gh-voltage direct-current generating station delivers 5 MW of power at 178 kV to a city, as depicted in Figure below. The city is represented by resistance R₁ and each of the two wires of the transmission line between the generating station and the city resented by resistance RTL. The distance between the two locations is 1752 km and the transmission lines are made of 7 cm diameter copper wire. Determine how much power is consumed by the transmission line. Please enter your answer 2 decim ces and in terms of Watt. (for copper-1.72 x 10-8) 0 + Station RTL RTL ww RL (city)

gh-voltage direct-current generating station delivers 5 MW of power at 178 kV to a city, as depicted in Figure below. The city is represented by resistance R₁ and each of the two wires of the transmission line between the generating station and the city resented by resistance RTL. The distance between the two locations is 1752 km and the transmission lines are made of 7 cm diameter copper wire. Determine how much power is consumed by the transmission line. Please enter your answer 2 decim ces and in terms of Watt. (for copper-1.72 x 10-8) 0 + Station RTL RTL ww RL (city)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
The reactive power output of an alternator is limited by load angle True False
A curve is drawm in descending order of load with time. Al1
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
A sinusoidal current has a rms value of 3 amperes, its maximum value will be ______. 2.1213 amp 4.2426 amp 3.46 amp 0.866 amp
Objective 3 ) -Be able to calculate all forms of ac power in ac circuits with linear transformers and ideal transformers
The answer fir this question is 2.817% for the ripple factor how i can get it ?
A generating station has a maximum capacity of 100 kW and costs $300,000. The annual fixed charges are 12% of the cost of the generating station consisting of 5% interest, 5% depreciation and 2% taxes. Find the fixed charges per kWh generated if load factor is (a) 100% and (b) 25%.
QUESTION 11 An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.
A 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
Transformers.