Find the Q-point values for the JFET network shown with voltage- divider bias. Assume IDSS=5mA and Vp=-4V. VDD +9 V www R₁ | 10 ΜΩ € R₂ • 2.2 ΜΩ RD 4.7 ΚΩ Rs • 3.3 ΚΩ

Q: Find the magnetic field intensity at the origin due to current of 10A in the conductor shown in…

A:

Q: A low-pass signal x(t) with bandwidth of 100 Hz is sampled at the Nyquist rate and the resulting…

A:

Q: 26) What is the type of electrical fault shown in the diagram : (A) Three Phase. (B) Phase to phase…

A:

Q: 3. A 4-kVA single-phase transformer with impedance of 5% and a power factor of a load is 80%. The…

A:

Q: Question 12 Draw an example of a parallel circuit with one 9 volt battery and two paths. On the…

A: Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If…

Q: 1. How many resistors and switches would be required to implement a 6-bit resistor-string DAC?

A: Number of resistors = 64 Number of switches = 63 Go through below for the explanation

Q: Calculate the total energy and average power for the Y(t) signal shown below. Y(t)= 9, -12<t<12 5-t,…

A:

Q: Magnetic Tape Recording Explain briefly the mechanism of Magnetic Tape Recording and how is…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 1- A 200-kVA transformer has an efficiency of 98 % at full-load. If the maximum efficiency occurs at…

A:

Q: 11.51 In a balanced three-phase system, the abc-phase- sequence source is wye connected and Van…

A:

Q: How Region I Mrs = 4 is the side of the plane y+z=1 containing the origin Region II 1 Mr₂ =6 for…

A:

Q: Consider a communications satellite that orbits the Earth at a height of about 40,000 km. At this…

A: Communication Satellite: A communications satellite is a man-made spacecraft that uses a transponder…

Q: 5. Four metal plates, each of surface area A on one side, are placed at a distance d from each other…

A: In this question we will find equivalent capacitance between point A and B.....

Q: calculate the speed

A:

Q: The double-pole main switch disconnects (at.4 :(the same time (answer can be found in the 5th…

A:

Q: A receiver has a noise power bandwidth of 10 kHz. A resistor that matches the receiver input…

A:

Q: 0 C4 2-to-1 MUX B 2-to-1 FO F1 0 2-to-1 MUX F

A: The basic 2:1 multiplexer is shown below. Where X1,X2 are inputs and Y is select line. F is the…

Q: Q3: For the feedback amplifier shown below determine the feedback topology and calculate A, B and…

A: Given: Consider the following circuit: To find: For the feedback amplifier, determine the feedback…

Q: a) State Kirchoff's first and second laws and name the fundamental physics principle that each law…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: For the circuit shown, calculate re, input impedance Z₁, output impedance Zo and voltage gain A,…

A:

Q: Copmpare between servo motor and 2phase Compare between drag-cup rotor and solid iron rotor 12:41 ✔

A: A Electrical motor is a a device which generates motion usually at a principal axis. Motor are of…

Q: 5- A single-phase transformer, working at unity power factor has an efficiency of 90 % at both…

A:

Q: Write a note on approx 500 words:   Explain how a fire alarm and detection system work. Which…

A: We need to explain how a fire alarm and detection system work. Which components and devices are…

Q: Evaluate the matrix operation

A: Given, The matrix is 164-389-27-1+-24-14-17-5618=

Q: Evaluate both sides of stokes theorem for The field H=6xyax-3y³ay Alm and the rectangular Path…

A: Solution

Q: A 4 pole , 3 phase sychronous motor runs at full speed of 1200rpm. If the load is reduced to…

A: Given: Synchronous speed motor

Q: Find the overall transfer function of: 5s + 3 44s² + 10 G1- G2 = > 12s3 +2s +5 354 + 5s² + 3 1) G1,…

A:

Q: For the fixed-bias configuration of Fig. 118, determine: a. I Bo 16 V b. Icg Ico C. VCEo d. Vc. e.…

A:

Q: Find the magnetic field intensity at the origin due to current of 10A in the conductor shown in…

A: Given: Current in the conductor, 10 A To find: Magnetic field intensity at origin   Diagram for this…

Q: Q1// Si transistor to be used in cct. Shown below has a current gain ß that varies from 50 to 200 if…

A:

Q: connected source supplies a balanced delta-connected load. The impedance per phase of the delta load…

A: Solve the problem

Q: kVA load for maximum efficiency (b) the efficiency at half full-load at 0.8 power factor lagging.

A:

Q: If V = OV, find Vo. Rb 2 Rc Rc +5V m Q1 Answer: If VOH = 3V, find VIL. (RC = 1k, Rb = 10k. Assume…

A: This question is belongs to transister switching circuits Assumption: Vbe=0.7v

Q: power transmission based on the given function.

A: Transformer- A device that transfers the electrical energy between two electrical circuits which are…

Q: QUESTION 2: A class-A emitter follower biased with a constant current source is shown below. Assume…

A: Given: A class A emitter follower biased with constant current source is shown below: The circuit…

Q: 9- An 11,000/230-V, 150-kVA, 50-Hz, 1-phase transformer has a core loss of 1.4 kW and full-load Cu…

A: Given, Full load KVA, Sfl=150 kVA Core loss, Pi=1.4 kW Full load Copper loss, Pcu=1.6 kW Power…

Q: 11.6 Find the equivalent Z of the network in Fig. P11.6. 192 -j10 20 j20 ww I se s 10 202 se es se S…

A:

Q: An 11,000/230-V, 150-kVA, 50-Hz, 1-phase transformer has a core loss of 1.4 kW and full-load Cu loss…

A:

Q: 11.52 In a balanced three-phase delta-delta system, the source has an abc-phase sequence. The phase…

A:

Q: FIND THE TOTAL FLUX DENSITY IN REGION: 1 <=Y <= 10 1 <= Z <= 2 X=0 If an infinite current sheet of…

A: It is given that: 1≤Y≤101≤Z≤2X=0k=3ay

Q: plot a graph of the tangents against the current [A]

A: A table is given in the question. We need to plot a graph of the tangents against the current.

Q: Three resistances of R Q each are conne form a triangle. The resistance between a terminals will be:…

A: In this question we will find equivalent resistance between two terminals in triangle...

Q: 84 일 Re - H2 Q4 G2 H3 G3 Loc K-

A:

Q: 2. A 10 KVA transformer has a maximum efficiency of 97.5% at 8% underload and a unity power factor.…

A:

Q: An amplifier tombstone or data block on an RF design map includes which of the following…

A: The data map on the RF design map includes the following information: Information on the individual…

Q: 15. A light bulb draws 300 mA when the voltage across it is 240 V. The resistance of the light bulb…

A: Given  I = 300mA , V. = 240V Find R

Q: 11.45 An abc-phase-sequence three-phase balanced wye- connected source supplies a balanced…

A:

Q: 7V Find ~ and i in the circuit in Figure 1 42 3v Ii W 22 362 Bar = 31 34 V Using Mesh and Nodal…

A:

Q: Use the convolution that sinc(t) * sinc(t) = sinc(t) theorem to show

A:

Q: Four metal plates, each of surface area A on one side, are placed at a distance d from each other as…

A: Given, Four metal plates are connected as shown, Surface area of each plate is A, distance between…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.