2. For link to be maintained between a geosatellite and an earth station about 35,786 kmapart, calculate the carrier power (in dB) necessary giving the following antennacharacteristics:a. 60% efficiencyb. 2.5-cm wavelengthc. 1.3-m diameter transmitting dishd. 1.0-m diameter receiving dishe. To ensure high service quality, it is suggested that the carrier power at the receiverinput must be at least -116dBW.

Answered: Image /qna-images/answer/fb76bee7-3645-43d1-96af-df34afe058c0.jpg

Answered: For link to be maintained between a…

For link to be maintained between a geosatellite and an earth station about 35,786 km apart, calculate the carrier power (in dB) necessary giving the following antenna characteristics:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The direct broadcast system (DBS) in North America operates at 12.2–12.7 GHz, with a transmit carrier power of 120 W, a trànsmit antenna gain of 34'dB, and a worst-case slant angle (30°) distance from the geostationary satellite to Earth of 39,000 km. The 18-inch receiving dish antenna has a gain of 33.5°dB and followed by a low-noise block (LNB). The overall system iš shown below. Find the following The link budget for the received carrier power at the antenna; i. If an extra 20 dB loss due to weather condition e.g. heavy rain to be considered in the system design, calculate the new received power; ii. iii. Circular polarisation (CP) is sometimes used in DBS, explain the advantages of CP over linear polarisation from EMC pérspectives. iv. Take patch antenna as an example, give two methods of realising CP? v. Design a patch antenna operating at the centre frequency of the DBS using Rogers’ FR4 which has ăn dielectric constant of 3.38 and thickness of 1.5 mm. vi. Find the input…
please do it correctly.. A system starts with omnidirectional transmit antennas. This produces a coverage area with a radius of 1500 m when there is a pathloss exponent of 3.8. If directional antennas are implemented with a gain of 7.070 dB, what does the radius become (in meters)?
The height of base station is 200 meter and operated at 2600MHz. The gain of the base station antenna (transmitter) and the receiving antenna (mobile phone) are 20 dB and 6 dB, respectively. The distance between base station and mobile phone is 2 km. a) Find the free space transmission loss. b) Find the power received when the transmitted power is 60 W.
Q2. A circular copper waveguide has a radius of 0.6 cm and is filled with a Teflon having & 2.25 and tan 8-0.0002. Identify the first four propagating modes and their cutoff frequencies. For the dominant mode, calculate the total attenuation at 12 GHz.
A satellite at an altitude of 37654 km transmits a signal of 17 GHz to a ground station directly below it. The following data is given. • Total atmospheric losses = 40dB • Transmit antenna gain = 55dBi • Receiver antenna gain = 60dBi • Signal to noise ratio of received signal = 6dB • Receiver signal noise power = 25pW • Receiver sensitivity = -90dBW I. Calculate the power transmitted. II. Find the Fade Margin for the link and comment on your result.
Calculate the received signal strength ( C) in dBW where the transmitter output power is 750 mW, the transmission line losses at each end are 3.4 dB, the distance between the transmitter and receiver site is 17 statute miles, and the operating frequency is 7.1 GHz; the antenna gains are 30.5 dB at each end. Assume a gaseous absorption loss of 0.3 dB.
A 1 GHz transmitter sends a signal to a receiver 4 km away. There are three knife-edged absorbing screens intercepting the direct path. The first screen has an excess height of 5 m and is 1 km from the transmitter. The second screen has an excess height of 10 m and is 2 km from the transmitter. The third screen has an excess height of 5 m and is 3 km from the trans- mitter. Find the excess path loss using the Deygout method.
In microwave communications systems, for a carrier frequency of 6GHz and a distance of 40 km. determine the free space path loss in dB.
Consider a wireless communication system that operates in 900MHZ. Transmitter and receiver are with antenna gain of 1. The transmit power is 0.05W. Relative permittivity of the ground is 5.5. The height of the transmitter and the height of the receiver are set to 5m and 1m, respectively. Use the 2-ray ground reflection propagation model to answer the following questions. a. Specify the RSSI at 30m. b. Specify the RSSI at 35m. c. If the receiver sensitivity is -100dBm, determine the distance where the signal cannot be received. d. Change the transmit power to 1W. Specify the RSSI at 30m. e. Compare your aņswer for a and d. Which one provides higher RRSI? Explain your answer. f. Compare your answer for a and b. Which one provides higher RRSI? Explain your answer.
How large dish diameter is needed for 80 dB gain at 300 MHz?
Consider a downlink communication from base station to mobile user. The carrier frequency is 6 GHz and the channel bandwidth is 5 MHz. The transmit antenna gain is 8 dB and the receive antenna gain is -5 dB. The fading margin is 15 dB. The path loss follows the breakpoint model with break distance dbreak= 50 m and the power exponent n = 3. The transmit power of base station is 80 Watts. The minimum received SNR (Signal-to-Noise Ratio) is 12 dB. Assume that there are no other losses, use link budget to find out the distance the base station can cover.
Select the correct statement(s) regarding transmit beamwidth. a. The higher the frequency, the narrower the beamwidth b. The larger the antenna dimension (e.g., diameter for a parabolic antenna), the narrower the beamwidth c. The smaller the signal wavelength, the narrower the beamwidth d. All are correct Select the correct statement(s) regarding a satellite's TWTA (Traveling Wave Tube Amplifier). a. The TWTA amplifies the aggregated channels coming from the multiplexer, and sends this amplified broadband signal directly to the transmit antenna b. Each transponder has a TWTA which amplifies the transponder channel c. A TWTA amplifies the incoming signal directly from the receive antenna. The TWTA is also termed an LNA. d. All of the statement(s) are correct.