Answered: Find the self-inductance (in Henry) of…

Find the self-inductance (in Henry) of a 100-turns solenoid with cross-sectional area 10cm2 and length of 62.8 cm. Round your answer into five decimal places.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 45P: What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose...

See similar textbooks

Related questions

Q: (a) A 6.00-μF capacitor is connected to a 12.0-V battery. How much energy is stored in the…

A: a) 3×10-6 j b) 1.08 ×10-4 j

Q: If the polar coordinates of the point (x, y) are (r, 0), determine the polar coordinates for the…

Q: (b) What is the power?

A: (b) Given data: Resistance 1, R1=11 Ω Resistance 2, R2=28 Ω Resistance 3, R3=33 Ω Voltage, V=56 V…

Q: How does the normal force acting on an object affect the force of friction?

A: Normal force ∝ force of friction the stronger the normal force, stronger the friction of force

Q: A 0.60 kg block rests on a frictionless horizontal surface, where it is attached to a massless…

Q: The question is :show how you applied the equation for light diffraction by a grating. Thank you:)

Q: The wavelength of light impacts the efficiency of photosynthesis. Suppose that light with a mean…

A: The taylor expansion is given by Ex+∆x=Ex+∆xE'x+12!∆x2E''x+13!∆x3E'''x+⋯

Q: 11. Lauren's SUV was detected exceeding the posted speed limit of 60 kilometers per hour, how many…

A: Given Dataspeed limit u = 60 km/hDistance covered by the car d = 10 km time taken by the car to…

Q: You come across an open container that is filled with two liquids. Since the two liquids have…

Q: Three blocks each mass 9.0 kg are on a frictionless table. A hand pushes block A such that all three…

A: Given data: Three blocks on a frictionless table The mass of each blocks (m) = 9.0 kg Hand pushes…

Q: How close together can two parallel conducting plates, with a potential difference of 5.0x10³ V…

A: Given data: Potential difference (ΔV) = 5.0×103 V Electric field (E) = 3.0×106 V/m Required: The…

Q: An irresponsible adult hurls a boomerang into the air with a center of mass velocity of 32.0 m/s at…

A: Given: m=1.2 kg V=32 m/s I= 1/12 ML2 ω=10.0 rev/s

Q: Determine the x-coordinate of the centroid of the shaded region shown. 3 in. 6 in. 6 in. 6 in. 6 in.

Q: The arrangement of wires shown below, are parallel to each other and carry currents of 10 amp and…

A: Given:- Two wires are in parallel to each other and carry a current of I1 = 10 A and I2 = 5A The…

Q: A 120-V rms voltage is applied across a 6.0-µF capacitor and a series combination of a 100-…

A: Given: The RMS voltage is 120 V. The capacitance of the capacitor is 6 μF. The resistance of the…

Q: Vector A has x and y components of -8.80 cm and 13.0 cm, respectively; vector B has x and y…

A: Given data: The component of the vector A and vector B Ax = -8.80 cm, Ay = 13.0 cm Bx = 13.8 cm, By…

Q: Example Derek leaves his physics book on top of a drafting table that is inclined at a 35° angle.…

A: Determine the net force along the parallel direction of the plane. Fpar=(22 N)sin35°−11 NFpar=1.618…

Q: If 2 gallons of water comes out of a 3/4" diameter faucet every minute, what is the speed of the…

Q: as a volume of 60.00 cm³ at 12 °C. What is its volume at 76 °C? . A glass plug

A: Given data: Original volume (V0) = 60.00 cm3 Initial temperature (T0) = 12°C Final temperature (T)…

Q: Your plane was travelling at 180 kn for 12 mins, how many nmi did you travel in those 12 mins? 036…

A: Given, Distance = 180 kn Time travelled = 12 mins Conversion: 1 kn = 1 knot 1 kn = 1 nmi/hr 1 nmi…

Q: You have decided that you love physics and want to construct your own solenoid. You find a plastic…

Q: Four long wires are perpendicular to the x-y plane. Each wire carries the same magnitude current.…

Q: If the Earth’s orbital velocity around the Sun were twice as large, its centripetal acceleration…

A: Formula - centripetal acceleration a= v2/r Here:- v = velocity of earth r = radius Given -…

Q: Where did the 10 come from when you divided 1000 by 10

Q: What is the power of a 36.5cm focal-length lens? Express your answer using three significant…

Q: A 70 kg statue is being retrieved from the bottom of the ocean. If the volume is 3 x 10^4 cm^3 and…

Q: A 10kg monkey climbs a uniform ladder with weight 120N and length 3m as shown in the figure. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Consider the circuit shown in the figure below. Take E = 6.00 V, L = 8.48 mH, and R = 4.04 . R www…

A: Given Data, Voltage ε=6.00 V Inductance (L)=8.48 mH Resistance (R)=4.04 Ω

Q: A centrifugal governor consists of a central rotating shaft that has two thin, pin-connected rods…

Q: 5. Calculate the rate of heat conduction through house walls that are 13.0 cm thick and that have an…

Q: When an object is placed at the proper distance to the left of a converging lens, the image is…

A: we have to calculate the focal length of the diverging lens. u = 16 V= 16 +18.7 = 34.7 f = ?

Q: The 50 kg uniform crate initially rests on the inclined surface. If a force (F=40t +200 N) as shown…

Q: What rms current flows in a 60-mH inductor when 120-V rms ac at a frequency of 20 kHz is applied to…

A: Given data, Inductance L=60 mH RMS voltage VRMS=120 V Frequency f=20 kHz

Q: A lens of focal length 25 cm is placed 50 cm from an object. On the opposite side of the lens, at a…

Q: A horse and a squirrel participate in a race over a 1.90 km long course. The horse travels at a…

A: a) Let the squirrel be x meters from the finish line when horse again resumes the race. At this…

Q: A certain electric motor draws a current of 10 A when connected to 120 V. (b) How much energy does…

Q: The diameter of the Arecibo radio telescope is 307 m. It can image radio source that emit…

Q: A rod of mass 0.720 kg and radius 6.00 cm rests on two parallel rails (see figure below) that are d…

Q: Initially, block A has a speed of 3 m/s as shown in the figure below. Use the principle of linear…

Q: Two conducting wires are placed parallel to each other, 3.0 cm apart. A 2.6-A current flows through…

Q: Six, small, identical putty each weighing 2.25 [kg], are placed on the corners of a massless,…

Q: What is the kinetic energy of an electron that passes undeviated through perpendicular electric and…

Q: The Large Magellanic Cloud is a small satellite galaxy that orbits the Milky Way. It is currently…

Q: A projectile fired from the ground follows the trajectory given by the following equation, where v…

Q: Two people carry a heavy electric motor by placing it on a light board 2.10 mm long. One person…

Q: Consider the circuit shown in the figure below. Take mH, and R = 9 2. Shown in the figure below. S R…

Q: How strong of a magnetic field is required to levitate a 1.0-m long piece of wire that has a mass of…

Q: A 35 N forearm (we are ignoring the hand for this problem) are held at a 45 deg angle to the…

A: Given data- A 35 N forearm are held at a 45 deg angle to the vertically oriented humerus. The COM of…

Q: A 2000 kg car is traveling East at 45 m/s while a 1500 kg car travels North at 30 m/s. They collide…

Q: What is the total angular magnification of the microscope, assuming a near point of 25 cm?

A: For the calculation of angular magnification we have the formula M= -Lf01+DfeNow, put the values in…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

I need help answering this. Thank you!
Find the self-inductance (in Henry) of a 100-turns solenoid with cross-sectional area 10cm² and length of 62.8 cm. Round your answer into five decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

I need help answering this. Thank you!There is a solenoid with an inductance of 0.285 mH, a length of 36 cm, and a cross-sectional area of 6×10−4 m2. Find the number of turns of the solenoid—round your answer to a positive integer.
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
In the following transformer circuit VSource=12.0volts, RSource=4, the number of turn on the left-handside is 100 and on the right-handside is 800. RLis 700. a.Find the voltage across RL
NOTE: Solve this as soon as possible, I need this urgently. Describe the cutoff condition in a BJT circuit?
An RL circuit has an emf of 5 volts, a resistance of 50 ohms, an inductance of 1 henry, and no initial current. Find the current in the circuit at time t = 2 ms. Express your answer in mA and round-off to three (3) decimal places. O 5.916 mA O 5.619 mA O 9.516 mA O 6.915 mA
J: Refer to figure la 2.0m conductor is shown, that rotates at 1200 rev/min in the radial field B = 0.10 sinpa, T. Solve the current in the closed loop with a resistance 100 N. Discuss the polarity and current direction. r= 0,20 m 2.0 m 100 N
Consider two concentric solenoids of the same length. The inner solenoid has radius ? and number of turns ?1. The outer solenoid has radius ? , number of turns ?2, and current ? (see figure). The mutual inductance between the two solenoids is ? . Suppose we now double the radii ? and ? , double the number of turns ?1 and ?2, and double the current ? . What will be the new mutual inductance? Refer to the image for the question, and kindly provide complete solutions.
Tia needs to produce a solenoid that has an inductance of 3.33 ?H She constructs the solenoid by uniformly winding 1.19 m of thin wire around a tube. How long, in centimeters, should the tube be?
5000.0μο) is Consider a circuit with a power source that provides a sinusoidal (A/C) voltage. When the switch is closed the lightbulb glows steadily. If an iron rod (liron inserted into the interior of the solenoid, how would the lightbulb respond? Iron bar L It would get dimmer. It would get brighter. It would be unaffected. Need more information.
There is a solenoid with an inductance of 0.285 mH, a length of 36 cm, and a cross-sectional area of 6×10−4 m2. Suppose at a specific time the emf is 12.5 mV, find the rate of change (Ampere per second) of the current at that time. Find the number of turns of the solenoid. Round your answer in one decimal place.
I need help answering this. Thank you!When a current of 4A between two coils changes to 12A in 0.5s in primary and induces an emf of 50mV in the secondary. Calculate the mutual inductance (in henry) between the two coils. Round to nearest thousandths.
o7 irio)-Google Chrome mutah.edu.jo/mod/quiz/attempt.php?attempt3D101502&cmid=D9729&page%3D6 Consider a series RC circuit as in Figure below for which R =2.2 MO, C=8.7 µF, and ɛ=30.0 V. Find the current (in units of HA) at the moment the switch S is closed. S