For the network shown in the figure below calculate the net input to the output neuron. 0.3 X, 0.2 1 0.5 0.1 X2 -0.3 0.6

Q: R1 R4 150 80 R2 100 R3 200 V2 V1 Ic 20Vpk }60HZ 30° 15Vpk 60HZ 15° C2 L3 20H =12µF

A:

Q: ŠOLVE THE FFG. PROBLEMS. I. USE ALL NET WORK ANALYSIS 0:52 TO SOLVE POR THE FFG. O1552 4. CURRENT IN...

A: This question belongs to electrical circuit theory . It is based on the concept of nodal analysis , ...

Q: A 100-MHz uniform plane wave propagates in a lossless medium for which eps_r = 5 and µ_r = 1. What i...

A:

Q: 3. In the circuit in Figure, find the value of RL that will absorb the maximum average power. Calcul...

A:

Q: What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10 cos2...

A: It is given that: C=20 μFE=10cos2377tt=1 sec

Q: Consider the circuit shown in (Figure 1). Suppose R = 3.5 N. Figure 62.5 mF HE 1 H Zab b.

A:

Q: a. Find I1, I2, and Vs b. Find Va, Vb and Vc a 11 b 2 A 20Ω 12 12v + 100 Vs 150

A:

Q: Q2 / Draw the root locus and find the value of K which is gain oscillatory K R(S) S(S + 1)(S + 2) C(...

A: Control systems are represented by transfer function. This  can be written in both time domain and s...

Q: What did you learn about the Republic Act No. 7920? "New Electrical Engineering Law." (150 words)

A: New electrical Engineering law:  In this law provision of composition, power, and function of the bo...

Q: Use voltage divider rule to determine V2 and V1. * 16 N 54 1 E 80 V V: 36 N 18 N

A:

Q: 5V a b 100 Ohm 3V 100 Ohm

A:

Q: A 3-phase, delta-connected alternator supplies a wye connected load, each phase of which has a resis...

A: I am attaching detailed solution image of this question.

Q: 12.0V R5 10000 C3 R1 1µF R6 1000000 10000 Q2 Č1 R3 1500000 5µF R2 100000 V1 5Vpk 1kHz 0° R4 C2 :4pF ...

A:

Q: Question 7 The amplifier configuration shown in figure below is a [ Select ] configuration, where th...

A:

Q: Opor 80V Osov

A:

Q: 1. A diode will pass only. alternation of a sine wave. 2. A half-wave rectifier can produce positive...

A:

Q: 30pF capacitor in parallel with a coil of 20Ω and 12mH is connected in series with a parallel connec...

A:

Q: 5. Consider the energy diagrams for Si, Ge, and GaAs shown below (also in Slide 14 in Lecture 2.3 Se...

A: Calculation of wavelengths for given energy diagrams of Si, Ge and GaAs : Enegy bandgap of Ge,  Eg(G...

Q: source generator supplies 100 uV signal to two identical amplifiers with a 20 dB total gain to boost...

A: We need to calculate output voltage and power 

Q: Design the circuit in the box to perform the function indicated in figure below Silicon diodes 10 V ...

A: Silicon diode- Silicon diode is a diode which have both charge polarity and allow current to pass th...

Q: washing machine is, in effect, an RL circuit. If the machine takes 311 W and 4.5A from 115-V source ...

A:

Q: what is the voltage provided by the building 2. What is the amount of current provided to the bulld...

A:

Q: An armature has a resistance of 0.2 N at 150°C and the armature Cu loss is to be limited to 600 watt...

A: It is given that: Ra=0.2 ΩT1=150°CPcu=60 WT2=150+55=205°Cα=0.0043/°C

Q: DEGREE: ELECTRICAL ENGINEERING  SUBJECT/COURSE: AC CIRCUITS   NOTE: Please solve in this way.   ...

A:

Q: What did you learn about the Republic Act No. 7832? "Anti-electricity and Electric Transmission Line...

A: It prevents the theft of electric transmission line. This act is prevent the following things-  1- T...

Q: R7= 5.76 m2 L7 = 30.6 µH + R = 52 v(t) = 120/2cos(377t-30°) V C = 921µF L = 5 mH

A:

Q: PROBLEM 2 Consider a series RLC circuit with R = 25 N, L = 6 mH, and C = 25 µF. The circuit is conne...

A:

Q: Find the numerical values of the zeros of the impedance. Express your answers in radians per second ...

A: Using the standard characteristics equation of the series RLC circuit We can find out the roots of t...

Q: cis)=. %3D S+リと ラ-

A: Given  C(s)=11+τs×1s2

Q: Solve for the total impedance of a three-branch parallel circuit with the following data: Branch 1:...

A: Given:3 branch parallel circuit.Branch 1: 50Ω resistor in series with a 20µF capacitor  Branch 2: 30...

Q: 1. Deter mine Vo and ID for the netwOrks Si エ( lomA : 2:2K 2:2KA Fig. I Vo +20V oM -20v 6.8k2 Si

A:

Q: Ex. 235. See Figure 235 Given V4=63 volts, and 3 capacitors in microfara C1=26, C2=55, C3=38, determ...

A: In this question we will find total voltages across each capacitor in given figure....

Q: Determine the size of PV modules, inverter, battery and solar charge controller of a PV systems give...

A: Here, we have given some information about devices present in a house.  We will first calculate the ...

Q: a 3.2 52 b 502 1002 Wr 3.23 20 d e W- 252 7503 - f

A:

Q: |39

A:         XOR gates in digital logic are used for producing outputs when two inputs are not the same t...

Q: Mention the metals used in an alloy of electric fuse

A: Electric Fuse: An electrical fuse is just a device that prevents current from flowing in an electric...

Q: Part II: Write Boolean expression for output Z (a) B Figure 1 Z =

A: Given logic circuit,

Q: xy +y' = -y³e* diferansiyel denklemi uygun bir dönüşüm ile lineer difer ansiyel denkleme dönüşüyor. ...

A: First we will transform the equation into Linear form by a suitable substitution. Then, we will find...

Q: Find the branch voltages V1 to V4. * + MESH 1 MESH 3 3 V V1 V2 2 V + + - V3 4 V V4 5 V MESH 2 MESH 4...

A:

Q: What was the first electrical digital computer comprised of?

A: All latest  computers today are digital computers. An electronic digital computer uses electricity t...

Q: A 300Ω transmission line 150m long, operates at 400kHz with attenuation coefficient of 2.4 x10^(-3) ...

A: A 300Ω transmission line 150m long, operates at 400kHz with an attenuation coefficient of 2.4 x10^(-...

Q: 134 Chapter 2 Resistive Circuits V1 5Ω V2 1 A 10 Ω 0.5i 20 Ω Figure P2.57

A:

Q: Find I (mA) unit if E1=11V, E2=-4.7V, R1=5.2kQ, and R2=2.8kN. (Answer should roundoff to 2 decimal p...

A:

Q: At which voltage value will the axis of the output voltage settle? a) Ov b) -8V c) +8V d) -3V What i...

A:

Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below. 2 IL R1 R2 R3 ...

A: Circuit is given as :

Q: 4 V +8 V 2.2 kn+ Si -8 V

A:

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A: Brief description : In the above given question they have mentioned an electrical circuit which cons...

Q: c) In a N-type semiconductor bar the fermi level is 0.4 eV below the conduction band at the temperat...

A: Given, The Fermi level of an n-type semiconductor at temperature 298K is below the conduction band, ...

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output vo...

A: It is given that: RL=10 ΩVo=400 V

Q: Inverse Laplace

A: This question belongs to signal and system . It is based on the concept of inverse Laplace transform...

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.