For a hydroelectric plant, a hydraulic turbine-generator is installed at the site below the free surface. The turbine drives a generator for electricity. The elevation difference between the two free surfaces is . The power input from the fluid to the turbine is is . The shaft power output from the turbine is . (3) Calculate the the efficiency of the turbine, __________%

For a hydroelectric plant, a hydraulic turbine-generator is installed at the site below the free surface. The turbine drives a generator for electricity. The elevation difference between the two free surfaces is . The power input from the fluid to the turbine is is . The shaft power output from the turbine is . (3) Calculate the the efficiency of the turbine, __________%

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Similar questions

a hydraulic turbine receives water froma reservor at an elevation of 100 meter above it. what is the minimum water flow in (kg/sce) to produce a steady turbine output of 50 mw?
A pump discharges 50 tons of water per hour to a height of 8 m, overall efficiency of the pumping system being 69%, what is the input and output power?
What is the turbine output of 100m head and delivering 1 cu. m/ sec in a hydro electric power plant if turbine efficiency is 88%?
The pump shown in the figure iswhen pumping water from a lake to a lake aboveIt gives 7.5 kW of energy to the water. your lakesThe elevation difference between the surfaces of 9 m and the loadloss is 4.5 m. under given conditionsa.) The flow through the pipes,b.) The power loss that occurs under these flow conditionsfind it.
A 10-hectare rice land is to be irrigated at the peak water requirement of 10 mm/day. The source of water is pump from a river with outlet discharge directly to the irrigation canal. If the pump operates at 10 hours per day, what should be the capacity of the pump? What should be the size of engine if the total dynamic head is 10 meters. Assume pump efficiency to be 80 percent and engine to be 75 percent.
A proposed hydropower plant to be built using a reservoir with a typical head of 18m and estimated power of 15MW. You are given the task to select an appropriate type of turbine for this site if the generator requires the turbine to run at a fixed speed of 120rpm.
QI: If the overall efficiency of the system and turbine in the figure below is 80 percent. What power is produced for H=60m and Q= 30m'/s? H 3 m diam Water
A Pelton wheel develops 70 kW under a head of 60 m of water. It rotates 400 rpm. Overall efficiency is 80%. Find the discharge rate in m³/s. Use the equation below, where P is power of the turbine shaft and no is the overall efficiency, where specific weight of water is is 9.80 kN/m³ no P YQH A generator is driven by a small, single-jet Pelton turbine designed to have a power specific speed sp 0.20. The effective head at nozzle inlet is 200 m and the nozzle velocity coefficient is 0.985. The runner rotates at 880 rev/min, The turbine overall efficiency is 80%. Find (a) the power delivered by the shaft of the turbine and (b) find the power delivered by the water to the turbine. where density of water is 1000 kg/m³ and g is 9.80 m/s². Use Stup Ω P/p (gHE)* Overall efficiency ne and Power developed at turbine shaft hydraulic power P YQH
A pump draws water at a head of 11Om and a discharge rate of 550 Ips. Determine the water power output if the pump efficiency is 70%.
A hydro electric plant having 30 sq. km reservoir area and 100 m head is used to generate power. The energy utilized by theconsumers whose load is connected to the power plant during a five-hour period is 13.5 x 106kwh. The overall generation efficiency is75%. Find the fall in the height of water in the reservoir after the 5-hour period.a. 5.13 mb. 1.32 mc. 3.21md. 2.20 m*
115 m turbine 2 In the above example problem, a hydroelectric turbine at the base of a dam is shown schematically. The height of the water above the turbine station given as 115 m. This turbine produces 4.6 MW of electricity, and you may assume the losses in the system to be equivalent to 10 m of head of water. The diameter of the pipe at the turbine exit is 0.75 m, and the velocity of water exiting from the pipe is 12.5 m/s. Caleulate the efficiency of the turbine.
The hydraulic motor has a displacement volume. (Displacement Volume) is 130 x 10-6 m³/rey and the pressure in the system is 105 x 105 Pa and has a speed of 33.34 rey / S if the actual flow rate of the hydraulic motor is 0.005 m³ /s and the actual torque is 200. Nm Find 1. Volumetric efficiency of a hydraulic motor 2. Mechanical efficiency 3. Total efficiency of a hydraulic motor 4. Power of Hydraulic motor