130Hz, to send at a…

A: please upvote for my efforts thanks! answer: bit rate= 2* bandwidth * log2(number of levels)

Q: How many bytes can be stored by a 2Gbps (gigabits per second) link with a delay or latency of 3.2 ms…

A: - We need to calculate the data that can be stored in bytes with a 2Gbps link given a delay of 3.2…

Q: Q6: Suppose the carrier waveform illustrate below with assuming a group of 10 information signals xi…

A: ANSWER:-

Q: used: (a) Circuit switching; (b) Virtual circuit and datagram packet switching. The stations are…

A: The answer is

Q: Calculate the propagation delay in miliseconds (ms) for the link between Dijbouti and Israel under…

A: The answer is

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data…

A: The Answer is

Q: f) Assume that Station A is silent, Station B sends bit 0, Station C sends bit 1, and Station D…

Q: Consider an OFDM system in which 1000 subcarriers are each to be modulated at 1000 bits per second.…

A: OFDM system in which 1000 subcontractor modulations are per second at 1000 bits. (A) The…

Q: 1000 bit in a frame, D.R. = 1 kbps, find L.E. in: 1) Twisted pair of 1 km. 2) Satellite of 50000 km.…

A: The Answer is in Below steps

Q: If GSM uses a frame structure where each frame consists of eight time slots, and each time slot…

A: GSM (Global System for Mobile Communication) is a digital mobile network which is widely used for…

Q: Q1) Given an OFDM system with bandwidth 10 MHz and number of subcarriers N=1024. The cyclic prefix…

Q: H.W: Binary data are transmitted at rate of 10 bit/sec, over a microwave link having a BW of…

A: Introduction: In this question we have the transmitted binary data rate , Receiver i/p and BW. We…

Q: 05: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal…

Q: 10000 kbytes of message in a circuit switching over 4-hop path with 100 ms propagation delay per hop…

A: Introductions :Given,circuit switchingsize of message=10000KBno.of hops in path=4propagation…

Q: As a Network Engineer, assume that you are given 9 input-lines that carry digital inputs, and the…

A: Number of lines = 9Minimum data rate of lines = 100 Bps

Q: Consider that the link capacity of a channel is 512 Kbps and round – trip delay time is 1000ms find…

A: Given: channel is 512 Kbps delay time is 1000ms

Q: Consider a transmission medium that has a bandwidth of 2 MHz, an average signal power of 155 units,…

A: Given signal power S=155 units Noise Power B=5 units Band width B=2Mhz signal to Noise…

Q: j. If link transmits 4000 frames per second, and each slot has 8 bits. Then what is the transmission…

A: Question j. If link transmits 4000 frames per second, and each slot has 8 bits. Then what is the…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

Q: Assume having a low-pass noiseless channel that spans from a Frequency of OHz to 180HZ, to send at a…

A: please do upvote for my efforts ! answer: bit rate = 2* bandwidth * log2(number of levels)

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data…

A: Given: Consider a full-duplex 256 Kbps satellite link with a 240-millisecond end-to-end delay. The…

Q: What is the channel capacity for a communication channel with a bandwidth of 1 MHz, 1 W transmitted…

A: Find the required answer with calculation given as below :

Q: The figure below illustrates an asynchronous transmission in the form of short blocks. Each data bit…

A: Given, data: 01001010, start bit: 1, stop bit: 11. Formula for bit rate: bit_rate = 1 /…

Q: Suppose a 128-Kbps point-to-point link is set up between Earth and a rover on Mars. The distance…

A: Answer is in next step.

Q: Discuss the characteristics of the following modulation schemes, based on their Complexity Data…

A: Answer

Q: 06: Suppose the carrier waveform illustrate below with assuming a group of 10 information signals xi…

A: ANSWER:-

Q: Consider a channel with bandwidth B = 2Mhz and a signal to noise ratio of 40dB (expressed in log…

A: According to the Shannon theorem, the maximum data rate in a noisy channel is B*log2(1+S/N) where B…

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

Find the latency of Token Ring (in bits) where data rate of link is 20 Mbps and 40 stations separated by 100 meters and bit delay at each station is 1 bit. (Assume propagation speed as 2x10⁵ m/sec)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Find the latency of Token Ring (in bits) where data rate of link is 20 Mbps and 40 stations separated by 100 meters and bit delay at each station is 1 bit. (Assume propagation speed as 2x105 m/sec)
In ADSL, the OFDM symbol rate across all subcarriers is 4000 symbols per second. Assume that in the downstream direction, 25 subcarriers use 1024-QAM, 50 use 256-QAM, 100 use 64-QAM and 100 use 16-QAM. What is the overall bit rate
Given a transmission rate of 1 Gbps and a propagation speed of 200m / μ sec , how many meters of cable are needed for a full duplex transmission link to have a minimum capacity of 1500 bytes?
Example: 1000 bit in a frame, D.R. = 1 kbps, find L.E. in: 1) Twisted pair of 1 km. 2) Satellite of 50000 km. Repeat e for 1 Mbps.
A 6000Km long truck runs at 1Mbps is used to send 20 byte frames and uses SWP. If the propagation time is 5µs/Km, then, the number of bits in the sequence number field is
Assume that, in a Stop-and-Wait system, the length of the line is 10 Km, the volume of the pipe is 5Kbytes, and 1 bit takes 40 milliseconds to make a round trip. What is the bandwidth of the line?
Design a channel coding scheme to detect two or less errors for the message source (00, 10, 01, 11). Can you find one of the best schemes in terms of information transmission speed?
Imagine the length of a cable is 2500 metres. If the speed of propagation in a thick co-axial cable is 60% of the speed of light, how long does it take for a bit to travel from the beginning to the end of the cable? Ignore any propagation delay in the equipment. (Speed of light c = 3 x 108 metres / sec)
2. A path in a digital circuit-switched network has a data rate of 1 Mbps. The exchange of 1000 bits is required for the setup and teardown phases. The distance between two parties is 5000 km. Answer the following questions if the propagation speed is 2 X 10° m: a. What is the total delay if 1000 bits of data are exchanged during the data transfer phase? b. What is the total delay if 100,000 bits of data are exchanged during the data transfer phase? c. What is the total delay if 1,000,000 bits of data are exchanged during the data transfer phase? d. Find the delay per 1000 bits of data for each of the above cases and compare them. What can you infer?
1000 bit in a frame, D.R. = 1 kbps, find L.E. in: 1) Twisted pair of 1 km. 2) Satellite of 50000 km. Repeat e for 1 Mbps.
Unless specified otherwise, use the free space propagation speed of light 3x108 m/s to calculate the propagation delay. For numerical calculations, the results must show the appropriate unit. Show a complete solution for each problem3. Consider a digital multimedia transmission system. Separate audio and video coders are used to encode these signals. Audio and video bits are packed in packets together and transmitted over a transmission link. Each packet is 2,000 bytes long, which includes a 48-byte header. The system generates one packet every 40 ms. Calculate the following values:a. The minimum data transmission rate required to support the above system.b. The minimum signal-to-noise ratio (SNR) in dB required to transmit the above audio and video information. Assume a 400-kHz transmission channel bandwidth is used.c. The end-to-end packet delay over a 50-km link, using answer in Part a).
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the shortest time possible (in seconds) to transmit a 1 Mbyte file over the given link?